Thermal energy storage behaviour of nanoparticle enhanced PCM during freezing and melting
The DOI matches its Crossref record; 29 of the 29 references it cites were found in a registry or an index.
Abstract
The present research work aimed to investigate the melting and solidification characteristics of NPCM. The NPCM was prepared using paraffin as the PCM and high conductive MWCNT as the nanomaterial without using any dispersant. The NPCM was prepared by dispersing MWCNTs with volume fractions of 0.3%, 0.6% and 0.9% in PCM as the base PCM. SEM morphology showed the uniform dispersion of MWCNTs in the paraffin wax. The MWCNT nano-additives PCMs showed two peaks in the heating curve by DSC measurement. Lessening in melting and solidification time of 30% and 43% was attained in the case of NPCM with 0.3% and 0.9%, respectively. It is observed from the DSC analysis that the latent heat of pure paraffin during freezing and melting cycle was 139.2 J/g (at 56.61 °C) and 131.8 J/g (at 57.55 °C), respectively. Whereas, the latent heat of NPCM with 0.9% of nanofluid was 150.7 J/g (at 56.36 °C) and 148.3 J/g (58.35 °C). It is construed that a maximum change in latent heat of 7.6% and 11% was observed between pure PCM and NPCM during freezing and melting cycle. For the lesser nanoparticle concentration (0.3% and 0.6%), the percentage change in latent heat was lesser than 0.9%.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Melting times were lowest at 0.3 wt % MWCNTs, with a decrease of 30%, which was potentially due to increases in viscosity past this point.”
From Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review (2021) · cites this paper as [43]
In the citing paper
“Solidification times were lowest at 0.9 wt %, with a decrease of 42.2% [43].”
From Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review (2021) · cites this paper as [43]
Citations
Cites
Describing the uncertainties in experimental results
Moffat, R. J. (1988) · Experimental Thermal and Fluid Science · doi:10.1016/0894-1777(88)90043-x · Cited by 9,860
Sabbah, R., Kizilel, R., Selman, J. R., & Al-Hallaj, S. (2008) · Journal of Power Sources · doi:10.1016/j.jpowsour.2008.03.082 · Cited by 680
Thermal performance of a solar-aided latent heat store used for space heating by heat pump
Esen, M. (2000) · Solar Energy · doi:10.1016/s0038-092x(00)00015-3 · Cited by 513
Esen, M., Durmuş, A., & Durmuş, A. (1998) · Solar Energy · doi:10.1016/s0038-092x(97)00104-7 · Cited by 480
Fan, L.-W., Fang, X., Wang, X., Zeng, Y., Xiao, Y.-Q., Yu, Z.-T., Xu, X., Hu, Y.-C., & Cen, K.-F. (2013) · Applied Energy · doi:10.1016/j.apenergy.2013.04.043 · Cited by 478
Esen, M., & Ayhan, T. (1996) · Energy Conversion and Management · doi:10.1016/0196-8904(96)00035-0 · Cited by 429
Khateeb, S. A., Amiruddin, S., Farid, M., Selman, J. R., & Al-Hallaj, S. (2005) · Journal of Power Sources · doi:10.1016/j.jpowsour.2004.09.033 · Cited by 410
Highly conductive composites made of phase change materials and graphite for thermal storage
Pincemin, S., Olives, R., Py, X., & Christ, M. (2008) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2007.11.010 · Cited by 339
Wu, S., Zhu, D., Zhang, X., & Huang, J. (2010) · Energy & Fuels · doi:10.1021/ef9013967 · Cited by 309
Experimentation with a water tank including a PCM module
Cabeza, L. F., Ibáñez, M., Solé, C., Roca, J., & Nogués, M. (2006) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2005.08.002 · Cited by 272
Research works printed but not linked: 4
- Cabeza LF, 2014, Advances in thermal energy storage systems: methods and applications. Woodhead Publishing, series in energy
- Vellaisamy K, 2013, Heat and Mass Transfer, 48, 1345
- Sharma A, 2009, Int Rev Chem Eng, 1, 297
- Luisa Fez, 2006, Sol Energy Mater Sol Cells. 2006;, 90, 1273
Cited by
Bharathiraja, R., Ramkumar, T., Selvakumar, M., & Radhika, N. (2024) · Renewable Energy · doi:10.1016/j.renene.2024.119986 · Cited by 174
Manoj Kumar, P., Mylsamy, K., & Saravanakumar, P. T. (2020) · Energy Sources, Part A: Recovery, Utilization, and Environmental Effects · doi:10.1080/15567036.2019.1607942 · Cited by 152
Review on Nano Enhanced PCMs: Insight on nePCM Application in Thermal Management/Storage Systems
Mebarek‐Oudina, F., & Chabani, I. (2023) · Energies · doi:10.3390/en16031066 · Cited by 164
Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review
Tofani, K., & Tiari, S. (2021) · Energies · doi:10.3390/en14133821 · Cited by 114
“…(2018) [42] Paraffin wax (82 ◦C) Low Al2O3, TiO2, MgO, ZnO, MWCNTs and Graphene nanoplatelet Melting and solidification Experimental GNPs showed thebest improvement Murugan et al. (2018) [43] Paraffin (18–23 ◦C) Low MWCNT Melting and solidification Experimental Melting improved up to 0.3 wt…”
BackgroundInfluentialBharathiraja, R., Ramkumar, T., & Selvakumar, M. (2023) · Journal of Energy Storage · doi:10.1016/j.est.2023.109216 · Cited by 125
Metadata
- Authors
- P, M., P, G. K., V, K., M, M., K, M. M., & R, V.
- Affiliations
- Department of Mechanical Engineering, Anna University, Chennai, India
- Anna University, Chennai (IN)
- Corresponding author
- P, Ganesh Kumar
- Venue
- Phase Transitions
- Publisher
- Informa UK Limited
- Published
- 2017-09-06
- Volume
- 91
- Issue
- 3
- Pages
- 254-270
- ISSN
- 0141-1594 (ISSN-L)
- 1029-0338
- OpenAlex
- W2751214111
- Cited by
- 53
- References
- 29
- Citations by year
- 2026: 6 · 2025: 4 · 2024: 10 · 2023: 5 · 2022: 7 · 2021: 7 · 2020: 4 · 2019: 6 · 2018: 4
- FWCI
- 2.98
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- Phase Transitions (publishedVersion)
- Topics
- Physical Sciences › Engineering › Mechanical Engineering › Phase Change Materials Research
- Physical Sciences › Chemical Engineering › Filtration and Separation › Freezing and Crystallization Processes
- Physical Sciences › Chemical Engineering › Fluid Flow and Transfer Processes › Nanofluid Flow and Heat Transfer
- Keywords
- nanoparticle-enhanced phase change materials, multi-walled carbon nanotubes, alkanes, latent heat, melting and solidification, thermal energy storage, nanoparticle concentration
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Thermal energy storage behaviour of nanoparticle enhanced PCM during freezing and melting. https://app.cochat.ai/papers/10.1080/01411594.2017.1372760
- The paper
- P, M., P, G. K., V, K., M, M., K, M. M., & R, V. (2018). Thermal energy storage behaviour of nanoparticle enhanced PCM during freezing and melting. Phase Transitions. https://doi.org/10.1080/01411594.2017.1372760
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.