CoChat

The DOI matches its Crossref record; 56 of the 56 references it cites were found in a registry or an index.

Collective adaptability in a replication network of minimal nucleobase sequences

Open access
Vela-Gallego, Sonia, Pardo-Botero, Zulay, Moya, Cristian, de la Escosura, Andrés · 2022 · Chemical Science

Abstract

A replication network of minimal nucleobase sequences is built from simple biological components. The network shows collective adaptability to changes in the environment, while disulfide exchange wires different auto- and cross-catalytic pathways.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1039/d2sc02419e

Cites

56 of 56 references verified0 citation errors · 0 not checkable

Statistics

Figures

Fig. 1 (A) Set of building blocks and transformations that constitute the reaction network under study. A and T are thiol monomers with a single nucleobase, and therefore lack the potential to self-assemble. Black arrows represent the oxidation of A and T into the disulfide dimers AA, TT and AT, which can occur in a non-catalyzed manner or alternatively via auto- and cross-catalysis, provided that they are in sufficient concentration to form ‘catalytic’ aggregates. Grey arrows represent disulfide exchange reactions. (B) Replication network topology, showing cartoons of all possible auto- and cross-catalytic pathways. The three disulfides can self-aggregate (the aggregates being represented as polymers of the supramolecular dimers), which leads to their autocatalysis, with a higher efficiency for AT due to the presence of complementary nucleobases. AA and TT can also replicate through cross-catalysis based on the complementarity of their nucleobase sequences.
Fig. 1 (A) Set of building blocks and transformations that constitute the reaction network under study. A and T are thiol monomers with a single nucleobase, and therefore lack the potential to self-assemble. Black arrows represent the oxidation of A and T into the disulfide dimers AA, TT and AT, which can occur in a non-catalyzed manner or alternatively via auto- and cross-catalysis, provided that they are in sufficient concentration to form ‘catalytic’ aggregates. Grey arrows represent disulfide exchange reactions. (B) Replication network topology, showing cartoons of all possible auto- and cross-catalytic pathways. The three disulfides can self-aggregate (the aggregates being represented as polymers of the supramolecular dimers), which leads to their autocatalysis, with a higher efficiency for AT due to the presence of complementary nucleobases. AA and TT can also replicate through cross-catalysis based on the complementarity of their nucleobase sequences.CC BY-NC · PubMed Central
Fig. 2 Supramolecular studies of compounds AA, TT, and an equimolar mixture of AA/TT. (A) Plot of the diffusion coefficient (D) obtained by DOSY experiments versus the concentration of AA (left), TT (middle) and AA/TT (right). Critical aggregation concentration (cac) values were calculated as the intersection of two straight lines in the plots for AA and TT, and through fitting to a Boltzmann-type equation for AA/TT. (B, C) TEM micrographs of AA (left), TT (middle) and AA/TT (right) at two different concentrations: 1 mM (B) and 2 mM (C) in 50 mM borate buffer (pH 8.2).
Fig. 2 Supramolecular studies of compounds AA, TT, and an equimolar mixture of AA/TT. (A) Plot of the diffusion coefficient (D) obtained by DOSY experiments versus the concentration of AA (left), TT (middle) and AA/TT (right). Critical aggregation concentration (cac) values were calculated as the intersection of two straight lines in the plots for AA and TT, and through fitting to a Boltzmann-type equation for AA/TT. (B, C) TEM micrographs of AA (left), TT (middle) and AA/TT (right) at two different concentrations: 1 mM (B) and 2 mM (C) in 50 mM borate buffer (pH 8.2).CC BY-NC · PubMed Central
Fig. 3 Kinetic profiles corresponding to: (first row) the autocatalytic formation of AA (A), TT (B), and the mixture of possible replicators AA/TT/AT (E); (second row) seeded experiments for the autocatalytic formation of AA (C), TT (D), and AA/TT/AT (F); (third row) disulfide exchange reactions (up to 7 h) between AA and T (G) or TT and A (H). Each panel shows the evolution of all involved species over time through experimental data (square data points) and fit curves (marked as []T in the figure legend), while the set of rate equations used for fitting are depicted in Table 1. In the templated reactions (C, D, F), the total concentration of starting materials was maintained in the same range as in the non-templated ones (A, B, E), with minor experimental deviations that are difficult to avoid but are considered in the mathematical analysis. Importantly, the non-seeded experiments were repeated three times, while seeded experiments and disulfide exchange reactions were repeated twice (Fig. S17–S20†). The treatment of fitting errors with such repeats is shown in Section 7 of the ESI.†
Fig. 3 Kinetic profiles corresponding to: (first row) the autocatalytic formation of AA (A), TT (B), and the mixture of possible replicators AA/TT/AT (E); (second row) seeded experiments for the autocatalytic formation of AA (C), TT (D), and AA/TT/AT (F); (third row) disulfide exchange reactions (up to 7 h) between AA and T (G) or TT and A (H). Each panel shows the evolution of all involved species over time through experimental data (square data points) and fit curves (marked as []T in the figure legend), while the set of rate equations used for fitting are depicted in Table 1. In the templated reactions (C, D, F), the total concentration of starting materials was maintained in the same range as in the non-templated ones (A, B, E), with minor experimental deviations that are difficult to avoid but are considered in the mathematical analysis. Importantly, the non-seeded experiments were repeated three times, while seeded experiments and disulfide exchange reactions were repeated twice (Fig. S17–S20†). The treatment of fitting errors with such repeats is shown in Section 7 of the ESI.†CC BY-NC · PubMed Central
Fig. 4 Simulations of the network evolution when fed with two input streams (Qin = 1 μL min−1) of A and T, in the presence of replicator AT (0–2 mM) (A) or AA/TT (0–2 mM) (B). (C) 3D surface representing the reached steady state (SSAT below the surface; SSAA/TT above) for a range of initial replicator proportions (horizontal axes on the graph) and total replicator concentrations (CT, vertical axis). The surface marks the boundary between initial conditions that favour SSAT (below the surface) or SSAA/TT (above). (D, E) Simulations of the network evolution when decreasing the exchange constants by six orders of magnitude, with the same input streams and conditions as in (A) and (B).
Fig. 4 Simulations of the network evolution when fed with two input streams (Qin = 1 μL min−1) of A and T, in the presence of replicator AT (0–2 mM) (A) or AA/TT (0–2 mM) (B). (C) 3D surface representing the reached steady state (SSAT below the surface; SSAA/TT above) for a range of initial replicator proportions (horizontal axes on the graph) and total replicator concentrations (CT, vertical axis). The surface marks the boundary between initial conditions that favour SSAT (below the surface) or SSAA/TT (above). (D, E) Simulations of the network evolution when decreasing the exchange constants by six orders of magnitude, with the same input streams and conditions as in (A) and (B).CC BY-NC · PubMed Central

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Research works printed but not linked: 1

  1. Liu, 2022, Angew. Chem., Int. Ed., e202117605

Cited by

See all 6

Metadata

Authors
Vela-Gallego, S., Pardo-Botero, Z., Moya, C., & de la Escosura, A.
Affiliations
  • Department of Organic Chemistry, Universidad Autónoma de Madrid, Campus de Cantoblanco, 28049 Madrid, Spain
  • IMDEA Nanociencia, C/Faraday 7, 28049 Madrid, Spain
  • Universidad Autónoma de Madrid (ES)
Venue
Chemical Science
Published
2022
Volume
13
Issue
36
Pages
10715-10724
ISSN
  • 2041-6520 (ISSN-L)
  • 2041-6539
OpenAlex
W4294557116
Cited by
6
References
56
Citations by year
2026: 1 · 2025: 1 · 2024: 1 · 2023: 3
FWCI
0.50
Type
journal article
Language
en
Open access
Locations
  • Chemical Science (publishedVersion, cc-by-nc)
  • PubMed Central (publishedVersion, cc-by-nc)
  • PubMed (publishedVersion)
  • Biblos-e Archivo (Universidad Autónoma de Madrid) (submittedVersion, public-domain)
  • Hispana (submittedVersion)
Funders
  • European Innovation Council (Grant Agreement No 862081)
  • Ministerio de Ciencia e Innovación (CTQ-2017-89539-P, EUIN2017-87022, PID2020-119306GB-100)
Topics
  • Physical Sciences › Physics and Astronomy › Astronomy and Astrophysics › Origins and Evolution of Life
  • Life Sciences › Biochemistry, Genetics and Molecular Biology › Molecular Biology › RNA and protein synthesis mechanisms
  • Life Sciences › Biochemistry, Genetics and Molecular Biology › Genetics › Evolution and Genetic Dynamics
Keywords
origin of life, adenine, thymine, cysteine, disulfide exchange, sequence complementarity, bistability, autocatalysis, cross-catalysis, feedstock availability, supramolecular self-assembly, kinetic analysis

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.