The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Slip at polymer–polymer interfaces: Rheological measurements on coextruded multilayers
Open accessAbstract
Polypropylene (PP) and polystyrene (PS), with closely matched viscosity, were coextruded into 8, 32, and 64 alternating layers. The apparent steady shear viscosity of these multilayer samples was measured with an in-line slit rheometer and with a parallel-plate rheometer. In both cases the apparent viscosity decreased with the number of layers providing strong evidence for interfacial slip. The velocity difference across the interface (interfacial slip velocity) versus shear stress, ΔVI(τ) was calculated from the apparent viscosity measurements. ΔVI(τ) showed sigmoidal behavior: a region of very low slip (< 10−3 μm) at low shear stress, a strongly increasing region at τ > 103 Pa followed by a linear region ΔVI=τ/β∞. These data could be fit with a modified Ellis model. The same function fit the different number of layers and both slit and parallel-plate data indicating ΔVI(τ) is a material property of the PP/PS pair. Slip was also observed in PS/PMMA (polymethyl methacrylate) and PP/aPA (amorphous nylon) pairs. Addition of a premade P(S-b-EE) diblock copolymer to the PP/PS pair was able to suppress the interfacial slip but only after enough time for sufficient block copolymers to diffuse to the interfaces. The in situ formed graft copolymer of maleated PP with aPA at the interface of the PP/aPA pair directly suppressed the slip. Our results are in qualitative agreement with the theory of Furukawa (1989) and de Gennes (1992), which predicts fewer chain entanglements near the interface between two immiscible polymers, and thus a narrow region (∼ interfacial width) with lower viscosity. This lower viscosity is the cause of apparent interfacial slip. Goveas and Fredrickson (1998) extended these ideas to calculate the slip in a symmetric bilayer where both bulk and interface are Newtonian. Their results are in qualitative agreement with our observation but predict a stronger slip. Our results also indicate that the anomalously low viscosity reported by a number of researchers for immiscible polymer blends is due to interfacial slip. Blends of PP and PS show similar negative viscosity deviations to those reported but only at τ > 2000 Pa. No negative deviations were found for linear viscoelastic (low-stress) measurements.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Compatibilizers for melt blending: premade block copolymers
Macosko, C. W., Guégan, P., Khandpur, A. K., Nakayama, A., Marechal, P., & Inoue, T. (1996) · Macromolecules · doi:10.1021/ma9602482 · Cited by 458
Self-citation
Cited by
Reactions at polymer–polymer interfaces for blend compatibilization
Macosko, C. W., Jeon, H. K., & Hoye, T. R. (2005) · Progress in Polymer Science · doi:10.1016/j.progpolymsci.2005.06.003 · Cited by 259
Self-citation
Metadata
- Authors
- Zhao, R., & Macosko, C. W.
- Venue
- Journal of Rheology
- Publisher
- Society of Rheology
- Published
- 2002-01-01
- Volume
- 46
- Issue
- 1
- Pages
- 145-167
- ISSN
- 0097-0360 (ISSN-L)
- 0148-6055
- 1520-8516
- OpenAlex
- W2022915118
- Cited by
- 222
- References
- 1
- FWCI
- 12.78
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Slip at polymer–polymer interfaces: Rheological measurements on coextruded multilayers. https://app.cochat.ai/papers/10.1122/1.1427912
- The paper
- Zhao, R., & Macosko, C. W. (2002). Slip at polymer–polymer interfaces: Rheological measurements on coextruded multilayers. Journal of Rheology. https://doi.org/10.1122/1.1427912
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.