Nanotopography of synthetic and natural dolomite crystals
Open accessThe DOI matches its Crossref record; 4 of the 4 references it cites were found in a registry or an index.
Abstract
Examination with scanning electron microscopy (SEM) and scanning force microscopy (SFM) revealed etch pits, layers and islands on dolomite crystal faces synthesized from calcite in Ca‐Mg‐Cl solutions at 200 °C and a wide variety of natural dolomites. Layers are broad, flat structures bounded by steps less than 100 nm high and greater than 1 μm wide. Islands are rounded topographic highs <20 nm high and <200 nm wide. The nanotopography of synthetic dolomite changed from islands throughout most of the reaction to layers at 100% dolomite. Island nanotopography formed on both Ca‐rich and near‐stoichiometric dolomite. Analyses of reaction products from dolomite synthesis indicates that there are no SFM‐detectable products formed in <10 h. SEM‐detectable products formed in 15 h. X‐ray diffraction (XRD)‐detectable products formed in ≈18 h, and the reaction went to completion in ≈40 h. Based on SFM analyses, the induction period for dolomitization in these experiments accounts for ≈20% of the total reaction time necessary to dolomitize CaCO 3 completely under the experimental conditions used here. Island nano‐ topography is inferred to occur at higher degrees of supersaturation than layer nanotopography for three reasons. First, island nanotopography on synthetic calcite and gypsum forms at higher supersaturations than layer nanotopography. Secondly, island nanotopography formed in solutions with higher degrees of supersaturation with respect to dolomite. Thirdly, the greater surface roughness of a crystal face composed of islands compared with layers indicates that island surfaces have higher surface energy than layer surfaces. Therefore, the stability of island surfaces requires a higher degree of supersaturation. Because islands and layers form under a wide range of conditions, their presence provides broadly applicable criteria for evaluating relative degrees of supersaturation under which ancient dolomite formed. Comparison of synthetic dolomites with natural dolomites demonstrates (1) similar nanotopography on natural and synthetic dolomites and (2) both natural planar and non‐planar dolomite may have island nanotopography.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Chemistry and environments of dolomitization-a reappraisal
Machel, H.-G., & Mountjoy, E. W. (1986) · Earth-Science Reviews · doi:10.1016/0012-8252(86)90017-6 · Cited by 350
Structural and compositional variations in some natural dolomites
Goldsmith, J. R., & Graf, D. L. (1958) · The Journal of Geology · doi:10.1086/626547 · Cited by 295 · cited 1×
“The composition of the synthetic dolomite was calculated by the corrected position of the d(104) peak (Goldsmith & Graf, 1958; Lumsden & Chimahusky, 1980).”
MethodThe dolomitization of CaCO3: an experimental study at 252–295°C
Katz, A., & Matthews, A. (1977) · Geochimica et Cosmochimica Acta · doi:10.1016/0016-7037(77)90238-1 · Cited by 165 · cited 1×
“Kinetic information can be inferred from high-temperature experiments (Katz & Matthews, 1977; Gaines, 1980; Sibley et al., 1994), but it is not clear whether those results are applicable to natural, low-temperature dolomites.”
BackgroundDolomite stoichiometry and Ostwald's Step Rule
Nordeng, S. H., & Sibley, D. F. (1994) · Geochimica et Cosmochimica Acta · doi:10.1016/0016-7037(94)90456-1 · Cited by 78
Self-citation
Cited by
Gregg, J. M., Bish, D. L., Kaczmarek, S. E., & Machel, H. G. (2015) · Sedimentology · doi:10.1111/sed.12202 · Cited by 480
“…of time elapsing after the onset of experimental conditions where no products are detected (Gaines, 1968; Katz & Matthews, 1977; Sibley & Bartlett, 1987; Sibley et al., 1987; Sibley, 1990; Nordeng & Sibley, 1994; Sibley et al., 1994; Kessels et al., 2000; Kaczmarek & Sibley, 2007, 2011, 2014).”
BackgroundKaczmarek, S. E., & Sibley, D. F. (2011) · Sedimentary Geology · doi:10.1016/j.sedgeo.2011.07.003 · Cited by 199
“…Sibley et al., 1987; Morrow and Rickets, 1988; Sibley, 1990; Sibley et al., 1994; Usdowski, 1994; Malone et al., 1996; Arvidson and Mackenzie, 1999; Kessels et al., 2000; Kaczmarek and Sibley, 2007), yet there is little theoretical basis for extrapolating data from high-temperature synthesis…”
BackgroundSelf-citationSnæbjörnsdóttir, S. Ó., Oelkers, E. H., Mesfin, K., Aradóttir, E. S., Dideriksen, K., Gunnarsson, I., Gunnlaugsson, E., Matter, J. M., Stute, M., & Gislason, S. R. (2017) · International Journal of Greenhouse Gas Control · doi:10.1016/j.ijggc.2017.01.007 · Cited by 193
“Such minerals have been reported to be kinetically inhibited from 658 forming abiotically at temperatures less than 80 °C (Higgins and Hu, 2005; Kessels et al., 2000; 659 Lippmann, 1973; Saldi et al., 2009, 2012).”
BackgroundDirect physical evidence of dolomite recrystallization
Kaczmarek, S. E., & Sibley, D. F. (2014) · Sedimentology · doi:10.1111/sed.12119 · Cited by 131
Self-citationKaczmarek, S. E., & Thornton, B. P. (2017) · Chemical Geology · doi:10.1016/j.chemgeo.2017.08.004 · Cited by 128
Metadata
- Authors
- Kessels, L. A., Sibley, D. F., & Nordeng, S. H.
- Venue
- Sedimentology
- Publisher
- Wiley
- Published
- 2000-02
- Volume
- 47
- Issue
- 1
- Pages
- 173-186
- ISSN
- 0037-0746 (ISSN-L)
- 1365-3091
- OpenAlex
- W2015936847
- Cited by
- 24
- References
- 4
- FWCI
- 0.53
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Nanotopography of synthetic and natural dolomite crystals. https://app.cochat.ai/papers/10.1046/j.1365-3091.2000.00287.x
- The paper
- Kessels, L. A., Sibley, D. F., & Nordeng, S. H. (2000). Nanotopography of synthetic and natural dolomite crystals. Sedimentology. https://doi.org/10.1046/j.1365-3091.2000.00287.x
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.