The DOI matches its Crossref record.
Chapter 7: Transition from Brittle Fracture to Ductile Flow in Solenhofen Limestone as a Function of Temperature, Confining Pressure, and Interstitial Fluid Pressure
Abstract
More than 115 triaxial compression and extension experiments have been performed on the mechanically isotropic, homogeneous Solenhofen limestone to determine the transition from brittle fracture to ductile flow as a function of temperature, confining pressure, and interstitial fluid pressure. Temperature and confining pressures ranged from 25° to 700°C. and from 1 to 7500 atmospheres; interstitial fluids included water and carbon dioxide. Strain rates remained constant at 10 –4/second. Transitional behavior was arbitrarily defined as that point at which 3–5 per cent strain may be induced without notable loss in cohesion. In dry extension tests, the confining pressure required to induce transitional behavior decreased from 7300 atmospheres at 25°C. to about 700 atmospheres at 700°C. In dry compression tests, the pressure required for the transition was 1000 atmospheres at 25°C., decreasing to 1 atmosphere at 480°C. For transitional behavior in compression tests with interstitial fluids, with increasing confining pressure, the difference between confining pressure and interstitial pressure decreased almost exponentially from 1000 atmospheres at 25°C. and 850 atmospheres at 150°C. to nearly zero at 5000 atmospheres. Data for all stress-strain curves are summarized; most stress-strain curves are plotted and compared for a wide variety of test conditions. From these, plots of transition stress or ultimate stress at transition conditions, maximum and minimum principal stresses, and mean stress are derived and reported as a function of temperature. None of the various theories of strength examined were able to correlate results in compression and extension. The Mohr criterion predicted shear fracture angles within 4° at the brittle-ductile transition for dry compression tests and within 7° for extension tests at temperatures ranging from 25° to 400°C. By applying the Mohr theory, similar angles were predicted within 3° for transitional compression tests with interstitial water at both 25° and 150°C. The geological implications of these experiments are briefly discussed. Even though the experimental strain rate is vastly greater than tectonic strain rates, the qualitative difference observed between compression and extension would probably apply to naturally deformed limestones. The analogy of compression experiments to reverse faulting and of extension experiments to normal faulting is discussed. In the event that strain rate does not affect the brittle-ductile transition, these experiments predict normal faulting of dry limestone to a depth of 15 km and reverse faulting to a depth of 3.5 km. Interstitial fluid pressure would increase the depth to which faulting could occur.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Strength of the lithosphere: Constraints imposed by laboratory experiments
Kohlstedt, D. L., Evans, B., & Mackwell, S. J. (1995) · Journal of Geophysical Research: Solid Earth · doi:10.1029/95jb01460 · Cited by 1,603
The damage mechanics of brittle solids in compression
Ashby, M. F., & Sammis, C. G. (1990) · pure and applied geophysics · doi:10.1007/bf00878002 · Cited by 771
The brittle-ductile transition in porous rock: A review
Wong, T.-F., & Baud, P. (2012) · Journal of Structural Geology · doi:10.1016/j.jsg.2012.07.010 · Cited by 657
Brittle-ductile transition in rocks
Byerlee, J. D. (1968) · Journal of Geophysical Research · doi:10.1029/jb073i014p04741 · Cited by 585
Fossen, H. (2010) · Cambridge University Press eBooks · doi:10.1017/cbo9780511777806 · Cited by 526
A practical guide to rock microstructure
(2005) · Choice Reviews Online · doi:10.5860/choice.42-4665 · Cited by 471
Fossen, H. (2016) · Cambridge University Press eBooks · doi:10.1017/9781107415096 · Cited by 457
Experimental deformation of dry westerly granite
Tullis, J., & Yund, R. A. (1977) · Journal of Geophysical Research · doi:10.1029/jb082i036p05705 · Cited by 419
On the nomenclature of mode of failure transitions in rocks
Rutter, E. H. (1986) · Tectonophysics · doi:10.1016/0040-1951(86)90153-8 · Cited by 383
Evans, B., & Goetze, C. (1979) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb084ib10p05505 · Cited by 357
Carter, N. L. (1976) · Reviews of Geophysics · doi:10.1029/rg014i003p00301 · Cited by 328
Micromechanics of the brittle to plastic transition in Carrara marble
Fredrich, J. T., Evans, B., & Wong, T. (1989) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb094ib04p04129 · Cited by 313
Tectonic stresses in the lithosphere: Constraints provided by the experimental deformation of rocks
Kirby, S. H. (1980) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb085ib11p06353 · Cited by 260
The brittle-ductile transition in rocks: Recent experimental and theoretical progress
Evans, B., Fredrich, J. T., & Wong, T.-F. (1990) · Geophysical Monograph Series · doi:10.1029/gm056p0001 · Cited by 259
Metadata
- Authors
- HEARD, H. C.
- Venue
- Geological Society of America Memoirs
- Publisher
- Geological Society of America
- Published
- 1960-03
- Pages
- 193-226
- ISSN
- 0072-1069
- OpenAlex
- W2339491761
- Cited by
- 321
- References
- 0
- FWCI
- 4.18
- Type
- conference paper
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.