The DOI matches its Crossref record.
Sediment Gravity Flows: II Depositional Models with Special Reference to the Deposits of High-Density Turbidity Currents
Abstract
Abstract Four principal mechanisms of deposition are effective in the formation of sediment gravity flow deposits. Grains deposited by traction sedimentation and suspension sedimentation respond individually and accumulate directly from bed and suspended loads, respectively. Those deposited by frictional freezing and cohesive freezing interact through either frictional contact or cohesive forces, respectively, and are deposited collectively, usually by plug formation. Sediment deposition from individual sediment flows commonly involves more than one of these mechanisms acting either serially as the flow evolves or simultaneously on different grain populations. Deposition from turbidity currents is treated in terms of three dynamic grain populations: 1) clay- to medium-grained sand-sized particles that can be fully suspended as individual grains by flow turbulence, 2) coarse-grained sand to small-pebble-sized gravel that can be fully suspended in large amounts mainly in highly concentrated turbulent suspensions where grain fall velocity is substantially reduced by hindered settling, and 3) pebble- and cobble-sized clasts having concentrations greater than 10 percent to 15 percent that will be supported largely by dispersive pressure resulting from clast collisions and by buoyant lift provided by the interstitial mixture of water and finer-grained sediment. The effects of hindered settling, dispersive pressure, and matrix buoyant lift are concentration dependent, and grain populations 2 and 3 are likely to be transported in large amounts only within flows having high particle concentrations, probably in excess of 20 percent solids by volume. Low-density turbidity currents, made up largely of grains of population 1, typically show an initial period of traction sedimentation, forming Bouma (T b ) and T c ) divisions, followed by one of mixed traction and suspension sedimentation (T d ), and a terminal period of fine-grained suspension sedimentation (T e ). The sediment loads of high-density turbidity currents commonly include grains belonging to populations 1, 2, and 3. Consequently, deposition often occurs as a series of discrete sedimentation waves as flows decelerate and individual grain populations can no longer be maintained in transport. Each sedimentation wave tends to show increasing unsteadiness and accelerating sedimentation rate as it evolves, passing from an initial stage of traction sedimentation, to one of mixed frictional freezing and suspension sedimentation within traction carpets, to a final stage of direct suspension sedimentation. Sequences of sedimentary structure divisions representing this succession of depositional stages are here termed the ecoR (sub 1-3) ) sequence, representing population 3 grains, and the (S (sub 1-3) ) sequence, representing population 2. Deposition of the high-density suspended load leaves behind a residual low-density turbidity current composed largely of population 1 grains. At their distal ends, high-density turbidity currents deposit mainly by suspension sedimentation, forming thin (S 3 ) divisions. These (S 3 ) divisions are the same as Bouma (T a ) and, if subsequently capped by (T (sub b-e) ) deposited by the residual low-density flows, become the basal divisions of normal turbidities. Liquefied flows deposit by direct high-density suspension sedimentation. Grain flows of sand are characterized by frictional freezing and their deposits are limited mainly to angle-of-repose slipface units. Density-modified grain flows, in which larger clasts are partially supported by matrix buoyancy, and traction carpets, in which a dense frictional grain dispersion is driven by an overlying turbulent flow, are important in the buildup of natural deposits on submarine slopes. Cohesive debris flows depost sediment mainly by cohesive freezing, commonly modified by suspension sedimentation of the largest clasts.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Turbidity Currents Generated at River Mouths during Exceptional Discharges to the World Oceans
Mulder, T., & Syvitski, J. P. M. (1995) · The Journal of Geology · doi:10.1086/629747 · Cited by 894
Kane, I. A., & Clare, M. A. (2019) · Frontiers in Earth Science · doi:10.3389/feart.2019.00080 · Cited by 476
Krapež, B., Barley, M. E., & Pickard, A. L. (2003) · Sedimentology · doi:10.1046/j.1365-3091.2003.00594.x · Cited by 216
Belousov, A., Voight, B., & Belousova, M. (2007) · Bulletin of Volcanology · doi:10.1007/s00445-006-0109-y · Cited by 178
Mueller, W. U., & Corcoran, P. L. (2001) · Sedimentary Geology · doi:10.1016/s0037-0738(01)00074-4 · Cited by 31
Metadata
- Authors
- Lowe, D. R.
- Venue
- SEPM Journal of Sedimentary Research
- Publisher
- Society for Sedimentary Geology
- Published
- 1982
- Volume
- Vol. 52
- Issue
- 1
- Pages
- 279-297
- ISSN
- 0022-4472 (ISSN-L)
- 1527-1404
- OpenAlex
- W2087125749
- Cited by
- 2,471
- References
- 0
- FWCI
- 37.26
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Sediment Gravity Flows: II Depositional Models with Special Reference to the Deposits of High-Density Turbidity Currents. https://app.cochat.ai/papers/10.1306/212f7f31-2b24-11d7-8648000102c1865d
- The paper
- Lowe, D. R. (1982). Sediment Gravity Flows: II Depositional Models with Special Reference to the Deposits of High-Density Turbidity Currents. SEPM Journal of Sedimentary Research. https://doi.org/10.1306/212f7f31-2b24-11d7-8648000102c1865d
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.