The DOI matches its Crossref record.
Lateral velocity resolution from three-dimensional seismic refraction data
Open accessAbstract
A method for estimating the lateral velocity resolution from 3-D seismic refraction traveltimes is presented. The method is non-linear in that synthetic data calculated from ‘checkerboard’ models are inverted using an iterative tomographic approach incorporating smoothness constraints and updated ray paths at each iteration. Two applications are presented: (1) real data from the Faeroe Basin experiment using the ray coverage and noise level of approximately 50000 picks, and (2) ideal data from the same experiment corresponding to 100 per cent data recovery, equivalent to about three times as many ray paths. The refraction data constrain the sedimentary and basement structure to approximately 12 km depth. A comparison of the results from the two data sets provides a qualitative check on the resolution method, illustrates the pitfalls of using ray coverage as an indicator of resolution, and demonstrates the potential resolution of currently feasible 3-D refraction experiments. 32 checkerboard models consisting of alternating positive and negative velocity anomalies superimposed on the preferred final model of the basin were tested, each with a different cell size, position or orientation. The problem of ray bending associated with the 5 per cent checkerboard anomalies is shown to be small. Using models with four cell sizes allowed for resolution estimates from 3 to 15 km, this range being imposed by the frequency content of the data and the areal dimensions of the study area (44×26 km). An operator centred on each model node measures the local semblance between the known and recovered checkerboard models. A determination of the smallest well-resolved cell size at each model node is then made using a 0.7 semblance threshold to provide a spatially dependent lateral resolution estimate. Resolution for the real data set varies from an average of just over 3 km at 2 km depth, to 10 km at 10 km depth, where there is a local maximum in ray coverage due to a concentration of ray-bottoming points. For the ideal data set, the average lateral resolution drops off roughly linearly from better than 3 km at 2 km depth, to 6.3 km at 10 km depth. The largest difference between the resolution associated with the ideal and real data occurs at 7.2 km depth, where it averages 4.6 km for the former and 10.8 km for the latter due to the near absence of ray-bottoming points between 7 and 9 km. The results show that the final model for the Faeroe Basin obtained by regularized inversion with smoothness constraints is consistent with the resolution estimates in the sense that the model does not contain structure with a wavelength smaller than the resolution estimate at any point. The results for the ideal data show that good-quality 3-D refraction experiments can provide a lateral resolution of no worse than the receiver spacing (shot spacing for land data) throughout most of the sampled volume.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
The Yellowstone magmatic system from the mantle plume to the upper crust
Huang, H.-H., Lin, F.-C., Schmandt, B., Farrell, J., Smith, R. B., & Tsai, V. C. (2015) · Science · doi:10.1126/science.aaa5648 · Cited by 304
VERMEESCH, P. M., & MORGAN, J. V. (2004) · Meteoritics & Planetary Science · doi:10.1111/j.1945-5100.2004.tb01127.x · Cited by 38
Metadata
- Authors
- Zelt, C. A.
- Venue
- Geophysical Journal International
- Publisher
- Oxford University Press (OUP)
- Published
- 1998-12
- Volume
- 135
- Issue
- 3
- Pages
- 1101-1112
- ISSN
- 0956-540X (ISSN-L)
- 1365-246X
- OpenAlex
- W2158212418
- Cited by
- 206
- References
- 0
- FWCI
- 4.17
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Lateral velocity resolution from three-dimensional seismic refraction data. https://app.cochat.ai/papers/10.1046/j.1365-246x.1998.00695.x
- The paper
- Zelt, C. A. (1998). Lateral velocity resolution from three-dimensional seismic refraction data. Geophysical Journal International. https://doi.org/10.1046/j.1365-246x.1998.00695.x
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.