A Comparative Study of the Electrical Characteristics of Piezoelectric and Triboelectric Nanogenerators for Energy-Harvesting Floor Tiles
The DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.
Abstract
Piezoelectric and Triboelectric nanogenerators (PENG and TENG) have gained significant attention for use in self-powered electronics and sensing systems. They also have high potential to harvest energy from low-frequency vibration sources in the ambient environment. This paper investigated the performance and behavior of the two aforementioned nanogenerators based on energy-harvesting floor tiles by using a test bench to demonstrate the electrical characteristics output and comparing their power density output, energy density output, and other properties for characterization and scale-up in practical applications. The input used in the experiment varied the gap distance of the cover plate for the test bench with constant pneumatic pressure to excite the cover plate. The experimental results showed that the power density and energy density of PENG were higher than those of the TENG. The power density and energy density measured in 10 s under 2 Hz of input excitation of PENG and TENG at the gap width of 5 mm were 5773.35 μW/cm3, 1376.26 μJ/cm3and 752.34 μW/cm3, 31.32 μJ/cm3, respectively. Due to their high output density, they enable promising possibilities to power small consumption electronics and sensing systems.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“The power density of the piezoelectric harvester was found to be 5773.35 μ W/cm 3 as compared to 752.34 μ W/cm 3 of the triboelectric harvester.”
From A review of piezoelectric energy harvesting tiles: Available designs and future perspective (2022) · cites this paper as [68]
Citations
Cites
Triboelectric Nanogenerator: A Foundation of the Energy for the New Era
Wu, C., Wang, A. C., Ding, W., Guo, H., & Wang, Z. L. (2019) · Advanced Energy Materials · doi:10.1002/aenm.201802906 · Cited by 1,996 · cited 2×
“For example, the piezoelectric effect converts mechanical to electrical charge by deformation, while the triboelectric effect generates electrical charge through friction or temporary contact [3], [8].”
BackgroundMethodPiezoelectric and triboelectric nanogenerators: Trends and impacts
Askari, H., Khajepour, A., Khamesee, M. B., Saadatnia, Z., & Wang, Z. L. (2018) · Nano Today · doi:10.1016/j.nantod.2018.08.001 · Cited by 173 · cited 2×
“PENG and TENG have been researched significantly since 2006 and 2012, respectively [2].”
BackgroundLi, Z., Saadatnia, Z., Yang, Z., & Naguib, H. E. (2018) · Energy Conversion and Management · doi:10.1016/j.enconman.2018.08.018 · Cited by 149
An Automatic Test Bench for Complete Characterization of Vibration-Energy Harvesters
Ruan, J., Lockhart, R. A., Janphuang, P., Quintero, A. V., Briand, D., & de Rooij, N. (2013) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2013.2265452 · Cited by 30 · cited 1×
“Moreover, there are four different modes of TENG, including vertical contactseparation (CS) mode, lateral-sliding (LS) mode, singleelectrode (SE) mode, and freestanding triboelectric-layer (FT) mode [5-7].”
BackgroundSelf-citationDesign and Evaluation of Double-Stage Energy Harvesting Floor Tile
Isarakorn, D., Jayasvasti, S., Panthongsy, P., Janphuang, P., & Hamamoto, K. (2019) · Sustainability · doi:10.3390/su11205582 · Cited by 27 · cited 6×
“The structure of the PPA-2011 cantilever is assembled from two active PZT-5H layers and three FR4 elastic layers with a high-performance, aerospace-grade structure epoxy possessing excellent adhesion, which provides robustness, extended durability, and high output power [3].”
BackgroundMethodSelf-citationPerformance and Behavior Analysis of Piezoelectric Energy Harvesting Floor Tiles
Panthongsy, P., Isarakorn, D., Hamamoto, K., & Janphuang, P. (2019) · 2019 5th International Conference on Engineering, Applied Sciences and Technology (ICEAST) · doi:10.1109/iceast.2019.8802555 · Cited by 11
Self-citationUltra low cost triboelectric energy harvesting solutions for embedded sensor systems
Bertacchini, A., Larcher, L., Lasagni, M., & Pavan, P. (2015) · IEEE International Conference on Nanotechnology (IEEE-NANO) · doi:10.1109/nano.2015.7388828 · Cited by 10
A Test Bench for Characterization of Piezoelectric Frequency Up-Converting Energy Harvesters
Panthongsy, P., Isarakorn, D., & Hamamoto, K. (2018) · International Conference on Electrical Engineering/Electronics, Computer, Telecommunications and Information Technology (ECTI-CON) · doi:10.1109/ecticon.2018.8619914 · Cited by 6 · cited 4×
“A function generator (GW INSTEK AFG-2225) is used to simulate the velocity and frequency of human walking at an average value of 2 Hz [4].”
BackgroundMethodSelf-citation
Cited by
A review of piezoelectric energy harvesting tiles: Available designs and future perspective
Sharma, S., Kiran, R., Azad, P., & Vaish, R. (2022) · Energy Conversion and Management · doi:10.1016/j.enconman.2022.115272 · Cited by 194
An electromagnetic energy harvester for applications in a high-speed rail pavement system
Cao, H., Kong, L., Tang, M., Zhang, Z., Wu, X., Lu, L., & Li, D. (2022) · International Journal of Mechanical Sciences · doi:10.1016/j.ijmecsci.2022.108018 · Cited by 75
The Advances in Conversion Techniques in Triboelectric Energy Harvesting: A Review
Peng, W., & Du, S. (2023) · IEEE Transactions on Circuits and Systems I Regular Papers · doi:10.1109/tcsi.2023.3261780 · Cited by 56
Technique for Measuring Power across High Resistive Load of Triboelectric Energy Harvester
Jayasvasti, S., Thainiramit, P., Yingyong, P., & Isarakorn, D. (2021) · Micromachines · doi:10.3390/mi12070766 · Cited by 7
Self-citationEnergy-harvesting tile incorporating an origami coupling mechanism
Khazaaleh, S., Dalaq, A. S., & Daqaq, M. F. (2024) · Philosophical Transactions of the Royal Society A Mathematical Physical and Engineering Sciences · doi:10.1098/rsta.2024.0015 · Cited by 8
“Such devices can be separated into three groups: inserts within wearables [14], energy-harvesting tiles [13,15,16] and textiles [17].”
Metadata
- Authors
- Yingyong, P., Thainiramit, P., Nundrakwang, S., Janphuang, P., & Isarakorn, D.
- Affiliations
- King Mongkut's Institute of Technology Ladkrabang (TH)
- Synchrotron Light Research Institute (TH)
- Venue
- 2020 17th International Conference on Electrical Engineering/Electronics, Computer, Telecommunications and Information Technology (ECTI-CON)
- Publisher
- IEEE
- Published
- 2020-06
- Pages
- 9-12
- OpenAlex
- W3047168131
- Semantic Scholar
- 2a2c9fa13f4b1ae873fd91de53402d8f33240c2d
- Cited by
- 5
- References
- 8
- Citations by year
- 2024: 1 · 2023: 1 · 2022: 2 · 2021: 1
- FWCI
- 1.81
- Type
- conference paper
- Language
- en
- Open access
- closed
- Locations
- International Conference on Electrical Engineering/Electronics, Computer, Telecommunications and Information Technology (ECTI-CON) (publishedVersion)
- Topics
- Physical Sciences › Engineering › Biomedical Engineering › Advanced Sensor and Energy Harvesting Materials
- Physical Sciences › Engineering › Mechanical Engineering › Innovative Energy Harvesting Technologies
- Physical Sciences › Materials Science › Materials Chemistry › Ferroelectric and Piezoelectric Materials
- Keywords
- piezoelectric nanogenerators, triboelectric nanogenerator, energy harvesting, floor tiles, vibration energy harvesting, power density, energy density, self-powered devices, gap distance
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A Comparative Study of the Electrical Characteristics of Piezoelectric and Triboelectric Nanogenerators for Energy-Harvesting Floor Tiles. https://app.cochat.ai/papers/10.1109/ecti-con49241.2020.9158263
- The paper
- Yingyong, P., Thainiramit, P., Nundrakwang, S., Janphuang, P., & Isarakorn, D. (2020). A Comparative Study of the Electrical Characteristics of Piezoelectric and Triboelectric Nanogenerators for Energy-Harvesting Floor Tiles. 2020 17th International Conference on Electrical Engineering/Electronics, Computer, Telecommunications and Information Technology (ECTI-CON). https://doi.org/10.1109/ecti-con49241.2020.9158263
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.