CoChat

Plasma processes inside dispenser hollow cathodes

The DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.

Abstract

A two-dimensional fluid model of the plasma and neutral gas inside dispenser orificed hollow cathodes has been developed to quantify plasma processes that ultimately determine the life of the porous emitters inserted in these devices. The model self-consistently accounts for electron emission from the insert as well as for electron and ion flux losses from the plasma. Two cathodes, which are distinctively different in size and operating conditions, have been simulated numerically. It is found that the larger cathode, with outer tube diameter of 1.5cm and orifice diameter of 0.3cm, establishes an effective emission zone that spans approximately the full length of the emitter when operated at a discharge current of 25A and a flow rate of 5.5sccm. The net heating of the emitter is caused by ions that are produced by ionization of the neutral gas inside the tube and are then accelerated by the sheath along the emitter. The smaller cathode, with an outer diameter of 0.635cm and an orifice diameter of 0.1cm, does not exhibit the same operational characteristics. At a flow rate of 4.25sccm and discharge current of 12A, the smaller cathode requires 4.5 times the current density near the orifice and operates with more than 6 times the neutral particle density compared to the large cathode. As a result, the plasma particle density is almost one order of magnitude higher compared to the large cathode. The plasma density in this small cathode is high enough such that the Debye length is sufficiently small to allow “sheath funneling” into the pores of the emitter. By accessing areas deeper into the insert material, it is postulated that the overall emission of electrons is significantly enhanced. The maximum emission current density is found to be about 1A∕mm2 in the small cathode, which is about one order of magnitude higher than attained in the large cathode. The effective emission zone in the small cathode extends to about 15% of the emitter length only, and the power deposited at the emitter surface by returning electrons is found to be twice that deposited by ions. A previous study suggested that the computed particle flux and energy of ions to the emitter of the 1.5cm cathode were not high enough to change the barium evaporation rate compared to thermally induced evaporation. The same suggestion is made here for the 0.635cm cathode. The peak ion flux to the emitter is found to be 1.2A∕cm2 (7.6×1018∕scm2), and the corresponding peak sheath drop is 2.9V. Consequently, once the emitter operating temperature is known it is possible to determine directly the barium depletion-limited life of these cathodes using existing vacuum-cathode data.

Overview

Integrity signals

Registry

Crossref · 10.1063/1.2208292

Cites

8 of 8 references verified0 citation errors · 0 not checkable

Statistics

Recomputing p-values needs the paper’s full text.

Verification

Claims the paper makes

This paper’s full text isn’t openly available, so its claims and self-check weren’t run. The registry and citation checks still apply.

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Citations

Cites

Show all 8 references

Research works printed but not linked: 17

  1. 2003, 39th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  2. 2003, 39th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  3. 1978, 13th AIAA/DGLR International Electric Propulsion Conference
  4. 2004, 40th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  5. 2005, 41st AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  6. 2004, 40th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  7. 2002, 38th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  8. 2002, 38th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  9. 1997, 33rd AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  10. 2004, 40th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  11. A. Salhi, Ph.D. thesis, The Ohio State University, 1993.
  12. 1992, 28th SAE/ASME/ASEE, Joint Propulsion Conference and Exhibit
  13. 2003, 33rd AIAA Fluid Dynamics Conference and Exhibit
  14. 2003, Proceedings of 28th International Electric Propulsion Conference
  15. 2005, 41st AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  16. 2004, 40th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit
  17. 2004, 40th AIAA/ASME/SAE/ASEE Joint Propulsion Conference and Exhibit

Cited by

See all 46

Metadata

Authors
Mikellides, I. G., Katz, I., Goebel, D. M., Polk, J. E., & Jameson, K. K.
Affiliations
California Institute of Technology (US)
Venue
Physics of Plasmas
Published
2006-06-01
Volume
13
Issue
6
ISSN
  • 1070-664X (ISSN-L)
  • 1089-7674
OpenAlex
W2048362983
Cited by
46
References
8
Citations by year
2025: 4 · 2024: 2 · 2022: 1 · 2021: 5 · 2020: 1 · 2019: 3 · 2018: 2 · 2017: 7 · 2016: 1 · 2015: 2 · 2014: 1 · 2013: 2 · 2012: 1
FWCI
4.38
Type
journal article
Language
en
Open access
closed
Locations
Physics of Plasmas (publishedVersion)
Funders
National Aeronautics and Space Administration
Topics
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Low-Pressure Plasma Processing and Diagnostics
  • Physical Sciences › Physics and Astronomy › Atomic and Molecular Physics, and Optics › Vacuum and Plasma Arcs
  • Physical Sciences › Physics and Astronomy › Atomic and Molecular Physics, and Optics › Gyrotron and Vacuum Electronics Research
Keywords
electron emission, Debye length, barium evaporation, two-dimensional hydrodynamic model, plasma density, electric thrusters, discharge current density

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Plasma processes inside dispenser hollow cathodes. https://app.cochat.ai/papers/10.1063/1.2208292
The paper
Mikellides, I. G., Katz, I., Goebel, D. M., Polk, J. E., & Jameson, K. K. (2006). Plasma processes inside dispenser hollow cathodes. Physics of Plasmas. https://doi.org/10.1063/1.2208292

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.