The DOI matches its Crossref record.
Field measurements of the flux and speed of wind‐blown sand
Abstract
A field experiment was conducted to measure the flux and speed of wind‐blown sand under known conditions in a natural setting. The experiment, run at Pismo Beach, California, involved a tract 100 m long (parallel with the wind) by 20 m wide. The site was instrumented with four arrays of anemometers to obtain wind velocity profiles through the lower atmospheric boundary‐layer, temperature probes to determine atmospheric stability and wind vanes to determine wind direction. From these measurements, wind friction speeds were derived for each experimental run. In order to measure sand saltation flux, a trench 3 m long by 10 m wide (transverse to the wind direction) by 0·5 m deep was placed at the downwind end of the tract and lined with 168 collector bins, forming an ‘egg‐box’ pattern. The mass of particles collected in each bin was determined for four experimental runs. In order to assess various sand‐trap systems used in previous experiments, 12 Leatherman traps, one Fryberger trap and one array of Ames traps were deployed to collect particles concurrently with the trench collection. Particle velocities were determined from analysis of high‐speed (3000 and 5000 frames per second) motion pictures and from a particle velocimeter. Sand samples were collected from the trench bins and the various sand traps and grain size distributions were determined. Fluxes for each run were calculated using various previously published expressions, and then compared with the flux derived from the trench collection. Results show that Bagnold's (1941) model and White's (1979) equation most closely agree with values derived from the trench. Comparison of the various collector systems shows that the Leatherman and Ames traps most closely agree with the flux derived from the trench, although these systems tended to under‐collect particles. Particle speeds were measured from analysis of motion pictures for saltating particles in ascending and descending parts of their trajectories. Results show that particle velocities from the velocimeter are in the range 0·5–7·0 m s−1, compared to a wind friction velocity of 0·32–0·43 m s−1 and a wind velocity of 2·7–3·9 m s−1 at the height of the particle measurements. Descending particles tended to exceed the speeds of ascending particles by ∼ 0·5 m s−1.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
The physics of wind-blown sand and dust
Kok, J. F., Parteli, E. J. R., Michaels, T. I., & Karam, D. B. (2012) · Reports on Progress in Physics · doi:10.1088/0034-4885/75/10/106901 · Cited by 1,608
A comprehensive numerical model of steady state saltation (COMSALT)
Kok, J. F., & Renno, N. O. (2009) · Journal of Geophysical Research: Atmospheres · doi:10.1029/2009jd011702 · Cited by 314
On aeolian transport: Grain-scale interactions, dynamical mechanisms and scaling laws
Durán, O., Claudin, P., & Andreotti, B. (2011) · Aeolian Research · doi:10.1016/j.aeolia.2011.07.006 · Cited by 302
Metadata
- Authors
- GREELEY, R., BLUMBERG, D. G., & WILLIAMS, S. H.
- Venue
- Sedimentology
- Publisher
- Wiley
- Published
- 1996-02
- Volume
- 43
- Issue
- 1
- Pages
- 41-52
- ISSN
- 0037-0746 (ISSN-L)
- 1365-3091
- OpenAlex
- W2013746506
- Cited by
- 178
- References
- 0
- FWCI
- 14.69
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Field measurements of the flux and speed of wind‐blown sand. https://app.cochat.ai/papers/10.1111/j.1365-3091.1996.tb01458.x
- The paper
- GREELEY, R., BLUMBERG, D. G., & WILLIAMS, S. H. (1996). Field measurements of the flux and speed of wind‐blown sand. Sedimentology. https://doi.org/10.1111/j.1365-3091.1996.tb01458.x
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.