High‐voltage boost quasi‐Z‐source isolated DC/DC converter
The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Abstract
A high‐voltage gain two‐switch quasi‐Z‐source isolated DC/DC converter has been presented in this study. It consists of a quasi‐Z‐source network at its input, a push–pull square‐wave inverter at its middle, and a voltage‐doubler rectifier at its output. When coordinated appropriately, the new converter uses less switches, a smaller common duty cycle and less turns for the transformer when compared with existing topologies. Its size and weight are therefore smaller, whereas its efficiency is higher. It is therefore well‐suited for applications, where a wide range of voltage gain is required like renewable energy systems, DC power supplies found in telecom, aerospace and electric vehicles. To demonstrate the performance of the proposed converter, a 400 V, 500 W prototype has been implemented in the laboratory. Efficiency of the prototype measured is found to vary from 89.0 to 97.4% when its input voltage changes from 44 to 82 V at full load.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Review of Nonisolated High-Step-Up DC/DC Converters in Photovoltaic Grid-Connected Applications
Li, W., & He, X. (2011) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2010.2049715 · Cited by 1,423
Cited by
Forouzesh, M., Siwakoti, Y. P., Gorji, S. A., Blaabjerg, F., & Lehman, B. (2017) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2017.2652318 · Cited by 2,123
Self-citationA review of galvanically isolated impedance-source DC-DC converters
Chub, A., Vinnikov, D., Blaabjerg, F., & Peng, F. Z. (2016) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2015.2453128 · Cited by 243
Self-citationSurvey of DC-DC Non-Isolated Topologies for Unidirectional Power Flow in Fuel Cell Vehicles
Sagar Bhaskar, M., Ramachandaramurthy, V. K., Padmanaban, S., Blaabjerg, F., Ionel, D. M., Mitolo, M., & Almakhles, D. (2020) · IEEE Access · doi:10.1109/access.2020.3027041 · Cited by 214
“In [153]–[156], DC-DC converter proposed with another technique by employing quasi-Y-source network to smoothen the current by adding one additional capacitor and inductor.”
BackgroundMethodSelf-citationIsolated switched-boost push–pull DC–DC converter for step-up applications
Gorji, S. A., Ektesabi, M., & Zheng, J. (2017) · Electronics Letters · doi:10.1049/el.2016.4151 · Cited by 54
Metadata
- Authors
- Siwakoti, Y. P., Blaabjerg, F., Loh, P. C., & Town, G. E.
- Venue
- IET Power Electronics
- Published
- 2014-09
- Volume
- 7
- Issue
- 9
- Pages
- 2387-2395
- ISSN
- 1755-4535 (ISSN-L)
- 1755-4543
- OpenAlex
- W2090936314
- Cited by
- 65
- References
- 1
- FWCI
- 4.42
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.