Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 174

The DOI matches its Crossref record.

Influence of annealing and Al2O3 properties on the hydrogen-induced passivation of the Si/SiO2 interface

Open access
Dingemans, G., Einsele, F., Beyer, W., van de Sanden, M. C. M., Kessels, W. M. M. · 2012 · Journal of Applied Physics

Abstract

Annealing at moderate temperatures is required to activate the silicon surface passivation by Al2O3 thin films while also the thermal stability at higher temperatures is important when Al2O3 is implemented in solar cells with screenprinted metallization. In this paper, the relationship between the microstructure of the Al2O3 film, hydrogen diffusion, and defect passivation is explored in detail for a wide range of annealing temperatures. The chemical passivation was studied using stacks of thermally-grown SiO2 and Al2O3 synthesized by atomic layer deposition. Thermal effusion measurements of hydrogen and implanted He and Ne atoms were used to elucidate the role of hydrogen during annealing. We show that the passivation properties were strongly dependent on the annealing temperature and time and were significantly influenced by the Al2O3 microstructure. The latter was tailored by variation of the deposition temperature (Tdep = 50 °C–400 °C) with hydrogen concentration [H] between 1 and 13 at.% and mass density ρmass between 2.7 and 3.2 g/cm3. In contrast to films with intermediate material properties, the passivation by low- and high density films showed a reduced thermal stability at relatively high annealing temperatures (∼600 °C). These observations proved to be in good agreement with thermal effusion results of hydrogen and inert gas atoms that were also strongly dependent on film microstructure. We demonstrate that the temperature of maximum effusion decreased for films with progressively lower density (i.e., with increasing [H]). Therefore, the reduced thermal stability of the passivation for low-density hydrogen-rich ([H] >∼5 at. %) films can be attributed to a loss of hydrogen at relatively low annealing temperatures. In contrast, the lower initial [H] for dense Al2O3 films can likely explain the lower thermal stability associated with these films. The effusion measurements also allowed us to discuss the role of molecular- and atomic hydrogen during annealing.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1063/1.4709729

Cites

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cited by

See all 174

Metadata

Authors
Dingemans, G., Einsele, F., Beyer, W., van de Sanden, M. C. M., & Kessels, W. M. M.
Venue
Journal of Applied Physics
Published
2012-05-01
Volume
111
Issue
9
ISSN
  • 0021-8979 (ISSN-L)
  • 1089-7550
OpenAlex
W2084690397
Cited by
174
References
0
FWCI
8.55
Type
journal article
Language
en
Open access
green

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Influence of annealing and Al2O3 properties on the hydrogen-induced passivation of the Si/SiO2 interface. https://app.cochat.ai/papers/10.1063/1.4709729
The paper
Dingemans, G., Einsele, F., Beyer, W., van de Sanden, M. C. M., & Kessels, W. M. M. (2012). Influence of annealing and Al2O3 properties on the hydrogen-induced passivation of the Si/SiO2 interface. Journal of Applied Physics. https://doi.org/10.1063/1.4709729

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.