Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 246

The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.

Introduction of biocides into clinical practice and the impact on antibiotic-resistant bacteria: BIOCIDES AND ANTIBIOTIC RESISTANCE

Russell, A.D.·2002·Journal of Applied Microbiology

Abstract

1. Summary, 121S 2. Introduction, 121S 2.1 Historical, 121S 2.2 Bacterial susceptibility or resistance to antibiotics and biocides, 122S 3. Possible linked biocide-antibiotic resistance, 123S 4. Introduction of biocides into clinical practice and bacterial resistance, 124S 4.1 Bacterial resistance to cationic biocides, 124S 4.2 Bacterial resistance to other biocides, 126S 4.3 Biocide usage and antibiotic resistance in Gram-negative bacteria, 127S 4.4 Biocide usage and antibiotic resistance in staphylococci, 127S 4.5 Biocide usage and antibiotic resistance in mycobacteria, 128S 5. Overall comments and conclusions, 129S 6. References, 130S Biocides and other antimicrobial agents have been employed for centuries. Much later, iodine found use as a wound disinfectant, chlorine water in obstetrics, alcohol as a hand disinfectant and phenol as a wound dressing and in antiseptic surgery. In the early part of the twentieth century, other chlorine-releasing agents (CRAs), and acridine and other dyes were introduced, as were some quaternary ammonium compounds (QACs, although these were only used as biocides from the 1930s). Later still, various phenolics and alcohols, formaldehyde and hydrogen peroxide were introduced and subsequently (although some had actually been produced at an earlier date) biguanides, iodophors, bisphenols, aldehydes, diamidines, isocyanurates, isothiazolones and peracetic acid. Antibiotics were introduced clinically in the 1940s, although sulphonamides had been synthesized and used previously. After penicillin came streptomycin and other aminoglycosides-aminocyclitols, tetracyclines, chloramphenicol, macrolides, semi-synthetic beta-lactams, glycopeptides, lincosamides, 4-quinolones and diaminopyrimidines. Bacterial resistance to antibiotics is causing great concern. Mechanisms of such resistance include cell impermeability, target site mutation, drug inactivation and drug efflux. Bacterial resistance to biocides was described in the 1950s and 1960s and is also apparently increasing. Of the biocides listed above, cationic agents (QACs, chlorhexidine, diamidines, acridines) and triclosan have been implicated as possible causes for the selection and persistence of bacterial strains with low-level antibiotic resistance. It has been claimed that the chronological emergence of qacA and qacB determinants in clinical isolates of Staphylococcus aureus mirrors the introduction and usage of cationic biocides. Biocides (antiseptics, disinfectants and preservatives) and other antimicrobial agents have been used in various forms for centuries. Early empirical approaches used copper and silver vessels for storing potable water; vinegar and honey for cleansing wounds; balsams as natural preservatives in aiding mummification; and drying, salting and spices for preserving fish and meat. Fracastoro's concept of the `seeds of disease' as possible aetiological agents was put forward in the fifteenth century and the `animalcules' of van Leeuwenhoek described in the seventeenth. Later, a method of quantifying chemical preservation was devised by Pringle, in which solutions of various salts were compared with a standard (sea salt) in terms of their relative ability to preserve lean meat. Later still, reports were made about the use of iodine as a wound disinfectant, of chlorine water in obstetrics and of phenol (carbolic acid) as a wound dressing and in antiseptic surgery (the high toxicity of agents applied directly to the human body is to be noted), and of the claimed sporicidal activity of mercuric chloride. These and other aspects of the early historical development of these chemical agents are well reviewed by 58, 59, 61, 62) and 21). In the early part of the twentieth century, other chlorine-releasing agents (CRAs) and some quaternary ammonium compounds (QACs) were introduced (see 61, 63; 21). By 1945, the biocides in common use included phenolics, organomercurials, CRAs, iodine, alcohols, formaldehyde, hydrogen peroxide, silver compounds and dyes (acridines, triphenylmethanes). Several of these remain in use at the beginning of the twentyfirst century. Some of the biocides introduced since 1945 (122) had actually been produced at an earlier date but not tested for antimicrobial efficacy until some time had elapsed. Probably the most important agents introduced since 1945 are biguanides (chlorhexidine, alexidine and polymeric forms), amphoteric surfactants, bisphenols including triclosan, aldehydes (notably glutaraldehyde, succinaldehyde-based products and ortho-phthalaldehyde), CRAs such as isocyanurates, iodine-releasing agents (iodophors), isothiazolones and peracetic acid (Table 1). Although antibiotics are often classically considered as dating from Fleming's work in the 1920s, in fact, the curative value of moulds has been known since ancient times and work in the nineteenth century was undertaken on the antibacterial activity of Penicillium spp. by Burdon, Sanderson and especially by Joseph Lister, Willia

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1046/j.1365-2672.92.5s1.12.x

Cites

2 of 2 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 2 references

Cited by

See all 246

Metadata

Authors
Russell, A. D.
Venue
Journal of Applied Microbiology
Published
2002-05
Volume
92
Issue
31
Pages
121S-135S
ISSN
1364-5072 (ISSN-L)
OpenAlex
W2170812462
Cited by
246
References
2
FWCI
7.33
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Introduction of biocides into clinical practice and the impact on antibiotic-resistant bacteria: BIOCIDES AND ANTIBIOTIC RESISTANCE. https://app.cochat.ai/papers/10.1046/j.1365-2672.92.5s1.12.x
The paper
Russell, A. D. (2002). Introduction of biocides into clinical practice and the impact on antibiotic-resistant bacteria: BIOCIDES AND ANTIBIOTIC RESISTANCE. Journal of Applied Microbiology. https://doi.org/10.1046/j.1365-2672.92.5s1.12.x

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.