The DOI matches its Crossref record; 6 of the 6 references it cites were found in a registry or an index.
Study of the SiO2-to-Si3N4 etch selectivity mechanism in inductively coupled fluorocarbon plasmas and a comparison with the SiO2-to-Si mechanism
Open accessAbstract
The mechanisms underlying selective etching of a SiO2 layer over a Si or Si3N4 underlayer, a process of vital importance to modern integrated circuit fabrication technology, has been studied. Selective etching of SiO2-to-Si3N4 in various inductively coupled fluorocarbon plasmas (CHF3, C2F6/C3F6, and C3F6/H2) was performed, and the results compared to selective SiO2-to-Si etching. A fluorocarbon film is present on the surfaces of all investigated substrate materials during steady state etching conditions. A general trend is that the substrate etch rate is inversely proportional to the thickness of this fluorocarbon film. Oxide substrates are covered with a thin fluorocarbon film (<1.5 nm) during steady-state etching and at sufficiently high self-bias voltages, the oxide etch rates are found to be roughly independent of the feedgas chemistry. The fluorocarbon film thicknesses on silicon, on the other hand, are strongly dependent on the feedgas chemistry and range from ∼2 to ∼7 nm in the investigated process regime. The fluorocarbon film thickness on nitride is found to be intermediate between the oxide and silicon cases. The fluorocarbon film thicknesses on nitride range from ∼1 to ∼4 nm and the etch rates appear to be dependent on the feedgas chemistry only for specific conditions. The differences in etching behavior of SiO2, Si3N4, and Si are suggested to be related to a substrate-specific ability to consume carbon during etching reactions. Carbon consumption affects the balance between fluorocarbon deposition and fluorocarbon etching, which controls the fluorocarbon steady-state thickness and ultimately the substrate etching.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Plasma etching—A discussion of mechanisms
Coburn, J. W., & Winters, H. F. (1979) · Journal of Vacuum Science and Technology · doi:10.1116/1.569958 · Cited by 613
Standaert, T. E. F. M., Schaepkens, M., Rueger, N. R., Sebel, P. G. M., Oehrlein, G. S., & Cook, J. M. (1998) · Journal of Vacuum Science & Technology A Vacuum Surfaces and Films · doi:10.1116/1.580978 · Cited by 271
Self-citationRueger, N. R., Beulens, J., Schaepkens, M., Doemling, M. F., Mirza, J. M., Standaert, T. E. F. M., & Oehrlein, G. S. (1997) · Journal of Vacuum Science & Technology A Vacuum Surfaces and Films · doi:10.1116/1.580655 · Cited by 261
Self-citationNovel radio-frequency induction plasma processing techniques
Keller, J. H., Forster, J. C., & Barnes, M. S. (1993) · Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films · doi:10.1116/1.578597 · Cited by 242
Silicon etching mechanisms in a CF4/H2 glow discharge
Oehrlein, G. S., & Williams, H. L. (1987) · Journal of Applied Physics · doi:10.1063/1.339766 · Cited by 160
Self-citationHaverlag, M., Vender, D., & Oehrlein, G. S. (1992) · Applied Physics Letters · doi:10.1063/1.108062 · Cited by 26
Self-citation
Cited by
High aspect ratio silicon etch: A review
Wu, B., Kumar, A., & Pamarthy, S. (2010) · Journal of Applied Physics · doi:10.1063/1.3474652 · Cited by 749
Ultra-low-loss on-chip resonators with sub-milliwatt parametric oscillation threshold
Ji, X., Barbosa, F. A. S., Roberts, S. P., Dutt, A., Cardenas, J., Okawachi, Y., Bryant, A., Gaeta, A. L., & Lipson, M. (2017) · Optica · doi:10.1364/optica.4.000619 · Cited by 552
Atomic Layer Etching at the Tipping Point: An Overview
Oehrlein, G. S., Metzler, D., & Li, C. (2015) · ECS Journal of Solid State Science and Technology · doi:10.1149/2.0061506jss · Cited by 295
Self-citationEnergy distribution of bombarding ions in plasma etching of dielectrics
Buzzi, F. L., Ting, Y.-H., & Wendt, A. E. (2009) · Plasma Sources Science and Technology · doi:10.1088/0963-0252/18/2/025009 · Cited by 50
Metadata
- Authors
- Schaepkens, M., Standaert, T. E. F. M., Rueger, N. R., Sebel, P. G. M., Oehrlein, G. S., & Cook, J. M.
- Venue
- Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films
- Publisher
- American Vacuum Society
- Published
- 1999-01-01
- Volume
- 17
- Issue
- 1
- Pages
- 26-37
- ISSN
- 0734-2101 (ISSN-L)
- 1520-8559
- OpenAlex
- W1973061894
- Cited by
- 319
- References
- 6
- FWCI
- 17.80
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Study of the SiO2-to-Si3N4 etch selectivity mechanism in inductively coupled fluorocarbon plasmas and a comparison with the SiO2-to-Si mechanism. https://app.cochat.ai/papers/10.1116/1.582108
- The paper
- Schaepkens, M., Standaert, T. E. F. M., Rueger, N. R., Sebel, P. G. M., Oehrlein, G. S., & Cook, J. M. (1999). Study of the SiO2-to-Si3N4 etch selectivity mechanism in inductively coupled fluorocarbon plasmas and a comparison with the SiO2-to-Si mechanism. Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films. https://doi.org/10.1116/1.582108
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.