The DOI matches its Crossref record; 25 of the 25 references it cites were found in a registry or an index.
Is Cobalt Needed in Ni-Rich Positive Electrode Materials for Lithium Ion Batteries?
Open accessAbstract
As a derivative of LiNiO 2 , NCA (LiNi 1-x-y Co x Al y O 2 ) is widely used in the electric vehicle industry because of its high energy density. It is thought that Co and Al both play important roles in enhancing NCA material properties. However, there is no solid evidence in the literature that clearly shows that Co is required in NCA with high nickel (e.g. when 1-x-y > 0.9) content. Therefore, a systematic study on the roles of different cation substituents in a series of LiNi 1-n M n O 2 (M = Al, Mn, Mg, or Co) materials was made. In-situ X-ray diffraction (XRD) and differential capacity versus voltage (dQ/dV vs. V) studies showed that the multiple phase transitions in Li x NiO 2 during charge and discharge, thought to cause poor charge-discharge capacity retention, were suppressed in Li x Ni 0.95 M 0.05 O 2 (M = Al, Mn, or Mg), while 5% Co failed to suppress the phase transitions. First principles calculations were made to understand the function of each substituent. Accelerating rate calorimetry shows that unlike Al, Mn, or Mg, Co has no contribution to safety improvement. Therefore, we believe that Co brings little or no value at all to NCA-type materials with high Ni content (> 90% Ni in the transition metal layer) and we hope this paper will spur more interest in Co-free materials.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Efficient iterative schemes for ab initio total-energy calculations using a plane-wave basis set
Kresse, G., & Furthmüller, J. (1996) · Physical Review B · doi:10.1103/physrevb.54.11169 · Cited by 123,652
From ultrasoft pseudopotentials to the projector augmented-wave method
Kresse, G., & Joubert, D. (1999) · Physical Review B · doi:10.1103/physrevb.59.1758 · Cited by 85,307
Kresse, G., & Furthmüller, J. (1996) · Computational Materials Science · doi:10.1016/0927-0256(96)00008-0 · Cited by 75,638
Strongly Constrained and Appropriately Normed Semilocal Density Functional
Sun, J., Ruzsinszky, A., & Perdew, J. P. (2015) · Physical Review Letters · doi:10.1103/physrevlett.115.036402 · Cited by 3,596
Noh, H.-J., Youn, S., Yoon, C. S., & Sun, Y.-K. (2013) · Journal of Power Sources · doi:10.1016/j.jpowsour.2013.01.063 · Cited by 2,302
Ryu, H.-H., Park, K.-J., Yoon, C. S., & Sun, Y.-K. (2018) · Chemistry of Materials · doi:10.1021/acs.chemmater.7b05269 · Cited by 1,629
Reversible anionic redox chemistry in high-capacity layered-oxide electrodes
Sathiya, M., Rousse, G., Ramesha, K., Laisa, C. P., Vezin, H., Sougrati, M. T., Doublet, M.-L., Foix, D., Gonbeau, D., Walker, W., et al. (2013) · Nature Materials · doi:10.1038/nmat3699 · Cited by 1,539
Myung, S.-T., Maglia, F., Park, K.-J., Yoon, C. S., Lamp, P., Kim, S.-J., & Sun, Y.-K. (2017) · ACS Energy Letters · doi:10.1021/acsenergylett.6b00594 · Cited by 1,382
Sun, J., Remsing, R. C., Zhang, Y., Sun, Z., Ruzsinszky, A., Peng, H., Yang, Z., Paul, A., Waghmare, U., Wu, X., et al. (2016) · Nature Chemistry · doi:10.1038/nchem.2535 · Cited by 960
Versatile van der Waals Density Functional Based on a Meta-Generalized Gradient Approximation
Peng, H., Yang, Z.-H., Perdew, J. P., & Sun, J. (2016) · Physical Review X · doi:10.1103/physrevx.6.041005 · Cited by 546
Ohzuku, T., Ueda, A., & Kouguchi, M. (1995) · Journal of The Electrochemical Society · doi:10.1149/1.2048458 · Cited by 445
Characterization and cathode performance of Li1 − xNi1 + xO2 prepared with the excess lithium method
Arai, H. (1995) · Solid State Ionics · doi:10.1016/0167-2738(95)00144-u · Cited by 365
Cobalt-Free Nickel Rich Layered Oxide Cathodes for Lithium-Ion Batteries
Sun, Y.-K., Lee, D.-J., Lee, Y. J., Chen, Z., & Myung, S.-T. (2013) · ACS Applied Materials & Interfaces · doi:10.1021/am403684z · Cited by 296
A Guide to Li-Ion Coin-Cell Electrode Making for Academic Researchers
Marks, T., Trussler, S., Smith, A. J., Xiong, D., & Dahn, J. R. (2011) · Journal of The Electrochemical Society · doi:10.1149/1.3515072 · Cited by 290
Self-citationStructure and electrochemistry of Li Mn Ni1−O2
Rossen, E., Jones, C. D. W., & Dahn, J. R. (1992) · Solid State Ionics · doi:10.1016/0167-2738(92)90164-k · Cited by 282
Self-citationThe Reaction of Charged Cathodes with Nonaqueous Solvents and Electrolytes: I. Li[sub 0.5]CoO[sub 2]
MacNeil, D. D., & Dahn, J. R. (2001) · Journal of The Electrochemical Society · doi:10.1149/1.1407245 · Cited by 273
Self-citationNondilute diffusion from first principles: Li diffusion in Li x TiS 2
der Ven, A. V., Thomas, J. C., Xu, Q., Swoboda, B., & Morgan, D. D. (2008) · Physical Review B · doi:10.1103/physrevb.78.104306 · Cited by 267
Solid‐State Redox Reactions of LiNi1 / 2Co1 / 2 O 2 ( R 3̄m ) for 4 Volt Secondary Lithium Cells
Ueda, A., & Ohzuku, T. (1994) · Journal of The Electrochemical Society · doi:10.1149/1.2055051 · Cited by 204
Electrochemical and Thermal Behavior of LiNi1 − z M z O 2 ( M = Co , Mn , Ti )
Arai, H., Okada, S., Sakurai, Y., & Yamaki, J. (1997) · Journal of The Electrochemical Society · doi:10.1149/1.1837968 · Cited by 194
SCAN+rVV10: A promising van der Waals density functional
Peng, H., Yang, Z.-H., Sun, J., & Perdew, J. P. (2015) · arXiv (Cornell University) · doi:10.48550/arxiv.1510.05712 · Cited by 193
Structural, Electrochemical, and Thermal Properties of Nickel-Rich LiNi x Mn y Co z O 2 Materials
Zhang, N., Li, J., Li, H., Liu, A., Huang, Q., Ma, L., Li, Y., & Dahn, J. R. (2018) · Chemistry of Materials · doi:10.1021/acs.chemmater.8b03827 · Cited by 133
Self-citationLiNi0.5+δMn0.5–δO2—A High‐Rate, High‐Capacity Cathode for Lithium Rechargeable Batteries
Schougaard, S. B., Bréger, J., Jiang, M., Grey, C. P., & Goodenough, J. B. (2006) · Advanced Materials · doi:10.1002/adma.200500113 · Cited by 92
Min, K., Jung, C., Ko, D., Kim, K., Jang, J., Park, K., & Cho, E. (2018) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.8b05648 · Cited by 87
Synthesis and Electrochemical Characterization of Divalent Cation-Incorporated Lithium Nickel Oxide
Chang, C., Kim, J. Y., & Kumta, P. N. (2000) · Journal of The Electrochemical Society · doi:10.1149/1.1393424 · Cited by 71
Chen, T., Gautam, G. S., Huang, W., & Ceder, G. (2017) · Chemistry of Materials · doi:10.1021/acs.chemmater.7b04038 · Cited by 64
Cited by
High-nickel layered oxide cathodes for lithium-based automotive batteries
Li, W., Erickson, E. M., & Manthiram, A. (2020) · Nature Energy · doi:10.1038/s41560-019-0513-0 · Cited by 1,754
Problems and their origins of Ni-rich layered oxide cathode materials
Zhang, S. S. (2020) · Energy Storage Materials · doi:10.1016/j.ensm.2019.08.013 · Cited by 746
Cobalt in lithium-ion batteries
Li, M., & Lu, J. (2020) · Science · doi:10.1126/science.aba9168 · Cited by 532
Toward Green Battery Cells: Perspective on Materials and Technologies
Dühnen, S., Betz, J., Kolek, M., Schmuch, R., Winter, M., & Placke, T. (2020) · Small Methods · doi:10.1002/smtd.202000039 · Cited by 395
Choi, J. U., Voronina, N., Sun, Y., & Myung, S. (2020) · Advanced Energy Materials · doi:10.1002/aenm.202002027 · Cited by 394
Metadata
- Authors
- Li, H., Cormier, M., Zhang, N., Inglis, J., Li, J., & Dahn, J. R.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 2019
- Volume
- 166
- Issue
- 4
- Pages
- A429-A439
- ISSN
- 0013-4651 (ISSN-L)
- 1945-7111
- OpenAlex
- W2913840015
- Cited by
- 343
- References
- 25
- FWCI
- 18.06
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.