The DOI matches its Crossref record; 20 of the 21 references it cites were found in a registry or an index.
Wideband Receiver for a Three-Dimensional Ranging LADAR System
Abstract
A low-noise, high-gain, wide-linear-dynamic-range, wide-band receiver for a pulsed, direct, three-dimensional ranging LADAR system has been designed and implemented in a 0.13 μm CMOS technology. Specific design techniques, including gain control scheme to widen linear dynamic range, gain allocating between blocks and noise minimization to improve SNR, frequency response compensation to extend bandwidth and ensure system stability, and output voltage swing boosting, have been proposed to achieve challenging design goals with linear dynamic range of 1:1600, equivalent input-referred current noise of less than 5.6 pA/√Hz, high gain of 78 dBΩ, maximum output swing of at least 500 mV, bandwidth of at least 500 MHz, and low sensitivity to temperature variation over the range from -10°C to 60°C, in the presence of 2 pF photodiode parasitic capacitance.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Ref. [21] demonstrated a dual-mode AFE preamplifier which could be configured as a charge-sensitive amplifier (CSA) or as a gated active load-assisted (GALA) TIA, depending upon the intensity of the input current, thereby extending the dynamic range to 96dB.Yet, the bandwidth shrunk down to 98 MHz in CSA mode from 230 MHz in GALA-TIA.Also, the power dissipation was still large owing to the dual”
From A CMOS Optoelectronic Transimpedance Amplifier Using Concurrent Automatic Gain Control for LiDAR Sensors (2024) · cites this paper as [21]
Citations
Cites
Analog integrated circuit design
Hurst, S. L. (1998) · Microelectronics Journal · doi:10.1016/s0026-2692(97)00051-7 · Cited by 1,732
A 4-MHz CMOS continuous-time filter with on-chip automatic tuning
Krummenacher, F., & Joehl, N. (1988) · IEEE Journal of Solid-State Circuits · doi:10.1109/4.315 · Cited by 697 · cited 1×
“The cross-coupled source degeneration technique [17], which is based on the dynamic resistance degeneration principle [18] is used to improve the linearity.”
Method(2003) · Convergence Technologies for 3G Networks · doi:10.1002/0470860936.ch2 · Cited by 243
Buller, G., & Wallace, A. (2007) · IEEE Journal of Selected Topics in Quantum Electronics · doi:10.1109/jstqe.2007.902850 · Cited by 189
A new compact temperature-compensated CMOS current reference
Fiori, F. L., & Crovetti, P. (2005) · IEEE Transactions on Circuits and Systems II Analog and Digital Signal Processing · doi:10.1109/tcsii.2005.852529 · Cited by 127 · cited 1×
“Moreover, temperature-compensated current [19] is used to generate bias voltages to further reduce the sensitivity of WBRx to temperature variation.”
MethodA high-precision time-to-digital converter for pulsed time-of-flight laser radar applications
Maatta, K. E., & Kostamovaara, J. (1998) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/19.744201 · Cited by 118
Nissinen, J., Nissinen, I., & Kostamovaara, J. (2009) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2009.2017006 · Cited by 105 · cited 1×
“Namely, pulse length [4], amplitude [6], slew rate [7], or unipolar-to-bipolar pulse shaping [8] has been used to reduce this error.”
MethodA wide dynamic range receiver channel for a pulsed time-of-flight laser radar
Ruotsalainen, T., Palojärvi, P., & Kostamovaara, J. (2001) · IEEE Journal of Solid-State Circuits · doi:10.1109/4.938373 · Cited by 93 · cited 1×
“In [9], another technique using automatic gain control has been proposed to minimize the error; however, the receiver bandwidth of 170 MHz and dynamic range of 1:624 are not adequate to our purpose.”
MethodPalojärvi, P., Ruotsalainen, T., & Kostamovaara, J. (2005) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2005.848022 · Cited by 78 · cited 2×
“Namely, pulse length [4], amplitude [6], slew rate [7], or unipolar-to-bipolar pulse shaping [8] has been used to reduce this error.”
BackgroundMethodA CMOS optical preamplifier for wireless infrared communications
Phang, K., & Johns, D. A. (1999) · IEEE Transactions on Circuits and Systems II Analog and Digital Signal Processing · doi:10.1109/82.775380 · Cited by 75
Research works printed but not linked: 1
- 1991, A Family of Wideband Low Noise Transimpedance Amplifiers
Cited by
A High-Sensitivity and Low-Walk Error LADAR Receiver for Military Application
Cho, H.-S., Kim, C.-H., & Lee, S. (2014) · IEEE Transactions on Circuits and Systems I Regular Papers · doi:10.1109/tcsi.2014.2327282 · Cited by 91
“In the design, a three-stage inverting amplifier [2] is adopted for the TIA, rather than a common source or cascode amplifiers, which has high DC gain of about 80 dB with GBW of about 6.”
BackgroundMethodSelf-citationA Wide Dynamic Range CMOS Laser Radar Receiver With a Time-Domain Walk Error Compensation Scheme
Kurtti, S., Nissinen, J., & Kostamovaara, J. (2016) · IEEE Transactions on Circuits and Systems I Regular Papers · doi:10.1109/tcsi.2016.2619762 · Cited by 69
“The performance of the proposed receiver is summarized and compared with figures presented in other recently published works in this field in Table I [13], [28]–[31].”
A Low Walk Error Analog Front-End Circuit With Intensity Compensation for Direct ToF LiDAR
Wang, X., Ma, R., Li, D., Zheng, H., Liu, M., & Zhu, Z. (2020) · IEEE Transactions on Circuits and Systems I Regular Papers · doi:10.1109/tcsi.2020.3022714 · Cited by 66
“It can be concluded from (9) that the input-referred noise current is slightly decreased in this design, compared with the conventional topology [16].”
BackgroundMethodResultInfluentialA CMOS Receiver–TDC Chip Set for Accurate Pulsed TOF Laser Ranging
Kurtti, S., Jansson, J.-P., & Kostamovaara, J. (2019) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2019.2918372 · Cited by 67
“This work [14] [23] [24] [25] [26] [27]”
A Linear-Mode LiDAR Sensor Using a Multi-Channel CMOS Transimpedance Amplifier Array
Hong, C., Kim, S.-H., Kim, J.-H., & Park, S. M. (2018) · IEEE Sensors Journal · doi:10.1109/jsen.2018.2852794 · Cited by 64
“They utilize laser light signals to characterize targets effectively across a scene by detecting and processing the reflected signals from targets [1]–[3].”
Background
Metadata
- Authors
- Ngo, T.-H., Kim, C.-H., Kwon, Y. J., Ko, J. S., Kim, D.-B., & Park, H.-H.
- Affiliations
- Korea Advanced Institute of Science and Technology (KR)
- Agency for Defense Development (KR)
- Samsung (South Korea) (KR)
- Venue
- IEEE Transactions on Circuits and Systems I: Regular Papers
- Published
- 2013-02
- Volume
- 60
- Issue
- 2
- Pages
- 448-456
- ISSN
- 1549-8328 (ISSN-L)
- 1558-0806
- OpenAlex
- W2069474418
- Cited by
- 68
- References
- 21
- Citations by year
- 2026: 3 · 2025: 3 · 2024: 10 · 2023: 4 · 2022: 4 · 2021: 4 · 2020: 9 · 2019: 9 · 2018: 6 · 2017: 9 · 2016: 3 · 2015: 1 · 2014: 2 · 2013: 1
- FWCI
- 2.94
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Transactions on Circuits and Systems I Regular Papers (publishedVersion)
- Topics
- Physical Sciences › Physics and Astronomy › Instrumentation › Advanced Optical Sensing Technologies
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Radio Frequency Integrated Circuit Design
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Analog and Mixed-Signal Circuit Design
- Keywords
- wideband receiver, direct detection, CMOS integrated circuit, linear dynamic range, gain control, noise minimization, signal-to-noise ratio, frequency response compensation, temperature stability, pulsed laser ranging
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Wideband Receiver for a Three-Dimensional Ranging LADAR System. https://app.cochat.ai/papers/10.1109/tcsi.2012.2215800
- The paper
- Ngo, T.-H., Kim, C.-H., Kwon, Y. J., Ko, J. S., Kim, D.-B., & Park, H.-H. (2013). Wideband Receiver for a Three-Dimensional Ranging LADAR System. IEEE Transactions on Circuits and Systems I: Regular Papers. https://doi.org/10.1109/tcsi.2012.2215800
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.