The DOI matches its Crossref record.
Editorial Policy Statement on the Control of Numerical Accuracy
Open accessAbstract
A professional problem exists in the computational fluid dynamics community and also in the broader area of computational physics. Namely, there is a need for higher standards on the control of numerical accuracy.The numerical fluid dynamics community is aware of this problem but, although individual researchers strive to control accuracy, the issue has not to our knowledge been addressed collectively and formally by any professional society of journal editorial board. The problem is certainly not unique to the JFE and came into even sharper focus at the 1980-81 AFOSRHTTM-Stanford Conference on Complex Turbulent Flows. It was a conclusion of that conference's Evaluation Committee1 that, in most of the submissions to that conference, it was impossible to evaluate and compare the accuracy of different turbulence models, since one could not distinguish physical modeling errors from numerical errors related to the algorithm and grid. This is especially the case for first-order accurate methods and hybrid methods.The practice of publishing comparisons based on coarse grid solutions, without systematic truncation error testing, may have been acceptable in the past. Certainly ten to fifteen years ago any calculation was of interest, and much of the exploratory work deserved publication, as many researchers lacked the computational power or funds to do a thorough and systematic error estimation. We are of the opinion that this practice, however understandable in the past, is outmoded and that, with powerful computers becoming more common, standards should be raised. Consequently, this journal hereby announces the following policy:The Journal of Fluids Engineering will not accept for publication any paper reporting the numerical solution of a fluids engineering problem that fails to address the task of systematic truncation error testing and accuracy estimation.Although the formal announcement of this journal policy is new, it has been the practice of many of our conscientious reviewers. Thus the present announcement is not a change in policy so much as a clarification and standardization.Methods are available to accomplish this task, such as Richardson extrapolation (when applicable), calculations with a high- and low-order method on the same grid, and straightforward repeat calculations with finer or coarser grids. As in the case of experimental uncertainty analysis, “… any appropriate analysis is far better than none as long as the procedure is explained.”2 Whatever the authors use will be considered in the review process, but we must make it clear that a single calculation in a fixed grid will not be acceptable, since it is impossible to infer an accuracy estimate from such a calculation. Also, the editors will not consider a reasonable agreement with experimental data to be sufficient proof of accuracy, especially if any adjustable parameters are involved, as in turbulence modeling.We recognize that it can be costly to do a thorough study, and that many practical engineering calculations will continue to be performed on a single fixed grid. However, this practice is insufficient for publication in an archival journal.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Procedure for Estimation and Reporting of Uncertainty Due to Discretization in CFD Applications
(2008) · Journal of Fluids Engineering · doi:10.1115/1.2960953 · Cited by 4,327
AIJ guidelines for practical applications of CFD to pedestrian wind environment around buildings
Tominaga, Y., Mochida, A., Yoshie, R., Kataoka, H., Nozu, T., Yoshikawa, M., & Shirasawa, T. (2008) · Journal of Wind Engineering and Industrial Aerodynamics · doi:10.1016/j.jweia.2008.02.058 · Cited by 2,470
QUANTIFICATION OF UNCERTAINTY IN COMPUTATIONAL FLUID DYNAMICS
Roache, P. J. (1997) · Annual Review of Fluid Mechanics · doi:10.1146/annurev.fluid.29.1.123 · Cited by 2,319
Self-citationBlocken, B. (2015) · Building and Environment · doi:10.1016/j.buildenv.2015.02.015 · Cited by 1,163
Verification and validation in computational fluid dynamics
Oberkampf, W. L., & Trucano, T. G. (2002) · Progress in Aerospace Sciences · doi:10.1016/s0376-0421(02)00005-2 · Cited by 1,150
Stern, F., Wilson, R. V., Coleman, H. W., & Paterson, E. G. (2001) · Journal of Fluids Engineering · doi:10.1115/1.1412235 · Cited by 935
50 years of Computational Wind Engineering: Past, present and future
Blocken, B. (2014) · Journal of Wind Engineering and Industrial Aerodynamics · doi:10.1016/j.jweia.2014.03.008 · Cited by 825
Index of Resolution Quality for Large Eddy Simulations
Celik, I. B., Cehreli, Z. N., & Yavuz, I. (2005) · Journal of Fluids Engineering · doi:10.1115/1.1990201 · Cited by 797
Code Verification by the Method of Manufactured Solutions
Roache, P. J. (2002) · Journal of Fluids Engineering · doi:10.1115/1.1436090 · Cited by 760
Self-citationVerification of Codes and Calculations
Roache, P. J. (1998) · AIAA Journal · doi:10.2514/2.457 · Cited by 679
Self-citationRamponi, R., & Blocken, B. (2012) · Building and Environment · doi:10.1016/j.buildenv.2012.01.004 · Cited by 555
LES over RANS in building simulation for outdoor and indoor applications: A foregone conclusion?
Blocken, B. (2018) · Building Simulation · doi:10.1007/s12273-018-0459-3 · Cited by 543
Prediction of wind environment and thermal comfort at pedestrian level in urban area
Mochida, A., & Lun, I. Y. F. (2008) · Journal of Wind Engineering and Industrial Aerodynamics · doi:10.1016/j.jweia.2008.02.033 · Cited by 331
Bitog, J. P., Lee, I.-B., Lee, C.-G., Kim, K.-S., Hwang, H.-S., Hong, S.-W., Seo, I.-H., Kwon, K.-S., & Mostafa, E. (2011) · Computers and Electronics in Agriculture · doi:10.1016/j.compag.2011.01.015 · Cited by 300
Guidelines on the use of structure‐from‐motion photogrammetry in geomorphic research
James, M. R., Chandler, J. H., Eltner, A., Fraser, C., Miller, P. E., Mills, J. P., Noble, T., Robson, S., & Lane, S. N. (2019) · Earth Surface Processes and Landforms · doi:10.1002/esp.4637 · Cited by 294
Simulation benchmarks for low-pressure plasmas: Capacitive discharges
Turner, M. M., Derzsi, A., Donkó, Z., Eremin, D., Kelly, S. J., Lafleur, T., & Mussenbrock, T. (2013) · Physics of Plasmas · doi:10.1063/1.4775084 · Cited by 293
Blocken, B., & Gualtieri, C. (2012) · Environmental Modelling & Software · doi:10.1016/j.envsoft.2012.02.001 · Cited by 287
Aubin, J., Fletcher, D. F., & Xuereb, C. (2004) · Experimental Thermal and Fluid Science · doi:10.1016/j.expthermflusci.2003.04.001 · Cited by 269
Bitog, J. P. P., Lee, I.-B., Oh, H.-M., Hong, S.-W., Seo, I.-H., & Kwon, K.-S. (2014) · Biosystems Engineering · doi:10.1016/j.biosystemseng.2014.03.006 · Cited by 44
Metadata
- Authors
- Roache, P. J., Ghia, K. N., & White, F. M.
- Venue
- Journal of Fluids Engineering
- Publisher
- ASME International
- Published
- 1986-03-01
- Volume
- 108
- Issue
- 1
- Pages
- 2
- ISSN
- 0098-2202 (ISSN-L)
- 1528-901X
- OpenAlex
- W2128928687
- Cited by
- 359
- References
- 0
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.