Student or educator? Sign up with your school email and get 6 months of Pro free.

The DOI matches its Crossref record; 43 of the 43 references it cites were found in a registry or an index; 2 of the 3 sources its claims cite were checked for support.

Development of a liquid-phase microextraction based on the freezing of a deep eutectic solvent followed by HPLC-UV for sensitive determination of common pesticides in environmental water samples

Open access
Pirsaheb, Meghdad, Fattahi, Nazir·2018·RSC Advances

Abstract

In this research, a new extraction method based on liquid-phase microextraction and the freezing of deep eutectic solvent has been developed for the determination of pesticides in water prior to their analysis by HPLC-UV.

Overview

CoChat Summary

TL;DR

The authors developed a liquid-phase microextraction method based on freezing of a hydrophobic deep eutectic solvent (LPME-FDES), coupled to HPLC-UV, for six pesticides in water. Under optimized conditions the method gave enrichment factors of 150–180, LODs of 0.05–0.50 μg L⁻¹, and relative recoveries of 90–108% in spiked well, tap and river water.

Key findings

  • Enrichment factors of 150–180 and extraction recoveries of 75–90% were obtained under optimum conditions; calibration was linear from 0.2 to 500 μg L⁻¹ with correlation coefficients better than 0.9982, and LODs (S/N = 3) ranged from 0.05 to 0.50 μg L⁻¹, below the EU MRLs of 3–5 μg L⁻¹ cited for drinking water.
  • Precision based on seven replicate measurements (200 μg L⁻¹ diazinon and endosulfan, 100 μg L⁻¹ phosalone, 50.0 μg L⁻¹ atrazine, desethylatrazine and deisopropylatrazine) was 1.3–2.5% intra-day RSD and 2.2–3.6% inter-day RSD.
  • Relative recoveries in spiked real waters were 97–106% (well), 90–108% (tap) and 95–107% (river); the unspiked samples were free of pesticide contamination.
  • The optimal extractant was [DMIM]Cl (1-decyl-3-methylimidazolium chloride) as hydrogen bond acceptor with 1-undecanol as hydrogen bond donor at a 1 : 2 molar ratio (DES12), selected over four other imidazolium chloride DESs; no disperser solvent was required.

Methods

  • LPME-FDES procedure: 50 μL of DES12 injected into 10.0 mL aqueous sample, heated to 45 °C, 500 mg NaCl added to break the emulsion, vortexed 3 min, centrifuged 4 min at 5000 rpm, then the floating DES was solidified in an ice bath for 5 min, evaporated under nitrogen at 50 °C, reconstituted in 30 μL mobile phase, and 25.0 μL injected.
  • Analysis by HPLC-UV on an H5-ODS C18 column (15 cm × 4.6 mm, 5 μm) with a methanol : water gradient (40 : 60 to 100% methanol over 20 min, 1 mL min⁻¹) and detection at 210, 220 and 254 nm.
  • Optimization experiments varied the HBA (five imidazolium chlorides), HBA : HBD molar ratio (1 : 1 to 3 : 7), DES volume (30–80 μL), sample pH (1–8), NaCl amount (100–700 mg), vortex time (0–5 min) and temperature (25–55 °C); real-water validation used well, tap and Gharasoo River samples from Kermanshah, Iran, analyzed within 48 h of collection.

Limitations

  • Not stated in the paper: the article reports no explicit limitations section; it states only that SPE-GC-MS achieved lower LODs than this method and that extraction time was longer than conventional DLLME.
  • Evident from the text: the abstract describes the extraction solvent as consisting of 1-octyl-3-methylimidazolium chloride and 1-undecanol, whereas the experimental and results sections state that [DMIM]Cl (1-decyl-3-methylimidazolium chloride) was selected as the HBA — an internal inconsistency in the reported solvent identity.
  • Evident from the text: the method requires a multi-step procedure (heating, salting out, vortexing, centrifugation, ice-bath freezing, nitrogen evaporation, reconstitution), and the authors note that volumes below 30 μL of DES12 gave a final volume under 25 μL, insufficient for HPLC determination.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.1039/c8ra00912k

Cites

43 of 43 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Fig. 1 Effect of the different types of hydrogen bond acceptors on the enrichment factor of the analytes. Extraction conditions: volume of the sample solution, 10 mL; volume of the extraction solvent, 50 μL; extraction temperature, 45 °C; amount of sodium chloride, 500 mg; vortex time, 3 min; centrifugation time, 4 min; centrifuge speed, 5000 rpm.
Fig. 1 Effect of the different types of hydrogen bond acceptors on the enrichment factor of the analytes. Extraction conditions: volume of the sample solution, 10 mL; volume of the extraction solvent, 50 μL; extraction temperature, 45 °C; amount of sodium chloride, 500 mg; vortex time, 3 min; centrifugation time, 4 min; centrifuge speed, 5000 rpm.CC BY · PubMed Central
Fig. 2 Effect of the molar ratio of hydrogen bond acceptors to hydrogen bond donor on the enrichment factor of the analytes. Extraction conditions: as in Fig. 1; type of HBA, [DMIM]Cl.
Fig. 2 Effect of the molar ratio of hydrogen bond acceptors to hydrogen bond donor on the enrichment factor of the analytes. Extraction conditions: as in Fig. 1; type of HBA, [DMIM]Cl.CC BY · PubMed Central
Fig. 3 Effect of the volume of DES12 on the enrichment factor of the analytes. Extraction conditions: as in Fig. 1; type of HBA, [DMIM]Cl.
Fig. 3 Effect of the volume of DES12 on the enrichment factor of the analytes. Extraction conditions: as in Fig. 1; type of HBA, [DMIM]Cl.CC BY · PubMed Central
Fig. 4 Effect of the pH on the enrichment factor of the analytes. Extraction conditions: as in Fig. 1; type of HBA, [DMIM]Cl.
Fig. 4 Effect of the pH on the enrichment factor of the analytes. Extraction conditions: as in Fig. 1; type of HBA, [DMIM]Cl.CC BY · PubMed Central
Fig. 5 Chromatograms of direct injection of standards at concentration level of 200 μg L−1 of diazinon and endosulfan, 100 μg L−1 of phosalone, 50.0 μg L−1 of atrazine, desethylatrazine and deisopropylatrazine (A) and spiked river water at concentration level of 50 μg L−1 of diazinon and endosulfan, 25 μg L−1 of phosalone, 12.5 μg L−1 of atrazine, desethylatrazine and deisopropylatrazine (B) obtained by using LPME-FDES combined HPLC-UV. Extraction conditions: as in Fig. 1; type of HBA, [DMIM]Cl; peak identification: (1) diazinon, (2) phosalone, (3) endosulfan, (4) desethylatrazine, (5) deisopropylatrazine, (6) atrazine.
Fig. 5 Chromatograms of direct injection of standards at concentration level of 200 μg L−1 of diazinon and endosulfan, 100 μg L−1 of phosalone, 50.0 μg L−1 of atrazine, desethylatrazine and deisopropylatrazine (A) and spiked river water at concentration level of 50 μg L−1 of diazinon and endosulfan, 25 μg L−1 of phosalone, 12.5 μg L−1 of atrazine, desethylatrazine and deisopropylatrazine (B) obtained by using LPME-FDES combined HPLC-UV. Extraction conditions: as in Fig. 1; type of HBA, [DMIM]Cl; peak identification: (1) diazinon, (2) phosalone, (3) endosulfan, (4) desethylatrazine, (5) deisopropylatrazine, (6) atrazine.CC BY · PubMed Central

Verification

Claims the paper makes

0 Valid · 1 Not valid · 1 Not checked · 37 Own results and interpretations

20 more claims

Create a free account to see all 39 claims and every source verdict.

See all claims — free account
  • It may state two separate claims as one. 12
  • Probably not a substantial claim. 2

Create a free account to see these claims.

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

1 of 1

Citations

Cites

Show all 43 references

Research works printed but not linked: 1

  1. Casa-Resino, 2012, Comp. Biochem. Physiol., 156, 159

Metadata

Authors
Pirsaheb, M., & Fattahi, N.
Affiliations
Kermanshah University of Medical Sciences (IR)
Corresponding author
Fattahi, Nazir
Venue
RSC Advances
Published
2018
Volume
8
Issue
21
Pages
11412-11418
ISSN
2046-2069 (ISSN-L)
OpenAlex
W2790800929
Cited by
83
References
43
Citations by year
2026: 2 · 2025: 2 · 2024: 7 · 2023: 9 · 2022: 12 · 2021: 16 · 2020: 23 · 2019: 9 · 2018: 2
FWCI
7.80
Type
journal article
Language
en
Open access
Locations
  • RSC Advances (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
Funders
Kermanshah University of Medical Sciences (95485)
Topics
  • Physical Sciences › Chemistry › Analytical Chemistry › Analytical chemistry methods development
  • Life Sciences › Agricultural and Biological Sciences › Food Science › Pesticide Residue Analysis and Safety
  • Physical Sciences › Environmental Science › Pollution › Pesticide and Herbicide Environmental Studies
Keywords
liquid-phase microextraction, deep eutectic solvents, pesticide detection, atrazine, desethylatrazine, deisopropylatrazine, water samples, green extraction, HPLC-UV

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-09-29, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-09-29 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Development of a liquid-phase microextraction based on the freezing of a deep eutectic solvent followed by HPLC-UV for sensitive determination of common pesticides in environmental water samples. https://app.cochat.ai/papers/10.1039/c8ra00912k
The paper
Pirsaheb, M., & Fattahi, N. (2018). Development of a liquid-phase microextraction based on the freezing of a deep eutectic solvent followed by HPLC-UV for sensitive determination of common pesticides in environmental water samples. RSC Advances. https://doi.org/10.1039/c8ra00912k

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.