The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Solution‐Controlled Dissolution of Supplementary Cementitious Material Glasses at pH 13: The Effect of Solution Composition on Glass Dissolution Rates
Open accessAbstract
Supplementary cementitious materials ( SCM s) are widely used to partially replace portland clinker in blended cements. Reducing clinker contents further without compromising the development of early strength necessitates a better assessment and enhancement of the reactivity of the available SCM s. To this purpose, the reactivity of synthesized calcium aluminosilicate glasses covering a compositional range from blast‐furnace slags (BFS) over fly ashes to silica fume was analyzed by dissolution experiments. Initial glass dissolution rates were measured at 20°C and pH 13, and with varying initial concentrations of aqueous Al , Ca , and Si . At pH 13, glass dissolution rates were observed to scale linearly with the glass Ca /( Al + Si ) molar ratio. Ca ‐rich blast‐furnace type glass dissolution was shown to be up to one order of magnitude faster than tectosilicate fly ash and silica fume type glass dissolution, supporting different pathways to dissolution. In solutions that are strongly undersaturated with respect to hydrous glass and hydration products, glass dissolution rates are independent of changes in solution undersaturation and aqueous Si activity. In contrast, dissolution rates decrease with aqueous Ca concentration for all glasses and with aqueous Al concentration for tectosilicate‐type glasses. The insights gained are instrumental in finding ways to enhance SCM reactivity.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Oelkers, E. H., & Gislason, S. R. (2001) · Geochimica et Cosmochimica Acta · doi:10.1016/s0016-7037(01)00664-0 · Cited by 498
Cited by
Supplementary cementitious materials: New sources, characterization, and performance insights
Juenger, M. C. G., Snellings, R., & Bernal, S. A. (2019) · Cement and Concrete Research · doi:10.1016/j.cemconres.2019.05.008 · Cited by 1,260
Self-citationReactivity of supplementary cementitious materials (SCMs) in cement blends
Skibsted, J., & Snellings, R. (2019) · Cement and Concrete Research · doi:10.1016/j.cemconres.2019.105799 · Cited by 984
Self-citationInfluence of limestone on the hydration of ternary slag cements
Adu-Amankwah, S., Zajac, M., Stabler, C., Lothenbach, B., & Black, L. (2017) · Cement and Concrete Research · doi:10.1016/j.cemconres.2017.05.013 · Cited by 365
Assessing, Understanding and Unlocking Supplementary Cementitious Materials
Snellings, R. (2016) · RILEM Technical Letters · doi:10.21809/rilemtechlett.2016.12 · Cited by 348
Self-citationDurdziński, P. T., Dunant, C. F., Haha, M. B., & Scrivener, K. L. (2015) · Cement and Concrete Research · doi:10.1016/j.cemconres.2015.02.008 · Cited by 288
Metadata
- Authors
- Snellings, R.
- Venue
- Journal of the American Ceramic Society
- Publisher
- Wiley
- Published
- 2013-07-24
- Volume
- 96
- Issue
- 8
- Pages
- 2467-2475
- ISSN
- 0002-7820 (ISSN-L)
- 1551-2916
- OpenAlex
- W2135145774
- Cited by
- 229
- References
- 1
- FWCI
- 16.68
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.