The DOI matches its Crossref record; 5 of the 5 references it cites were found in a registry or an index.
A study of ternary Cu2SnS3 and Cu3SnS4 thin films prepared by sulfurizing stacked metal precursors
Open accessAbstract
Thin films of Cu 2 SnS 3 and Cu 3 SnS 4 were grown by sulfurization of dc magnetron sputtered Sn–Cu metallic precursors in a S 2 atmosphere. Different maximum sulfurization temperatures were tested which allowed the study of the Cu 2 SnS 3 phase changes. For a temperature of 350 °C the films were composed of tetragonal (I-42 m) Cu 2 SnS 3. The films sulfurized at a maximum temperature of 400 °C presented a cubic (F-43 m) Cu 2 SnS 3 phase. On increasing the temperature up to 520 °C, the Sn content of the layer decreased and orthorhombic (Pmn 21) Cu 3 SnS 4 was formed. The phase identification and structural analysis were performed using x-ray diffraction (XRD) and electron backscattered diffraction (EBSD) analysis. Raman scattering analysis was also performed and a comparison with XRD and EBSD data allowed the assignment of peaks at 336 and 351 cm−1 for tetragonal Cu 2 SnS 3, 303 and 355 cm−1 for cubic Cu 2 SnS 3, and 318, 348 and 295 cm−1 for the Cu 3 SnS 4 phase. Compositional analysis was done using energy dispersive spectroscopy and induced coupled plasma analysis. Scanning electron microscopy was used to study the morphology of the layers. Transmittance and reflectance measurements permitted the estimation of absorbance and band gap. These ternary compounds present a high absorbance value close to 10 4 cm−1. The estimated band gap energy was 1.35 eV for tetragonal (I-42 m) Cu 2 SnS 3, 0.96 eV for cubic (F-43 m) Cu 2 SnS 3 and 1.60 eV for orthorhombic (Pmn 21) Cu 3 SnS 4. A hot point probe was used for the determination of semiconductor conductivity type. The results show that all the samples are p-type semiconductors. A four-point probe was used to obtain the resistivity of these samples. The resistivities for tetragonal Cu 2 SnS 3, cubic Cu 2 SnS 3 and orthorhombic (Pmn 21) Cu 3 SnS 4 are 4.59 × 10−2 Ω cm, 1.26 × 10−2 Ω cm, 7.40 × 10−4 Ω cm, respectively.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
19·9%‐efficient ZnO/CdS/CuInGaSe2 solar cell with 81·2% fill factor
Repins, I., Contreras, M. A., Egaas, B., DeHart, C., Scharf, J., Perkins, C. L., To, B., & Noufi, R. (2008) · Progress in Photovoltaics: Research and Applications · doi:10.1002/pip.822 · Cited by 2,022
Optical processes in semiconductors
Pánkové, J. I. (1975) · CERN Document Server (European Organization for Nuclear Research) · Cited by 1,596
Katagiri, H., Jimbo, K., Yamada, S., Kamimura, T., Maw, W. S., Fukano, T., Ito, T., & Motohiro, T. (2008) · Applied Physics Express · doi:10.1143/apex.1.041201 · Cited by 807
Krill, C. E., & Birringer, R. (1998) · Philosophical magazine. A/Philosophical magazine. A. Physics of condensed matter. Structure, defects and mechanical properties · doi:10.1080/01418619808224072 · Cited by 462
Copper sulphide (CuxS) as an ammonia gas sensor working at room temperature
Sagade, A. A., & Sharma, R. (2008) · Sensors and Actuators B: Chemical · doi:10.1016/j.snb.2008.02.015 · Cited by 276
Cited by
The Rebound Effect and Energy Efficiency Policy
Gillingham, K., Rapson, D., & Wagner, G. (2016) · Review of Environmental Economics and Policy · doi:10.1093/reep/rev017 · Cited by 672
Metadata
- Authors
- Fernandes, P. A., Salomé, P. M. P., & Cunha, A. F. D.
- Venue
- Journal of Physics D: Applied Physics
- Publisher
- IOP Publishing
- Published
- 2010-05-13
- Volume
- 43
- Issue
- 21
- Pages
- 215403
- ISSN
- 0022-3727 (ISSN-L)
- 1361-6463
- OpenAlex
- W1980645145
- Cited by
- 481
- References
- 5
- FWCI
- 16.94
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A study of ternary Cu2SnS3 and Cu3SnS4 thin films prepared by sulfurizing stacked metal precursors. https://app.cochat.ai/papers/10.1088/0022-3727/43/21/215403
- The paper
- Fernandes, P. A., Salomé, P. M. P., & Cunha, A. F. D. (2010). A study of ternary Cu2SnS3 and Cu3SnS4 thin films prepared by sulfurizing stacked metal precursors. Journal of Physics D: Applied Physics. https://doi.org/10.1088/0022-3727/43/21/215403
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.