The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
High-Frequency Resonant Transistor DC-DC Converters
Abstract
Transistor dc-dc converters which employ a resonant circuit are described. A resonant circuit is driven with square waves of current or voltage, and by adjusting the frequency around the resonant point, the voltage on the resonant components can be adjusted to any practical voltage level. By rectifying the voltage across the resonant elements, a dc voltage is obtained which can be either higher or lower than the input dc voltage to the converter. Thus, the converter can operate in either the step-up or step-down mode. In addition, the switching losses in the inverter devices and rectifiers are extremely low due to the sine waves that occur from the use of a resonant circuit (as opposed to square waves in a conventional converter); also, easier EMI filtering should result. In the voltage input version, the converter is able to use the parasitic diode associated with an FET or monolithic Darlington, while in the current input version, the converter needs the inverse blocking capability which can be obtained with an IGT or GTO device. A low-power breadboard operating at 200-300 kHz has been built. Two typical application areas are switching power supplies and battery chargers. The converter circuits offer improvements over conventional circuits due to their high efficiency (low switching losses), small reactive components (high-frequency operation), and their step-up/stepdown ability.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
An Improved Method of Resonant Current Pulse Modulation for Power Converters
Schwarz, F. C. (1976) · IEEE Transactions on Industrial Electronics and Control Instrumentation · doi:10.1109/tieci.1976.351365 · Cited by 179
Cited by
A three-phase soft-switched high-power-density DC/DC converter for high-power applications
De Doncker, R. W. A. A., Divan, D. M., & Kheraluwala, M. H. (1991) · IEEE Transactions on Industry Applications · doi:10.1109/28.67533 · Cited by 2,535
The resonant DC link converter-a new concept in static power conversion
Divan, D. M. (1989) · IEEE Transactions on Industry Applications · doi:10.1109/28.25548 · Cited by 815
Efficiency-Optimized High-Current Dual Active Bridge Converter for Automotive Applications
Krismer, F., & Kolar, J. W. (2012) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2011.2112312 · Cited by 747
Analysis and Design of an LCL-T Resonant Converter as a Constant-Current Power Supply
Borage, M., Tiwari, S., & Kotaiah, S. (2005) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2005.858729 · Cited by 271
A three-phase soft-switched high power density DC/DC converter for high power applications
De Doncker, R. W., Divan, D. M., & Kheraluwala, M. H. (2003) · Conference Record of the 1988 IEEE Industry Applications Society Annual Meeting · doi:10.1109/ias.1988.25153 · Cited by 256
Metadata
- Authors
- Steigerwald, R. L.
- Venue
- IEEE Transactions on Industrial Electronics
- Published
- 1984-05
- Volume
- IE-31
- Issue
- 2
- Pages
- 181-191
- ISSN
- 0278-0046 (ISSN-L)
- OpenAlex
- W2172235144
- Cited by
- 330
- References
- 1
- FWCI
- 8.50
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: High-Frequency Resonant Transistor DC-DC Converters. https://app.cochat.ai/papers/10.1109/tie.1984.350066
- The paper
- Steigerwald, R. L. (1984). High-Frequency Resonant Transistor DC-DC Converters. IEEE Transactions on Industrial Electronics. https://doi.org/10.1109/tie.1984.350066
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.