Identifying Circulating Currents and Zero-Sequence Voltages for Reduction in Stored Capacitor Energy in Modular Multilevel Converters
The DOI matches its Crossref record; 30 of the 30 references it cites were found in a registry or an index.
Abstract
To reduce stored capacitor energy in modular multilevel converters (MMCs), previous papers propose injection of harmonics in the arm circulating currents and zero-sequence voltages. While this approach is effective, previously utilized combinations of injected harmonics significantly increase converter current ratings. In contrast, the optimization approach developed in this article identifies harmonics that simultaneously achieve capacitor energy optimization and reduced overrating of converter currents. In addition, the proposed approach eliminates the possibility of convergence to local minima, which is a significant improvement on previously proposed nonconvex optimization approaches. Experimental verification of the proposed approach is performed on a low-voltage three-phase modular multilevel converter.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Citations
Cites
An Industry-Based Survey of Reliability in Power Electronic Converters
Yang, S., Bryant, A., Mawby, P., Xiang, D., Ran, L., & Tavner, P. (2011) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2011.2124436 · Cited by 2,019 · cited 1×
“increase converter cost, volume, and weight [8] and [9].”
BackgroundOn the Implementation of a Primal-Dual Interior Point Method
Mehrotra, S. (1992) · SIAM Journal on Optimization · doi:10.1137/0802028 · Cited by 1,613
High Performance Current Controller for Selective Harmonic Compensation in Active Power Filters
Lascu, C., Asiminoaei, L., Boldea, I., & Blaabjerg, F. (2007) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2007.904060 · Cited by 521
Low output frequency operation of the Modular Multi-Level Converter
Korn, A. J., Winkelnkemper, M., & Steimer, P. (2010) · 2010 IEEE Energy Conversion Congress and Exposition · doi:10.1109/ecce.2010.5617802 · Cited by 426 · cited 4×
“, [15] assumed that the zero-sequence voltage only contained one harmonic frequency.”
BackgroundInfluentialWang, K., Li, Y., Zheng, Z., & Xu, L. (2013) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2012.2201433 · Cited by 378 · cited 4×
“To further reduce SM stored energy, other papers have injected a combination of circulating currents and zero-sequence voltages [14] and [15].”
BackgroundMethodInfluentialSolving large-scale linear programs by interior-point methods under the Matlab∗Environment†
Zhang, Y. (1998) · Optimization Methods and Software · doi:10.1080/10556789808805699 · Cited by 320 · cited 2×
“The procedure to find the KKT conditions is outlined in [25].”
BackgroundModular Multilevel Converter AC Motor Drives With Constant Torque From Zero to Nominal Speed
Antonopoulos, A., Angquist, L., Norrga, S., Ilves, K., Harnefors, L., & Nee, H.-P. (2014) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2013.2286217 · Cited by 297 · cited 1×
“a harmonic voltage component by ω0, then the resultant arm energy contains a fundamental frequency component [22].”
BackgroundVogelsberger, M. A., Wiesinger, T., & Ertl, H. (2011) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2010.2059713 · Cited by 244
Merlin, M. M. C., & Green, T. C. (2015) · IET Power Electronics · doi:10.1049/iet-pel.2014.0328 · Cited by 216 · cited 1×
“Reduction of the peakto-peak energy variation in MMCs reduces the peak of the total stored capacitor energy [21].”
BackgroundControl of the Modular Multi-Level Converter for minimized cell capacitance
Engel, S. P., & Doncker, R. W. D. (2011) · RWTH Publications (RWTH Aachen) · Cited by 201
Cited by
Modular Multilevel Converters: Recent Achievements and Challenges
Perez, M. A., Ceballos, S., Konstantinou, G., Pou, J., & Aguilera, R. P. (2021) · IEEE Open Journal of the Industrial Electronics Society · doi:10.1109/ojies.2021.3060791 · Cited by 327
Self-citationTian, Y., Wickramasinghe, H. R., Li, Z., Pou, J., & Konstantinou, G. S. (2022) · Energies · doi:10.3390/en15061985 · Cited by 66
“Additionally, the negative state of Figure 3c can be used [25] for improving the voltage/energy balancing and current control performance of the MMC [26], enabling multiple harmonic injections in the MMC arm [27].”
MethodSelf-citationLin, L., Li, A., Xu, C., & Wang, Y. (2020) · IEEE Access · doi:10.1109/access.2020.2995293 · Cited by 30
“There is a linear programming optimization approach has been taken to analyze the third-order harmonic injection combined with the second-order circulating current injection method [21].”
MethodA novel design of circulating current control target to minimize SM capacitance in MMC
Li, Q., Li, B., He, J., Prieto‐Araujo, E., Spier, D. W., Lyu, H., & Gomis‐Bellmunt, O. (2022) · International Journal of Electrical Power & Energy Systems · doi:10.1016/j.ijepes.2022.108432 · Cited by 19
Mishra, R., Vaghasiya, K. M., & Agarwal, V. (2022) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2021.3139144 · Cited by 11
Rodríguez, E., Leyva, R., Farivar, G. G., Townsend, C. D., & Pou, J. (2022) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2022.3233033 · Cited by 11
“Discretization, usingNs uniformly sampled values within T/2, of (15)–(17), within the index set t ∈ [0, T/2], or equivalently ωt ∈ [0, π], transforms the semiinfinite optimization problem into a finite-dimension LP problem [26].”
BackgroundSelf-citationMishra, R., & Agarwal, V. (2022) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2022.3199939 · Cited by 9
“Further, various circulating current schemes are also proposed in the literature [11], [12], [13] to shrink the SM–CVR and to reduce the SM capacitance requirement.”
BackgroundShi, X., Liu, C., Zhang, C., Li, R., & Cai, X. (2023) · IEEE Transactions on Energy Conversion · doi:10.1109/tec.2023.3282261 · Cited by 8
“Injecting third harmonic voltage (THV) into the three-phase modulation reference signals is a common technique to improve the utilization ratio of the DC bus voltage in CHBC-based applications [19], [20].”
MethodTian, R., Wu, X., Jing, L., Li, J., Zhao, H., & Yan, H. (2023) · IET Power Electronics · doi:10.1049/pel2.12552 · Cited by 5
Nunes, E., Liang, G., Rodriguez, E., Farivar, G. G., Konstantinou, G. S., Ghias, A. M. Y. M., Ceballos, S., Pou, J., Franquelo, L. G., & Rodriguez, J. (2025) · IEEE Open Journal of the Industrial Electronics Society · doi:10.1109/ojies.2025.3635635 · Cited by 3
“The details of this LP are omitted for brevity, and interested readers are referred to [60].”
Self-citationOptimization Methods to Reduce Capacitor Stress in Modular Multilevel Converters
Petranovic, N., Cantoni, A., Townsend, C. D., & Konstantinou, G. S. (2020) · IEEE Access · doi:10.1109/access.2020.3043254 · Cited by 4
“A two-step linear programming method is considered in [18] that uses auxiliary optimisation parameters that provide upper and lower bounds to stored capacitor energy, an upper bound on average current, and upper bounds on harmonic zero-sequence voltage magnitudes.”
BackgroundMethodSelf-citationLiu, Z., Li, Y.-C., Li, L., Guo, Z., Li, K., & Wang, J. (2022) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2022.3174010 · Cited by 1
“By means of this approach, the influence of the circulating current was considered in [17] and [18], and the improved models were proposed for capacitor”
MethodGui, Q., Fehr, H., & Gensior, A. (2023) · European Conference on Power Electronics and Applications · doi:10.23919/epe23ecceeurope58414.2023.10264464 · Cited by 1
Closed-Loop Performance Improvement for MMCs Based on Optimal Reference Governor
Poblete, P., Neira, S., Cuzmar, R. H., Aguilera, R. P., Mora, A., & Pereda, J. E. (2021) · IEEE ECCE Asia Downunder · doi:10.1109/ecce-asia49820.2021.9479378
Zhang, B., Dai, N., & Zhu, M. (2025) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2025.3592311
“Townsend et al. [28] proposed a linear programming-based optimization method that identifies the optimal CC and ZVS to minimize CVR under constraints on peak arm current and power loss.”
Thahab, R. T., & Al-Mhana, T. (2026) · Results in Engineering · doi:10.1016/j.rineng.2026.110427
Mohtat, S., Bongiorno, M., Beza, M., Svensson, J., & Rasmussen, J. (2025) · Energy Conversion Congress and Expo Europe (ECCE Europe) · doi:10.1109/ecce-europe62795.2025.11238671
“For instance, prior works [4]–[6] have explored the injection of circulating current and zero-sequence voltage to optimize specific design parameters, such as SM capacitor size or converter losses.”
Mohtat, S., Bongiorno, M., Beza, M., Svensson, J., & Rasmussen, J. (2026) · Electric Power Systems Research · doi:10.1016/j.epsr.2026.113406
Metadata
- Authors
- Townsend, C. D., Goodwin, G. C., Konstantinou, G., Petranovic, N., Mirzaeva, G., Farivar, G., & Pou, J.
- Affiliations
- The University of Western Australia (AU)
- University of Newcastle Australia (AU)
- UNSW Sydney (AU)
- Nanyang Technological University (SG)
- ORCID
- Venue
- IEEE Transactions on Industrial Electronics
- Published
- 2021-01
- Volume
- 68
- Issue
- 1
- Pages
- 454-465
- ISSN
- 0278-0046 (ISSN-L)
- 1557-9948
- OpenAlex
- W3000498656
- Cited by
- 17
- References
- 30
- Citations by year
- 2026: 2 · 2025: 2 · 2023: 3 · 2022: 6 · 2021: 2
- FWCI
- 1.12
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- Locations
- IEEE Transactions on Industrial Electronics (publishedVersion)
- UWA Profiles and Research Repository (UWA) (submittedVersion)
- NOVA (University of Newcastle Australia) (submittedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › HVDC Systems and Fault Protection
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Multilevel Inverters and Converters
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Power Quality and Harmonics
- Keywords
- modular multilevel converter, circulating current, zero-sequence voltage, harmonic injection, non-convex optimization, local optima avoidance
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.