The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
How much power is enough? Against the development of an arbitrary convention for statistical power calculations
Abstract
Due largely to the work of Jacob Cohen (1962, 1988), statistical power analysis has become a widely known technique in many fields of experimental science. Promotion of power analysis in ecology (Toft & Shea 1983; Peterman 1990a,b; Fairweather 1991) has led to its increasing use over the last few decades. This trend is encouraging as power analysis is a useful tool in the planning phase of ecological experiments and can also be used after data analysis to improve the interpretation of non-significant results (Quinn & Keough 2002). Statistical power = 1 –β where β is the Type II error rate. Power can generally be described by the equation Power ∝ (ES × α × √n)/σ where ES is the effect size, α is the Type I error rate, n is the sample size and σ is the population standard deviation. A Type I error is the probability of erroneously rejecting the null hypothesis, while a Type II error is the probability of erroneously failing to reject the null hypothesis. Equation 1 (its specific form depends on the statistical model being used) is usually solved for power, sample size or effect size depending on the objectives of the analysis (Fairweather 1991), and can be implemented either before or after data are collected. Whichever way power analysis is used, researchers must often make a decision about what constitutes an acceptable level of power. This is almost always difficult as there is no simple way to decide how much power is enough. Unfortunately, the definition of adequate statistical power in the ecological literature often appears arbitrary with minimal attention to the context within which individual studies are conducted. Authors frequently state that statistical power is adequate if its value is 0·80 or above (Steidl, Hayes & Schauber 1997; Lougheed, Breault & Lank 1999; Manolis, Andersen & Cuthbert 2000; Strehlow et al. 2002), and a convention is fast developing where ‘significance and power levels are set … at 0·05 and 0·80 … respectively’ (Walsh et al. 1999). This practice is hereafter referred to as the five-eighty convention. When the five-eighty convention is used, the probabilities of making Type I and Type II errors are 5% and 20%, respectively. Implicitly, this means that the cost of making a Type I error is considered four times more important than the cost of making a Type II error (Cohen 1988). While in some situations this may be the case, it certainly cannot be assumed. For example, in the fields of impact assessment and conservation biology, making a Type II error will often be more costly than making a Type I error (Peterman 1990b; Taylor & Gerrodette 1993). However, the specific scientific, economic and socio-political context within which research is conducted will influence the relative importance of each type of error (Di Stefano 2001), thus designating research fields in which Type I or Type II errors are more important is problematic. The relative costs of statistical errors need to be considered each time that an experiment or monitoring program is planned. The need to identify the relative costs of Type I and Type II errors when deciding on an acceptable level of statistical power has been discussed at some length in the literature (Toft & Shea 1983; Peterman 1990a; Peterman & Mgonigle 1992; Mapstone 1995; Keough & Mapstone 1997; Downes et al. 2002). Although evaluating the relative costs of Type I and Type II errors is complex and may be influenced by the perspective of the decision maker, the process brings the functional consequences of statistical errors to the fore and thus promotes rational consideration of the scientific, economic or socio-political issues that may be at stake. For example, consider an experiment designed to test the ecological impact of a toxin in a waterway. In this case the cost of making a Type II error (concluding there is no toxic effect when there is one) is arguably greater than the cost of making a Type I error (concluding that there is a toxic effect when one does not exist). A Type I error may result in unnecessary clean up efforts, or the implementation of unjustified fines or other penalties. A Type II error, however, would result in management inaction and (depending on the type and quantity of the toxin) potentially serious environmental damage. Peterman (1990b) provides an example from the field of fisheries ecology where making a Type II error led to management inaction and a subsequent decline in fish stocks. Alternatively, if researchers were interested in testing whether a new highly mechanised timber-harvesting technique resulted in better wildlife habitat than a conventional labour-intensive technique, the cost of making a Type I error (concluding that the new technique is better when it is not) may be greater. If the implementation of the new technique resulted in large technology changeover costs and job losses, making a Type I error could place substantial economic pressure on the local human population. A Type II error (concluding th
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Experimental Design and Data Analysis for Biologists
Quinn, G. P., & Keough, M. J. (2002) · doi:10.1017/cbo9780511806384 · Cited by 10,674
The statistical power of abnormal-social psychological research: A review.
Cohen, J. (1962) · The Journal of Abnormal and Social Psychology · doi:10.1037/h0045186 · Cited by 1,824
Monitoring Ecological Impacts: Concepts and Practice in Flowing Waters
Downes, B. J., Barmuta, L. A., Fairweather, P. G., Faith, D. P., Keough, M. J., Lake, P. S., Mapstone, B. D., & Quinn, G. P. (2002) · doi:10.1017/cbo9780511542015 · Cited by 42
Cited by
Ellis, P. D. (2010) · doi:10.1017/cbo9780511761676 · Cited by 2,461
Why most conservation monitoring is, but need not be, a waste of time
Legg, C. J., & Nagy, L. (2006) · Journal of Environmental Management · doi:10.1016/j.jenvman.2005.04.016 · Cited by 483
Indicators to support an ecosystem approach to fisheries
Jennings, S. (2005) · Fish and Fisheries · doi:10.1111/j.1467-2979.2005.00189.x · Cited by 330
OPTIMIZING ALLOCATION OF MONITORING EFFORT UNDER ECONOMIC AND OBSERVATIONAL CONSTRAINTS
FIELD, S. A., TYRE, A. J., & POSSINGHAM, H. P. (2005) · Journal of Wildlife Management · doi:10.2193/0022-541x(2005)069[0473:oaomeu]2.0.co;2 · Cited by 271
FIELD, S. A., O'CONNOR, P. J., TYRE, A. J., & POSSINGHAM, H. P. (2007) · Austral Ecology · doi:10.1111/j.1442-9993.2007.01715.x · Cited by 258
Metadata
- Authors
- Di Stefano, J.
- Venue
- Functional Ecology
- Publisher
- Wiley
- Published
- 2003-09-29
- Volume
- 17
- Issue
- 5
- Pages
- 707-709
- ISSN
- 0269-8463 (ISSN-L)
- 1365-2435
- OpenAlex
- W2032688037
- Cited by
- 159
- References
- 3
- FWCI
- 9.49
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: How much power is enough? Against the development of an arbitrary convention for statistical power calculations. https://app.cochat.ai/papers/10.1046/j.1365-2435.2003.00782.x
- The paper
- Di Stefano, J. (2003). How much power is enough? Against the development of an arbitrary convention for statistical power calculations. Functional Ecology. https://doi.org/10.1046/j.1365-2435.2003.00782.x
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.