The DOI matches its Crossref record; 17 of the 17 references it cites were found in a registry or an index.
Hollow cathode modeling: II. Physical analysis and parametric study
Open accessAbstract
A numerical emissive hollow cathode model which couples plasma and thermal aspects of the NASA NSTAR cathode has been presented in a companion paper and simulation results obtained using the plasma model were compared to experimental data. We now compare simulation results with measurements using the full coupled model. Inside the cathode, the simulated plasma density profile agrees with the experimental data up to the ±50% experimental uncertainty while the simulated emitter temperature differs from measurements by at most 5 K. We then proceed to an analysis of the cathode discharge both inside the cathode where electron emission is dominant and outside in the near plume where electron transport instabilities are important. As observed previously in the literature, the total emitted electron current is much larger ( 34 A ) than the set discharge current collected at the anode ( 13 A ) while ionization plays a negligible role. Extracted electrons are emitted from a region much shorter than the full emitter ( 0.9 cm versus 2.5 cm ). The influence of an applied axial magnetic field in the plume is also assessed and we observe that it leads to a 10-fold increase of the plasma density 1 cm downstream of the orifice entrance while the simulated discharge potential at the anode is increased from 10 V up to 35.5 V . Lastly, we perform a parametric study on both the operating point (discharge current, mass flow rate) and design (inner radius) of the cathode. The simulated useful operating envelope is shown to be limited at low discharge current mostly because of the probable ion sputtering of the emitter and at high discharge current because of emitter evaporation, plasma oscillations and sputtering of the keeper electrode. The behavior of the cathode is also analyzed w.r.t. its internal radius and simulation results show that the useful emitter length scales linearly with the cathode radius.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Joule heating in the insert region is negligible due to the large diameter and low current density [27, 28].”
From Computational modelling of water-fuelled Hall Effect Thrusters (2025) · cites this paper as [28]
Citations
Cites
Fundamentals of Electric Propulsion: Ion and Hall Thrusters
Goebel, D. M., & Katz, I. (2008) · doi:10.1002/9780470436448 · Cited by 1,351
Taylor, J. B. (1970) · Physics Bulletin · doi:10.1088/0031-9112/21/5/019 · Cited by 920
Anomalous transport in high-temperature plasmas with applications to solenoidal fusion systems
Davidson, R. C., & Krall, N. A. (1977) · Nuclear Fusion · doi:10.1088/0029-5515/17/6/017 · Cited by 242
Potential fluctuations and energetic ion production in hollow cathode discharges
Goebel, D. M., Jameson, K. K., Katz, I. M., & Mikellides, I. G. (2007) · Physics of Plasmas · doi:10.1063/1.2784460 · Cited by 163 · cited 9×
“However, it is generally associated in the literature with an ionization instability of the plume rather than with a ion acoustic instability induced mode [2].”
BackgroundResultInfluentialHollow cathode theory and experiment. II. A two-dimensional theoretical model of the emitter region
Mikellides, I. G., Katz, I., Goebel, D. M., & Polk, J. E. (2005) · Journal of Applied Physics · doi:10.1063/1.2135409 · Cited by 162 · cited 3×
“Even in absence of magnetic field, some qualitative differences between simulation results and experimental data remained and it was shown in the early cathode modeling literature [3, 4] that accounting for the excitation of ion acoustic instabilities in the orifice and in the plume (through an anomalous collision fre…”
MethodResultLaB6 Hollow Cathodes for Ion and Hall Thrusters
Goebel, D. M., Watkins, R. M., & Jameson, K. K. (2007) · Journal of Propulsion and Power · doi:10.2514/1.25475 · Cited by 148 · cited 2×
“We have seen that the thermionic emission current density is one of the key characteristics which partly determine the expected lifetime of the cathode, since the evaporation rate of the emitter increases with the emission current density [17].”
BackgroundIon acoustic turbulence in a 100-A LaB 6 hollow cathode
Jorns, B., Mikellides, I. G., & Goebel, D. M. (2014) · Physical Review E · doi:10.1103/physreve.90.063106 · Cited by 118 · cited 1×
“Definitive evidence for these instabilities was provided much later by Jorns et al [5] who demonstrated experimentally the occurrence of ion acoustic instabilities in the plume of high-current hollow cathodes.”
BackgroundWear Mechanisms in Electron Sources for Ion Propulsion, II: Discharge Hollow Cathode
Mikellides, I. G., Katz, I. M., Goebel, D. M., Jameson, K. K., & Polk, J. E. (2008) · Journal of Propulsion and Power · doi:10.2514/1.33462 · Cited by 116 · cited 4×
“magnetic field topology in some cathode numerical models published in the literature though [3].”
BackgroundMethodResultInfluentialWear Mechanisms in Electron Sources for Ion Propulsion, I: Neutralizer Hollow Cathode
Mikellides, I. G., & Katz, I. M. (2008) · Journal of Propulsion and Power · doi:10.2514/1.33461 · Cited by 100
Hollow cathode modeling: I. A coupled plasma thermal two-dimensional model
Sary, G., Garrigues, L., & Bœuf, J.-P. (2017) · Plasma Sources Science and Technology · doi:10.1088/1361-6595/aa6217 · Cited by 80 · cited 10×
“The plasma density profile simulated in our companion paper [1] for a set emitter”
BackgroundMethodInfluentialSelf-citation
Cited by
Perspectives, frontiers, and new horizons for plasma-based space electric propulsion
Levchenko, I., Xu, S., Mazouffre, S., Lev, D., Pedrini, D., Goebel, D., Garrigues, L., Taccogna, F., & Bazaka, K. (2020) · Physics of Plasmas · doi:10.1063/1.5109141 · Cited by 228
Self-citationRecent progress in research and development of hollow cathodes for electric propulsion
Lev, D. R., Mikellides, I. G., Pedrini, D., Goebel, D. M., Jorns, B., & McDonald, M. (2019) · Reviews of Modern Plasma Physics · doi:10.1007/s41614-019-0026-0 · Cited by 124
An overview of discharge plasma modeling for Hall effect thrusters
Hara, K. (2019) · Plasma Sources Science and Technology · doi:10.1088/1361-6595/ab0f70 · Cited by 120
Goebel, D. M., Becatti, G., Mikellides, I. G., & Lopez Ortega, A. (2021) · Journal of Applied Physics · doi:10.1063/5.0051228 · Cited by 95
Hollow cathode modeling: I. A coupled plasma thermal two-dimensional model
Sary, G., Garrigues, L., & Bœuf, J.-P. (2017) · Plasma Sources Science and Technology · doi:10.1088/1361-6595/aa6217 · Cited by 80
Self-citation
Metadata
- Authors
- Sary, G., Garrigues, L., & Boeuf, J.-P.
- Affiliations
- Centre National de la Recherche Scientifique (FR)
- Université de Toulouse
- Corresponding author
- Sary, Gaétan
- Venue
- Plasma Sources Science and Technology
- Publisher
- IOP Publishing
- Published
- 2017-03-31
- Volume
- 26
- Issue
- 5
- Pages
- 055008
- ISSN
- 0963-0252 (ISSN-L)
- 1361-6595
- OpenAlex
- W2590730080
- Cited by
- 57
- References
- 17
- Citations by year
- 2026: 5 · 2025: 2 · 2024: 7 · 2023: 8 · 2022: 7 · 2021: 6 · 2020: 10 · 2019: 8 · 2018: 1 · 2017: 3
- FWCI
- 2.50
- Type
- journal article
- Language
- en
- Open access
- green
- hal.science
- Licence
- other-oa
- publishingsupport.iopscience.iop.org/iop-standard/v1 (vor)
- iopscience.iop.org/info/page/text-and-data-mining (tdm)
- Locations
- Plasma Sources Science and Technology (publishedVersion)
- HAL (submittedVersion, other-oa)
- Funders
- Centre National d Etudes Spatiales (CNES-Snecma Ph.D. grant)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Low-Pressure Plasma Processing and Diagnostics
- Physical Sciences › Physics and Astronomy › Atomic and Molecular Physics, and Optics › Vacuum and Plasma Arcs
- Physical Sciences › Physics and Astronomy › Atomic and Molecular Physics, and Optics › Gyrotron and Vacuum Electronics Research
- Keywords
- hollow cathode, NSTAR, electron emission, plasma density profile, emitter temperature, axial magnetic field, discharge potential, plasma oscillations, cathode design, parametric study
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Hollow cathode modeling: II. Physical analysis and parametric study. https://app.cochat.ai/papers/10.1088/1361-6595/aa6210
- The paper
- Sary, G., Garrigues, L., & Boeuf, J.-P. (2017). Hollow cathode modeling: II. Physical analysis and parametric study. Plasma Sources Science and Technology. https://doi.org/10.1088/1361-6595/aa6210
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.