Cited by 22Power Quality and HarmonicsMultilevel Inverters and ConvertersAdvanced DC-DC Converters

The DOI matches its Crossref record; 13 of the 13 references it cites were found in a registry or an index.

Bi-directional single-phase half-bridge rectifier for power quality compensation

Lin, B.R., Hung, T.L., Huang, C.H.·2003·IEE Proceedings - Electric Power Applications

Abstract

A single-phase half-bridge rectifier with a capacitor clamped scheme is proposed. Four power switches and one flying capacitor are employed in the proposed rectifier. Bipolar and unipolar PWM control schemes are used to perform power factor correction and achieve low total harmonic distortion of line current. A neutral point voltage balance compensator, hysteresis current controller and DC link voltage regulator are used to balance neutral point voltage, to track line current command, and to maintain the constant DC bus voltage. The proposed control scheme and the circuit configuration can also perform a shunt active power filter operation to eliminate the harmonic currents and compensate the reactive power generated from the nonlinear load. Analytical and experimental results are presented to illustrate the validity and effectiveness of the proposed control scheme.

Overview

Integrity signals

Registry

Crossref · 10.1049/ip-epa:20030261

Cites

13 of 13 references verified0 citation errors · 0 not checkable

Statistics

Recomputing p-values needs the paper’s full text.

Verification

Claims the paper makes

This paper’s full text isn’t openly available, so its claims and self-check weren’t run. The registry and citation checks still apply.

Citations

Cites

Flagged first, then by citations

Research works printed but not linked: 8

  1. Brkovic, 1992, Proceedings of IEEE International Telecommunications energy Conference, (INTELEC), 532
  2. Draou, 1994, 141, 275
  3. Erickson, 1990, Proceedings of IEEE Applied power electronics Conference (APEC), 792
  4. Watanabe, 1993, 8, 697
  5. Siares, 1997, Proceedings of European Power electronics and applications Conference (EPE), 4.804
  6. Stanislaw, 1997, Proceedings of the European power electronics and applications Conference (EPE), 4.831
  7. Isidori, A.: ‘Nonlinear control systems: an introduction’, 2nd(Springer-Verlag, London 1991)
  8. Tsai, 1992, 9, 61

Cited by

Sorted by citations

Metadata

Authors
Lin, B. R., Hung, T. L., & Huang, C. H.
Affiliations
National Yunlin University of Science and Technology (TW)
Venue
IEE Proceedings - Electric Power Applications
Published
2003-07-08
Volume
150
Issue
4
Pages
397-406
ISSN
  • 1350-2352 (ISSN-L)
  • 1359-7043
OpenAlex
W1972408375
Cited by
22
References
13
Citations by year
2025: 1 · 2023: 2 · 2022: 2 · 2021: 3 · 2019: 1 · 2017: 1 · 2016: 2 · 2015: 1 · 2013: 2 · 2012: 1
FWCI
0.67
Type
journal article
Language
en
Open access
closed
Locations
IEE Proceedings - Electric Power Applications (publishedVersion)
Funders
National Science Council
Topics
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Power Quality and Harmonics
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Multilevel Inverters and Converters
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced DC-DC Converters
Keywords
flying capacitor, power factor correction, total harmonic distortion reduction, neutral-point voltage balancing, hysteresis current control, DC bus voltage regulation, shunt active power filter, reactive power compensation, nonlinear loads, harmonic current suppression

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review