The DOI matches its Crossref record; 21 of the 21 references it cites were found in a registry or an index.
Pyroelectric energy conversion: Optimization principles
Abstract
In the framework of microgenerators, we present in this paper the key points for energy harvesting from temperature using ferroelectric materials. Thermoelectric devices profit from temperature spatial gradients, whereas ferroelectric materials require temporal fluctuation of temperature, thus leading to different applications targets. Ferroelectric materials may harvest perfectly the available thermal energy whatever the materials properties (limited by Carnot conversion efficiency) whereas thermoelectric material's efficiency is limited by materials properties (ZT figure of merit). However, it is shown that the necessary electric fields for Carnot cycles are far beyond the breakdown limit of bulk ferroelectric materials. Thin films may be an excellent solution for rising up to ultra-high electric fields and outstanding efficiency. Different thermodynamic cycles are presented in the paper: principles, advantages, and drawbacks. Using the Carnot cycle, the harvested energy would be independent of materials properties. However, using more realistic cycles, the energy conversion effectiveness remains dependent on the materials properties as discussed in the paper. A particular coupling factor is defined to quantify and check the effectiveness of pyroelectric energy harvesting. It is defined similarly to an electromechanical coupling factor as k2=p2theta0/(epsilontheta33cE), where p, theta0, epsilontheta33, cE are pyroelectric coefficient, maximum working temperature, dielectric permittivity, and specific heat, respectively. The importance of the electrothermal coupling factor is shown and discussed as an energy harvesting figure of merit. It gives the effectiveness of all techniques of energy harvesting (except the Carnot cycle). It is finally shown that we could reach very high efficiency using 1110.75Pb(Mg1/3Nb2/3)-0.25PbTiO3 single crystals and synchronized switch harvesting on inductor (almost 50% of Carnot efficiency). Finally, practical implementation key points of pyroelectric energy harvesting are presented showing that the different thermodynamic cycles are feasible and potentially effective, even compared to thermoelectric devices.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Fundamentals of Power Electronics
Erickson, R. W., & Maksimović, D. (2001) · Springer eBooks · doi:10.1007/b100747 · Cited by 6,112
Fundamentals of Power Electronics
Erickson, R. W., & Maksimović, D. (2020) · Springer eBooks · doi:10.1007/978-3-030-43881-4 · Cited by 5,420
Ferroelectric, dielectric and piezoelectric properties of ferroelectric thin films and ceramics
Damjanovic, D. (1998) · Reports on Progress in Physics · doi:10.1088/0034-4885/61/9/002 · Cited by 2,287
Giant Electrocaloric Effect in Thin-Film PbZr 0.95 Ti 0.05 O 3
Mischenko, A. S., Zhang, Q., Scott, J. F., Whatmore, R. W., & Mathur, N. D. (2006) · Science · doi:10.1126/science.1123811 · Cited by 1,713
Toward energy harvesting using active materials and conversion improvement by nonlinear processing
Guyomar, D., Badel, A., Lefeuvre, E., & Richard, C. (2005) · IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control · doi:10.1109/tuffc.2005.1428041 · Cited by 1,049
Self-citationImproving Power Output for Vibration-Based Energy Scavengers
Roundy, S., Leland, E. S., Baker, J., Carleton, E., Reilly, E., Lai, E., Otis, B., Rabaey, J. M., Sundararajan, V., & Wright, P. K. (2005) · IEEE Pervasive Computing · doi:10.1109/mprv.2005.14 · Cited by 1,031
A comparison between several vibration-powered piezoelectric generators for standalone systems
Lefeuvre, E., Badel, A., Richard, C., Petit, L., & Guyomar, D. (2006) · Sensors and Actuators A: Physical · doi:10.1016/j.sna.2005.10.043 · Cited by 712
Self-citationPiezoelectric Energy Harvesting Device Optimization by Synchronous Electric Charge Extraction
Lefeuvre, E., Badel, A., Richard, C., & Guyomar, D. (2005) · Journal of Intelligent Material Systems and Structures · doi:10.1177/1045389x05056859 · Cited by 640
Self-citationBuck-Boost Converter for Sensorless Power Optimization of Piezoelectric Energy Harvester
Lefeuvre, E., Audigier, D., Richard, C., & Guyomar, D. (2007) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2007.904230 · Cited by 439
Self-citationMischenko, A. S., Zhang, Q., Whatmore, R. W., Scott, J. F., & Mathur, N. D. (2006) · Applied Physics Letters · doi:10.1063/1.2405889 · Cited by 374
Review of some lesser-known applications of piezoelectric and pyroelectric polymers
Lang, S. B., & Muensit, S. (2006) · Applied Physics A · doi:10.1007/s00339-006-3688-8 · Cited by 277
Badel, A., Guyomar, D., Lefeuvre, E., & Richard, C. (2005) · Journal of Intelligent Material Systems and Structures · doi:10.1177/1045389x05053150 · Cited by 211
Self-citationElectrocaloric Effects in Some Ferroelectric and Antiferroelectric Pb(Zr, Ti)O3 Compounds
Thacher, P. D. (1968) · Journal of Applied Physics · doi:10.1063/1.1656478 · Cited by 211
Single crystals and nonlinear process for outstanding vibration-powered electrical generators
Badel, A., Benayad, A., Lefeuvre, E., Lebrun, L., Richard, C., & Guyomar, D. (2006) · IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control · doi:10.1109/tuffc.2006.1611027 · Cited by 181
Self-citationImproved ferroelectric and pyroelectric properties in Mn-doped lead zirconate titanate thin films
Zhang, Q., & Whatmore, R. W. (2003) · Journal of Applied Physics · doi:10.1063/1.1613370 · Cited by 131
Beyer, H., Nurnus, J., Böttner, H., Lambrecht, A., Wagner, E. E., & Bauer, G. (2002) · Physica E Low-dimensional Systems and Nanostructures · doi:10.1016/s1386-9477(02)00246-1 · Cited by 106
Pyroelectric Arrays: Ceramics and Thin Films
Whatmore, R. W. (2004) · Journal of Electroceramics · doi:10.1007/s10832-004-5090-2 · Cited by 84
Novel power conditioning circuits for piezoelectric micro power generators
Han, J., von Jouanne, A., Le, T., Mayaram, K., & Fiez, T. S. (2004) · Conference proceedings/Conference proceedings - IEEE Applied Power Electronics Conference and Exposition · doi:10.1109/apec.2004.1296069 · Cited by 84
Davis, M., Damjanović, D., & Setter, N. (2004) · Journal of Applied Physics · doi:10.1063/1.1775308 · Cited by 59
Ducharne, B., Guyomar, D., & Sebald, G. (2007) · Journal of Physics D Applied Physics · doi:10.1088/0022-3727/40/2/032 · Cited by 44
Self-citationPyroelectric properties of PZT/P(VDF-TrFE) 0-3 composites
Ng, W. Y., Ploss, B., Chan, H. L. W., Shin, F. G., & Choy, C. L. (2002) · Proceedings - IEEE International Symposium on Applications of Ferroelectrics/Proceedings of the ... IEEE International Symposium on Applications of Ferroelectrics · doi:10.1109/isaf.2000.942432 · Cited by 13
Cited by
Piezoelectric and ferroelectric materials and structures for energy harvesting applications
Bowen, C. R., Kim, H. A., Weaver, P. M., & Dunn, S. (2014) · Energy Environ. Sci. · doi:10.1039/c3ee42454e · Cited by 1,223
Ferroelectricity and Antiferroelectricity of Doped Thin HfO2‐Based Films
Park, M. H., Lee, Y. H., Kim, H. J., Kim, Y. J., Moon, T., Kim, K. D., Müller, J., Kersch, A., Schroeder, U., Mikolajick, T., et al. (2015) · Advanced Materials · doi:10.1002/adma.201404531 · Cited by 1,189
Pandey, R., Vats, G., Yun, J., Bowen, C. R., Ho‐Baillie, A. W. Y., Seidel, J., Butler, K. T., & Seok, S. I. (2019) · Advanced Materials · doi:10.1002/adma.201807376 · Cited by 1,069
High performance ferroelectric relaxor-PbTiO3 single crystals: Status and perspective
Zhang, S., & Li, F. (2012) · Journal of Applied Physics · doi:10.1063/1.3679521 · Cited by 966
Standards and figure-of-merits for quantifying the performance of triboelectric nanogenerators
Zi, Y., Niu, S., Wang, J., Wen, Z., Tang, W., & Wang, Z. L. (2015) · Nature Communications · doi:10.1038/ncomms9376 · Cited by 897
Metadata
- Authors
- Sebald, G., Lefeuvre, E., & Guyomar, D.
- Venue
- IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control
- Published
- 2008-03
- Volume
- 55
- Issue
- 3
- Pages
- 538-551
- ISSN
- 0885-3010 (ISSN-L)
- OpenAlex
- W2118507765
- Cited by
- 274
- References
- 21
- FWCI
- 27.03
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.