CoChat

Development of Hardware-in-the-Loop Simulation for CubeSat Platform: Focusing on Magnetometer and Magnetorquer

Open access

The DOI matches its Crossref record; 59 of the 64 references it cites were found in a registry or an index.

Abstract

This study is aimed at addressing the practical challenges of conducting hardware-in-the-loop simulation (HILS) for a CubeSat attitude determination and control system (ADCS) with a magnetometer and magnetorquer. The inherent problem of magnetometer time-varying bias is typically addressed using compensation methods. Because compensation is performed in orbit, the application of such methods to HILS is difficult. In addition, the magnetorquer has limited applicability to HILS if only magnetorquers without reaction wheels or control moment gyroscopes are used. In general, HILS for CubeSat uses air bearing; however, it cannot be applied to a solely magnetorquer-based ADCS owing to the inertial moments and center of gravity effects induced by the air bearing table. To overcome these challenges, in this study, the magnetometer reliability is enhanced by compensating for temperature, current, and iron effects, which are modeled experimentally, in the pre-launch stage. Then, a novel single axis-based HILS for CubeSats is developed to minimize the disturbances by the ground environment. The torque limit of the magnetorquer is supplemented through a magnetic field generated by a Helmholtz cage. The proposed HILS environment is mathematically modeled to simulate the performance of the CubeSat ADCS, and its reliability is ensured by comparing the simulation with real-time experimental results. To validate the usefulness of the proposed HILS, it is applied to an ADCS based on a low-cost sensor fusion extended-Kalman filter and a linear quadratic regulator controller commonly used in CubeSats. The simulation and experimental results are well matched, demonstrating the potential of the proposed framework.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1109/access.2023.3294565

Cites

59 of 59 references verified0 citation errors · 0 not checkable

Statistics

Figures

Image 1
CC-BY-NC-ND · From the PDF
Image 2
CC-BY-NC-ND · From the PDF
Image 3
CC-BY-NC-ND · From the PDF
Image 4
CC-BY-NC-ND · From the PDF
Image 5
CC-BY-NC-ND · From the PDF
Image 6
CC-BY-NC-ND · From the PDF
Image 7
CC-BY-NC-ND · From the PDF
Image 8
CC-BY-NC-ND · From the PDF
Image 9
CC-BY-NC-ND · From the PDF
Image 10
CC-BY-NC-ND · From the PDF
FIGURE 6 Overall block diagram of ADCS.
FIGURE 6 Overall block diagram of ADCS.CC-BY-NC-ND · From the PDF
Image 12
CC-BY-NC-ND · From the PDF
FIGURE 7 Coordinate system used in SNUGLITE-I CubeSat ADCS.
FIGURE 7 Coordinate system used in SNUGLITE-I CubeSat ADCS.CC-BY-NC-ND · From the PDF
FIGURE 8 Proposed HILS environment system configuration
FIGURE 8 Proposed HILS environment system configurationCC-BY-NC-ND · From the PDF
Image 15
CC-BY-NC-ND · From the PDF
FIGURE 9 Single-axis HILS environment for verification of ADCS. The CubeSat is hung on a string and generates a magnetic field from a Helmholtz cage. Sunlight is simulated by a halogen lamp.
FIGURE 9 Single-axis HILS environment for verification of ADCS. The CubeSat is hung on a string and generates a magnetic field from a Helmholtz cage. Sunlight is simulated by a halogen lamp.CC-BY-NC-ND · From the PDF
Image 17
CC-BY-NC-ND · From the PDF
FIGURE 10 HILS environment built using SNUGLITE-I EM.
FIGURE 10 HILS environment built using SNUGLITE-I EM.CC-BY-NC-ND · From the PDF
Image 19
CC-BY-NC-ND · From the PDF
Image 20
CC-BY-NC-ND · From the PDF

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 59 references

Research works printed but not linked: 3

  1. soken, 2020, Attitude-independent magnetometer calibration for spinning spacecraft using quasi-measurements, Proc AAS/AIAA Astrodyn Spec Conf
  2. lee, 2016, Development of CubeSat attitude determination and control system with a hybrid control strategy and its simulator on SO(3), Proc 26th AAS/AIAA Spaceflight Mech Meeting
  3. goecks, 2016, Low cost spacecraft attitude determination for CubeSat type missions, Proc AAS Guid Control Conf

Cited by

See all 9

Metadata

Authors
Shim, H., Kim, O.-J., Park, M., Choi, M., & Kee, C.
Affiliations
  • Seoul National University (KR)
  • Sejong University (KR)
  • GNSS Research and Development Center, Danam Systems Inc., Anyang, South Korea
  • Samsung (South Korea) (KR)
Venue
IEEE Access
Published
2023
Volume
11
Pages
73164-73179
ISSN
2169-3536 (ISSN-L)
OpenAlex
W4384080068
Cited by
9
References
64
Citations by year
2026: 1 · 2025: 3 · 2024: 5
FWCI
1.10
Type
journal article
Language
en
Open access
Locations
  • IEEE Access (publishedVersion, cc-by-nc-nd)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
Funders
  • Future Space Navigation & Satellite Research Center through the National Research Foundation funded by the Ministry of Science and ICT, the Republic of Korea (2022M1A3C2074404)
  • Institute of Advanced Aerospace Technology at Seoul National University
  • The Institute of Engineering Research at Seoul National University provided research facilities for this work
Topics
  • Physical Sciences › Engineering › Aerospace Engineering › Spacecraft Design and Technology
  • Physical Sciences › Engineering › Aerospace Engineering › Spacecraft Dynamics and Control
  • Physical Sciences › Engineering › Aerospace Engineering › Space Satellite Systems and Control
Keywords
hardware-in-the-loop, CubeSat, attitude determination and control, magnetometer, magnetorquers, Helmholtz coil, extended Kalman filter, linear quadratic regulator, low-cost sensor fusion

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Development of Hardware-in-the-Loop Simulation for CubeSat Platform: Focusing on Magnetometer and Magnetorquer. https://app.cochat.ai/papers/10.1109/access.2023.3294565
The paper
Shim, H., Kim, O.-J., Park, M., Choi, M., & Kee, C. (2023). Development of Hardware-in-the-Loop Simulation for CubeSat Platform: Focusing on Magnetometer and Magnetorquer. IEEE Access. https://doi.org/10.1109/access.2023.3294565

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.