The DOI matches its Crossref record.
Silicon etching mechanisms in a CF4/H2 glow discharge
Abstract
Fluorocarbon film deposition onto Si and its influence on the measured Si etch rate in CF4/H2 reactive ion etching in a symmetric two electrode reactor has been studied as a function of CF4/H2 feed gas composition, total gas flow, and applied rf power. For reactive ion etching, the fluorocarbon film thickness on Si increases as the percentage x of H2 in CF4/x% H2 is increased. The fluorocarbon film thickness depends on the total gas flow and is greater for greater gas flows. The observed Si etch rate is controlled by the fluorocarbon film. The Si etch rate is directly proportional to the inverse of the F,C-film thickness for fluorocarbon films thicker than ∼10 Å, which may indicate a diffusion-limited mechanism. Both in-diffusion of fluorine and out-diffusion of SiF4 etch product through the fluorocarbon film are consistent with the decrease of the Si etch rate. The relative importance of the lowering of the atomic F concentration in the gas phase on the Si etch rate, e.g., by the H scavenging mechanism, has also been studied. This reaction can be important for conditions where either the inner walls of the etching apparatus can be maintained free of C,F film throughout the etching experiment, and/or a low hydrogen concentration (≤20%) in the CF4/H2 feed gas is used. For a fixed gas composition of CF4/40% H2, the rf-power dependence of the C,F-film thickness and of the Si etch rate was studied. In reactive ion etching, i.e., if rf power is supplied to the bottom (substrate) electrode, at first a monotonic rise in deposited fluorocarbon film thickness with increasing rf power is observed; at high rf-power levels a dramatic decrease in the C,F-layer thickness occurs, which is concomitant with a greater intensity of near surface lattice disorder (from ion channeling studies) and Si etching. Silicon etching is not observed for lower rf powers. In cases where rf power was supplied to the top electrode only, C,F-film deposition has been observed and no Si etching. These data are consistent with a recombinant model of etch anisotropy.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Surface science aspects of etching reactions
Winters, H. F., & Coburn, J. W. (1992) · Surface Science Reports · doi:10.1016/0167-5729(92)90009-z · Cited by 502
Schaepkens, M., Standaert, T. E. F. M., Rueger, N. R., Sebel, P. G. M., Oehrlein, G. S., & Cook, J. M. (1999) · Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films · doi:10.1116/1.582108 · Cited by 319
Self-citationAtomic Layer Etching at the Tipping Point: An Overview
Oehrlein, G. S., Metzler, D., & Li, C. (2015) · ECS Journal of Solid State Science and Technology · doi:10.1149/2.0061506jss · Cited by 295
Self-citationEnergy distribution of bombarding ions in plasma etching of dielectrics
Buzzi, F. L., Ting, Y.-H., & Wendt, A. E. (2009) · Plasma Sources Science and Technology · doi:10.1088/0963-0252/18/2/025009 · Cited by 50
Metadata
- Authors
- Oehrlein, G. S., & Williams, H. L.
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 1987-07-15
- Volume
- 62
- Issue
- 2
- Pages
- 662-672
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W2036266711
- Cited by
- 160
- References
- 0
- FWCI
- 11.25
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Silicon etching mechanisms in a CF4/H2 glow discharge. https://app.cochat.ai/papers/10.1063/1.339766
- The paper
- Oehrlein, G. S., & Williams, H. L. (1987). Silicon etching mechanisms in a CF4/H2 glow discharge. Journal of Applied Physics. https://doi.org/10.1063/1.339766
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.