A Fully-Integrated 71 nW CMOS Temperature Sensor for Low Power Wireless Sensor Nodes
The DOI matches its Crossref record; 14 of the 14 references it cites were found in a registry or an index.
Abstract
We propose a fully-integrated temperature sensor for battery-operated, ultra-low power microsystems. Sensor operation is based on temperature independent/dependent current sources that are used with oscillators and counters to generate a digital temperature code. A conventional approach to generate these currents is to drop a temperature sensitive voltage across a resistor. Since a large resistance is required to achieve nWs of power consumption with typical voltage levels (100 s of mV to 1 V), we introduce a new sensing element that outputs only 75 mV to save both power and area. The sensor is implemented in 0.18 μm CMOS and occupies 0.09 mm2while consuming 71 nW. After 2-point calibration, an inaccuracy of + 1.5°C/-1.4°C is achieved across 0 °C to 100 °C. With a conversion time of 30 ms, 0.3 °C (rms) resolution is achieved. The sensor does not require any external references and consumes 2.2 nJ per conversion. The sensor is integrated into a wireless sensor node to demonstrate its operation at a system level.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
CMOS VLSI Design : A Circuits and Systems Perspective
Weste, N. H. E., & Harris, D. M. (2004) · Cited by 2,417
A Portable 2-Transistor Picowatt Temperature-Compensated Voltage Reference Operating at 0.5 V
Seok, M., Kim, G., Blaauw, D., & Sylvester, D. (2012) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2012.2206683 · Cited by 459 · cited 1×
“Therefore, generating a small current with well-defined temperature dependency is crucial to designing a low-power temperature sensor.”
BackgroundSelf-citationPertijs, M. A. P., Niederkorn, A., Ma, X., McKillop, B., Bakker, A., & Huijsing, J. H. (2005) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2004.841013 · Cited by 367
Pertijs, M. A. P., Makinwa, K. A. A., & Huijsing, J. H. (2005) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2005.858476 · Cited by 360
Full Passive UHF Tag With a Temperature Sensor Suitable for Human Body Temperature Monitoring
Vaz, A., Ubarretxena, A., Zalbide, I., Pardo, D., Solar, H., Garcia-Alonso, A., & Berenguer, R. (2010) · IEEE Transactions on Circuits and Systems II: Express Briefs · doi:10.1109/tcsii.2010.2040314 · Cited by 242 · cited 1×
“For low power operation, time-to-digital [10], [11] or frequency-to-digital conversion [12], [13] is used instead of ADCs.”
MethodSouri, K., Chae, Y., & Makinwa, K. A. A. (2013) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2012.2214831 · Cited by 232
Lee, Y., Bang, S., Lee, I., Kim, Y., Kim, G., Ghaed, M. H., Pannuto, P., Dutta, P., Sylvester, D., & Blaauw, D. (2013) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2012.2221233 · Cited by 210 · cited 1×
“These systems can be used in a wide range of application areas such as medical, surveillance, and environmental monitoring by equipping them with the appropriate sensors [1]–[3].”
BackgroundSelf-citationA Sub-$\mu$W Embedded CMOS Temperature Sensor for RFID Food Monitoring Application
Law, M. K., Bermak, A., & Luong, H. C. (2010) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2010.2047456 · Cited by 203 · cited 1×
“For low power operation, time-to-digital [10], [11] or frequency-to-digital conversion [12], [13] is used instead of ADCs.”
MethodAn ultra low power 1V, 220nW temperature sensor for passive wireless applications
Lin, Y.-S., Sylvester, D., & Blaauw, D. (2008) · Custom Integrated Circuits Conference · doi:10.1109/cicc.2008.4672133 · Cited by 125 · cited 1×
“On the other hand, a temperature sensor that uses an on-chip time reference while consuming sub- W has been reported [14].”
BackgroundSelf-citationSebastiano, F., Breems, L. J., Makinwa, K. A. A., Drago, S., Leenaerts, D. M. W., & Nauta, B. (2010) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2010.2076610 · Cited by 107
Sebastiano, F., Breems, L. J., Makinwa, K. A. A., Drago, S., Leenaerts, D. M. W., & Nauta, B. (2010) · Digest of technical papers/Digest of technical papers - IEEE International Solid-State Circuits Conference · doi:10.1109/isscc.2010.5433895 · Cited by 89 · cited 1×
“The ratio between the PTAT and reference voltages is fed to an analog-to-digital converter (ADC) to be digitized.”
BackgroundA 405-nW CMOS Temperature Sensor Based on Linear MOS Operation
Law, M. K., & Bermak, A. (2009) · IEEE Transactions on Circuits & Systems II Express Briefs · doi:10.1109/tcsii.2009.2034201 · Cited by 79 · cited 1×
“For low power operation, time-to-digital [10], [11] or frequency-to-digital conversion [12], [13] is used instead of ADCs.”
MethodMixed-signal integrated circuits for self-contained sub-cubic millimeter biomedical implants
Chow, E. Y., Chakraborty, S., Chappell, W. J., & Irazoqui, P. P. (2010) · 2010 IEEE International Solid-State Circuits Conference - (ISSCC) · doi:10.1109/isscc.2010.5433933 · Cited by 63 · cited 1×
“These systems can be used in a wide range of application areas such as medical, surveillance, and environmental monitoring by equipping them with the appropriate sensors [1]–[3].”
BackgroundA hybrid DC-DC converter for sub-microwatt sub-1V implantable applications
Wieckowski, M., Chen, G. K., Seok, M., Blaauw, D. T., & Sylvester, D. (2009) · Symposium on VLSI Circuits · Cited by 52
Self-citation
Cited by
RF power harvesting: a review on designing methodologies and applications
Tran, L.-G., Cha, H.-K., & Park, W.-T. (2017) · Micro and Nano Systems Letters · doi:10.1186/s40486-017-0051-0 · Cited by 293
Wang, H., & Mercier, P. P. (2017) · Scientific Reports · doi:10.1038/s41598-017-04705-6 · Cited by 43
Metadata
- Authors
- Jeong, S., Foo, Z., Lee, Y., Sim, J.-Y., Blaauw, D., & Sylvester, D.
- Venue
- IEEE Journal of Solid-State Circuits
- Published
- 2014-08
- Volume
- 49
- Issue
- 8
- Pages
- 1682-1693
- ISSN
- 0018-9200 (ISSN-L)
- 1558-173X
- OpenAlex
- W2087509188
- Cited by
- 228
- References
- 14
- FWCI
- 8.28
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.