The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
Effect of sulphur containing additive on initial corrosion of superheater tubes in waste fired boiler
Abstract
The major drawback to generating electricity from waste fired boilers is the rapid corrosion of superheaters which increases the maintenance costs. Within the last few years, it has been shown that additions of ammonium sulphate to biomass fired boilers decrease the corrosion tendencies. This paper reports on the effects of ammonium sulphate on corrosion in a waste fired CFB boiler. Air cooled probes were exposed at a position corresponding to the one of superheater tubes. The probe temperature was 500°C, corresponding to a steam temperature of ∼450°C. Both the austenitic steel EN1·4301 (Fe–18Cr–9Ni) and the low alloyed ferritic steel EN1·7380 (Fe–2·25Cr–1Mo) were tested. During exposure, the concentration of alkali chlorides in the flue gas was measured and a decrease was observed when adding ammonium sulphate. After 4 h of exposure, the probes were removed for detailed analysis with SEM-EDS, TOF-SIMS and XRD. The sides of the tubes facing the flue gas were covered with a calcium rich deposit, while relatively more sodium and potassium were present on the lee side. The results also show that ammonium sulphate shifted the deposit composition from chloride rich and highly corrosive, to one significantly less corrosive and dominated by sulphates of sodium, potassium and calcium. Metallography shows a marked difference in corrosion attack between the two steels. Iron chlorides accumulate at the metal/oxide interface of the ferritic steel, while the amounts of iron chlorides were significantly lower in the austenitic steel. These results indicate that ammonium sulphate has the potential to reduce corrosion in waste fired boilers and that austenitic stainless steels are more likely to resist corrosion in these environments than low alloyed ferritic steels.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Ash deposition during biomass and coal combustion: A mechanistic approach
Baxter, L. L. (1993) · Biomass and Bioenergy · doi:10.1016/0961-9534(93)90031-x · Cited by 429
Pettersson, C., Pettersson, J., Asteman, H., Svensson, J.-E., & Johansson, L.-G. (2006) · Corrosion Science · doi:10.1016/j.corsci.2005.05.018 · Cited by 112
Reducing superheater corrosion in wood‐fired boilers
Henderson, P., Szakálos, P., Pettersson, R., Andersson, C., & Högberg, J. (2006) · Materials and Corrosion · doi:10.1002/maco.200503899 · Cited by 87
Self-citation
Cited by
Ma, W., Wenga, T., Frandsen, F. J., Yan, B., & Chen, G. (2020) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2019.100789 · Cited by 275
Karlsson, S., Åmand, L.-E., & Liske, J. (2015) · Fuel · doi:10.1016/j.fuel.2014.09.007 · Cited by 79
Hot corrosion behaviour of HVOF-sprayed Cr 3 C 2 -NiCrMoNbAl coating
Zhou, W., Zhou, K., Deng, C., Zeng, K., & Li, Y. (2017) · Surface and Coatings Technology · doi:10.1016/j.surfcoat.2016.10.076 · Cited by 62
Corrosion Problems in Incinerators and Biomass-Fuel-Fired Boilers
Mudgal, D., Singh, S., & Prakash, S. (2014) · International Journal of Corrosion · doi:10.1155/2014/505306 · Cited by 56
Continuous KCl addition in high temperature exposures of 304 L – A way to mimic a boiler environment
Phother-Simon, J., Jonsson, T., & Liske, J. (2020) · Corrosion Science · doi:10.1016/j.corsci.2020.108511 · Cited by 25
Metadata
- Authors
- Viklund, P., Pettersson, R., Hjörnhede, A., Henderson, P., & Sjövall, P.
- Venue
- Corrosion Engineering, Science and Technology
- Publisher
- SAGE Publications
- Published
- 2009-06
- Volume
- 44
- Issue
- 3
- Pages
- 234-240
- ISSN
- 1478-422X (ISSN-L)
- 1743-2782
- OpenAlex
- W1969659958
- Cited by
- 37
- References
- 3
- FWCI
- 2.58
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Effect of sulphur containing additive on initial corrosion of superheater tubes in waste fired boiler. https://app.cochat.ai/papers/10.1179/174327809x419203
- The paper
- Viklund, P., Pettersson, R., Hjörnhede, A., Henderson, P., & Sjövall, P. (2009). Effect of sulphur containing additive on initial corrosion of superheater tubes in waste fired boiler. Corrosion Engineering, Science and Technology. https://doi.org/10.1179/174327809x419203
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.