The DOI matches its Crossref record; 26 of the 26 references it cites were found in a registry or an index.
Ultraselective and sensitive detection of xylene and toluene for monitoring indoor air pollution using Cr-doped NiO hierarchical nanostructures
Abstract
Ultraselective and sensitive detection of xylene and toluene with minimum interferences of other indoor air pollutants such as benzene, ethanol, and formaldehyde is achieved using NiO hierarchical nanostructures doped with Cr. Pure and 1.15-2.56 at% Cr-doped NiO flower-like hierarchical nanostructures assembled from nanosheets are prepared by a simple solvothermal reaction and their gas sensing characteristics toward o-xylene and toluene gases are investigated. The 1.15 at% Cr-doped NiO hierarchical nanostructures show high responses to 5 ppm of o-xylene and toluene (ratio of resistance to gas and air = 11.61 and 7.81, respectively) and negligible cross-responses to 5 ppm of benzene, formaldehyde, ethanol, hydrogen, and carbon monoxide. However, pure NiO nanostructures show low responses to 5 ppm of o-xylene and toluene (ratio of resistance to gas and air = 2.01 and 1.14, respectively) and no selectivity toward any specific gas is observed. Significant enhancement of the response and selectivity to o-xylene and toluene is attributed to the decrease in the hole concentration in NiO and the catalytic oxidation of methyl groups by Cr doping.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Shannon, R. D. (1976) · Acta Crystallographica Section A · doi:10.1107/s0567739476001551 · Cited by 66,145
Gas sensors using hierarchical and hollow oxide nanostructures: Overview
Lee, J.-H. (2009) · Sensors and Actuators B: Chemical · doi:10.1016/j.snb.2009.04.026 · Cited by 1,493
Self-citationCo3O4 Nanomaterials in Lithium‐Ion Batteries and Gas Sensors
Li, W. Y., Xu, L. N., & Chen, J. (2005) · Advanced Functional Materials · doi:10.1002/adfm.200400429 · Cited by 1,201
Toward innovations of gas sensor technology
Yamazoe, N. (2005) · Sensors and Actuators B Chemical · doi:10.1016/j.snb.2004.12.075 · Cited by 1,166
Detection of CO and O2 Using Tin Oxide Nanowire Sensors
Kolmakov, A., Zhang, Y., Cheng, G., & Moskovits, M. (2003) · Advanced Materials · doi:10.1002/adma.200304889 · Cited by 1,049
Fabrication and Gas‐Sensing Properties of Porous ZnO Nanoplates
Jing, Z., & Zhan, J. (2008) · Advanced Materials · doi:10.1002/adma.200800243 · Cited by 737
Function and applications of gas sensors
Kohl, D. (2001) · Journal of Physics D: Applied Physics · doi:10.1088/0022-3727/34/19/201 · Cited by 483
Modeling of sensing and transduction for p-type semiconducting metal oxide based gas sensors
Bârsan, N., Simion, C. E., Heine, T., Pokhrel, S., & Weimar, U. (2009) · Journal of Electroceramics · doi:10.1007/s10832-009-9583-x · Cited by 422
Kim, H.-R., Haensch, A., Kim, I., Bârsan, N., Weimar, U., & Lee, J. (2011) · Advanced Functional Materials · doi:10.1002/adfm.201101154 · Cited by 419
Self-citationChemical synthesis, characterisation and gas sensing performance of copper oxide nanoribbons
Gou, X., Wang, G., Yang, J., Park, J., & Wexler, D. (2008) · Journal of Materials Chemistry · doi:10.1039/b716745h · Cited by 261
Porous SnO2 nanospheres as sensitive gas sensors for volatile organic compounds detection
Li, Z., Zhao, Q., Fan, W., & Zhan, J. (2011) · Nanoscale · doi:10.1039/c0nr00728e · Cited by 241
Langenfeld, J. J., Hawthorne, S. B., & Miller, D. J. (1996) · Analytical Chemistry · doi:10.1021/ac950862w · Cited by 212
Highly sensitive C2H5OH sensors using Fe-doped NiO hollow spheres
Kim, H.-J., Choi, K.-I., Kim, K.-M., Na, C. W., & Lee, J. (2012) · Sensors and Actuators B Chemical · doi:10.1016/j.snb.2012.06.029 · Cited by 163
Self-citationHigh toluene sensing properties of NiO–SnO2 composite nanofiber sensors operating at 330 °C
Liu, L., Zhang, Y., Wang, G., Li, S., Wang, L., Han, Y., Jiang, X., & Wei, A. (2011) · Sensors and Actuators B Chemical · doi:10.1016/j.snb.2011.08.007 · Cited by 157
Sun, F., Cai, W., Li, Y., Jia, L., & Lu, F. (2005) · Advanced Materials · doi:10.1002/adma.200500936 · Cited by 140
Synthesis and toluene sensing properties of SnO2 nanofibers
Qi, Q., Zhang, T., Liu, L., & Zheng, X. (2008) · Sensors and Actuators B Chemical · doi:10.1016/j.snb.2008.11.042 · Cited by 132
Self-activated ultrahigh chemosensitivity of oxide thin film nanostructures for transparent sensors
Moon, H. G., Shim, Y.-S., Kim, D. H., Jeong, H. Y., Jeong, M., Jung, J. Y., Han, S. M., Kim, J. K., Kim, J.-S., Park, H., et al. (2012) · Scientific Reports · doi:10.1038/srep00588 · Cited by 124
Self-citationWang, L., Lou, Z., Fei, T., & Zhang, T. (2011) · Journal of Materials Chemistry · doi:10.1039/c1jm13354c · Cited by 112
Ultrasensitive and selective C2H5OH sensors using Rh-loaded In2O3 hollow spheres
Kim, S. J., Hwang, I.-S., Na, C. W., Kim, I., Kang, Y. C., & Lee, J. (2011) · Journal of Materials Chemistry · doi:10.1039/c1jm14252f · Cited by 109
Self-citationDetermining indoor air quality and identifying the origin of odour episodes in indoor environments
Gallego, E., Roca, X., Lorente, J. F. P., & Guardino, X. (2009) · Journal of Environmental Sciences · doi:10.1016/s1001-0742(08)62273-1 · Cited by 106
Microstructure control of TiO2 nanotubular films for improved VOC sensing
Seo, M.-H., Yuasa, M., Kida, T., et al. (2010) · Sensors and Actuators B Chemical · doi:10.1016/j.snb.2010.01.069 · Cited by 101
Na, C. W., Woo, H.-S., & Lee, J. (2011) · RSC Advances · doi:10.1039/c1ra01001h · Cited by 96
Self-citationHighly sensitive and selective sensors to volatile organic compounds using MWCNTs/SnO2
Ahmadnia-Feyzabad, S., Khodadadi, A. A., Vesali‐Naseh, M., & Mortazavi, Y. (2012) · Sensors and Actuators B Chemical · doi:10.1016/j.snb.2012.02.024 · Cited by 78
Effective VOCs gas sensor based on porous SnO2 microcubes prepared via spontaneous phase segregation
Huang, J., Xu, X., Gu, C., et al. (2012) · Sensors and Actuators B Chemical · doi:10.1016/j.snb.2012.07.068 · Cited by 67
Selective gas sensing response from different loading of Ag in sol–gel mesoporous titania powders
Bahadur, N., Jain, K., Pasricha, R., Govind, G., & Chand, S. (2011) · Sensors and Actuators B Chemical · doi:10.1016/j.snb.2011.06.058 · Cited by 41
Elumalai, P., Zösel, J., Guth, U., & Miura, N. (2009) · Ionics · doi:10.1007/s11581-009-0354-0 · Cited by 29
Cited by
Highly sensitive and selective gas sensors using p-type oxide semiconductors: Overview
Kim, H.-J., & Lee, J.-H. (2014) · Sensors and Actuators B: Chemical · doi:10.1016/j.snb.2013.11.005 · Cited by 2,258
Self-citationRecent Progress on the Development of Chemosensors for Gases
Zhou, X., Lee, S., Xu, Z., & Yoon, J. (2015) · Chemical Reviews · doi:10.1021/cr500567r · Cited by 777
Self-citationDesign of Superior Ethanol Gas Sensor Based on Al-Doped NiO Nanorod-Flowers
Wang, C., Cui, X., Liu, J., Zhou, X., Cheng, X., Sun, P., Hu, X., Li, X., Zheng, J., & Lu, G. (2016) · ACS Sensors · doi:10.1021/acssensors.5b00123 · Cited by 441
Jeong, S., Kim, J., & Lee, J. (2020) · Advanced Materials · doi:10.1002/adma.202002075 · Cited by 415
Self-citationSynergy between nanomaterials and volatile organic compounds for non-invasive medical evaluation
Broza, Y. Y., Vishinkin, R., Barash, O., Nakhleh, M. K., & Haick, H. (2018) · Chemical Society Reviews · doi:10.1039/c8cs00317c · Cited by 276
Metadata
- Authors
- Kim, H.-J., Yoon, J.-W., Choi, K.-I., Jang, H. W., Umar, A., & Lee, J.-H.
- Venue
- Nanoscale
- Publisher
- Royal Society of Chemistry (RSC)
- Published
- 2013
- Volume
- 5
- Issue
- 15
- Pages
- 7066
- ISSN
- 2040-3364 (ISSN-L)
- 2040-3372
- OpenAlex
- W2018594685
- Cited by
- 256
- References
- 26
- FWCI
- 11.18
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.