Hydrodynamic force and moment in pure rolling lubricated contacts. Part 2: Point contacts
The DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.
Abstract
Hydrodynamic rolling force and moments in point contact have been studied in detail using isoviscousrigid (IVR) and elastohydrodynamic (EHL) models. Using fully flooded assumptions, curve-fitted relationships are given for calculating the IVR and EHL hydrodynamic rolling forces. Both are proportional (or almost proportional in the IVR case) to 2 a, the Hertzian contact length being perpendicular to the rolling direction, and are also functions of the dimensionless speed parameter. A single curve-fitted relationship has been derived to cover the full range of operating conditions with a smooth transition from IVR to EHL regime of lubrication. The results obtained are slightly higher than those previously published (the ratio being of the order of 1.5 for usual operating conditions). Point contact and line contact (with a contact length £ being equal to the point contact length 2 a) hydrodynamic rolling forces have also been compared. The point contact forces are about 26 per cent larger than those obtained using line contact relationship (published in part 1) because of a larger domain of integration in the lateral direction. By limiting the width of the integration domain to £ (roller length or ball diameter), the effect of 2 a/£ on the hydrodynamic rolling force has been studied, leading to the derivation of a truncation factor C. As the load increases, 2 a increases and the truncation factor decreases until reaching a limit when ellipse truncation starts because 2 a/£ is equal to or larger than one. Using the truncation factor and limiting the 2 a/£ ratio to one, it was found that point contact and line contact hydrodynamic forces are the same within a few per cent. A single point contact relationship can therefore be suggested, covering the IVR to EHL operating conditions with a smooth transition between these lubrication regimes, and also a smooth transition from point contact to line contact as the load increases and contact ellipse truncation occurs. Finally, calculations of power losses due to the Poiseuille flow in the rolling direction x and in the perpendicular direction z show that the power loss in the z direction is usually very small for wide elliptical contacts and that most of the power is dissipated in the inlet and outlet, with a 26 per cent contribution of the integration domain defined out the range − a < z < a. This result is in line with the truncation factor defined previously.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“According to an order-of-magnitude analysis in [63], the EHL rolling friction can be approximated using the pure-rolling EHL traction, which is due to pressure-induced viscous shear (Poiseuille flow) in the fluid film.”
From Enhancing practical modeling: A neural network approach for locally-resolved prediction of elastohydrodynamic line contacts (2024) · cites this paper as [63]
Citations
Cites
Isothermal Elastohydrodynamic Lubrication of Point Contacts: Part III—Fully Flooded Results
Hamrock, B. J., & Dowson, D. (1977) · Journal of Lubrication Technology · doi:10.1115/1.3453074 · Cited by 1,183
Elasto-hydrodynamic lubrication : the fundamentals of roller and gear lubrication
Dowson, D., & Higginson, G. R. (1966) · Pergamon Press eBooks · Cited by 573
Multilevel Methods in Lubrication
Jacobson, B. (2001) · Tribology International · doi:10.1016/s0301-679x(01)00031-7 · Cited by 201
An Engineering Approach to Hertzian Contact Elasticity—Part I
Houpert, L. (2000) · Journal of Tribology · doi:10.1115/1.1308043 · Cited by 132
Self-citationThe Influence of Fluid Rheology on the Performance of Traction Drives
Tevaarwerk, J. L., & Johnson, K. L. (1979) · Journal of Lubrication Technology · doi:10.1115/1.3453346 · Cited by 104
Simplified Solution for Stresses and Deformations
Hamrock, B. J., & Brewe, D. E. (1983) · Journal of Lubrication Technology · doi:10.1115/1.3254558 · Cited by 84
Houpert, L. (1987) · Journal of Tribology · doi:10.1115/1.3261367 · Cited by 51
Self-citationAnalysis of Starvation Effects on Hydrodynamic Lubrication in Nonconforming Contacts
Brewe, D. E., & Hamrock, B. J. (1982) · Journal of Lubrication Technology · doi:10.1115/1.3253237 · Cited by 31
Research works printed but not linked: 2
- Dalmaz G. Le film mince visqueux dans les contacts hertziens en régimes hydrodynamique et élastohydrodynamique Docteur d'Etat Es Science thesis, no. I-DE-7907, INSA-Lyon, 1979.
- Dowson D., Elastohydrodynamic lubrication, the fundamentals of roller and gear lubrication
Cited by
Numerical investigation of the air–oil two-phase flow inside an oil-jet lubricated ball bearing
Hu, J., Wu, W., Wu, M., & Yuan, S. (2013) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2013.09.013 · Cited by 112
The influence of the lubricant viscosity on the rolling friction torque
Bălan, M. R. D., Stamate, V. C., Houpert, L., & Olaru, D. N. (2013) · Tribology International · doi:10.1016/j.triboint.2013.11.017 · Cited by 59
Self-citationA Dynamic Analysis of Cage Instability in Ball Bearings
Nogi, T., Maniwa, K., & Matsuoka, N. (2017) · Journal of Tribology · doi:10.1115/1.4036451 · Cited by 58
Oh, K.-J., Cao, L., & Chung, S.-C. (2019) · Tribology International · doi:10.1016/j.triboint.2019.105841 · Cited by 52
A simulation analysis for lubricating characteristics of an oil-jet lubricated ball bearing
Liu, J., Ni, H., Xu, Z., & Pan, G. (2021) · Simulation Modelling Practice and Theory · doi:10.1016/j.simpat.2021.102371 · Cited by 50
Metadata
- Authors
- Biboulet, N., & Houpert, L.
- Affiliations
- TIMKEN Europe, Colmar, France
- Venue
- Proceedings of the Institution of Mechanical Engineers Part J Journal of Engineering Tribology
- Publisher
- SAGE Publications
- Published
- 2010-05-14
- Volume
- 224
- Issue
- 8
- Pages
- 777-787
- ISSN
- 1350-6501 (ISSN-L)
- 2041-305X
- OpenAlex
- W4247538131
- Cited by
- 51
- References
- 8
- Citations by year
- 2026: 6 · 2025: 2 · 2024: 8 · 2023: 4 · 2022: 2 · 2021: 2 · 2020: 5 · 2019: 2 · 2018: 1 · 2017: 2 · 2016: 4 · 2015: 6 · 2014: 2 · 2013: 3 · 2012: 1
- FWCI
- 3.04
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- journals.sagepub.com/page/policies/text-and-data-mining-license (tdm)
- Locations
- Proceedings of the Institution of Mechanical Engineers Part J Journal of Engineering Tribology (publishedVersion)
- HAL (submittedVersion)
- Topics
- Physical Sciences › Engineering › Mechanical Engineering › Tribology and Lubrication Engineering
- Physical Sciences › Engineering › Mechanical Engineering › Gear and Bearing Dynamics Analysis
- Physical Sciences › Engineering › Mechanics of Materials › Adhesion, Friction, and Surface Interactions
- Keywords
- hydrodynamic moments, point contacts, line contact, elastohydrodynamic lubrication
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Hydrodynamic force and moment in pure rolling lubricated contacts. Part 2: Point contacts. https://app.cochat.ai/papers/10.1243/13506501jet791
- The paper
- Biboulet, N., & Houpert, L. (2010). Hydrodynamic force and moment in pure rolling lubricated contacts. Part 2: Point contacts. Proceedings of the Institution of Mechanical Engineers Part J Journal of Engineering Tribology. https://doi.org/10.1243/13506501jet791
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.