CoChat

Production of methane and ethylene from plastic in the environment

Open access

The DOI matches its Crossref record; 40 of the 40 references it cites were found in a registry or an index.

Abstract

Mass production of plastics started nearly 70 years ago and the production rate is expected to double over the next two decades. While serving many applications because of their durability, stability and low cost, plastics have deleterious effects on the environment. Plastic is known to release a variety of chemicals during degradation, which has a negative impact on biota. Here, we show that the most commonly used plastics produce two greenhouse gases, methane and ethylene, when exposed to ambient solar radiation. Polyethylene, which is the most produced and discarded synthetic polymer globally, is the most prolific emitter of both gases. We demonstrate that the production of trace gases from virgin low-density polyethylene increase with time, with rates at the end of a 212-day incubation of 5.8 nmol g-1 d-1 of methane, 14.5 nmol g-1 d-1 of ethylene, 3.9 nmol g-1 d-1 of ethane and 9.7 nmol g-1 d-1 of propylene. Environmentally aged plastics incubated in water for at least 152 days also produced hydrocarbon gases. In addition, low-density polyethylene emits these gases when incubated in air at rates ~2 times and ~76 times higher than when incubated in water for methane and ethylene, respectively. Our results show that plastics represent a heretofore unrecognized source of climate-relevant trace gases that are expected to increase as more plastic is produced and accumulated in the environment.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1371/journal.pone.0200574

Cites

40 of 40 references verified0 citation errors · 0 not checkable

Statistics

Figures

Fig 1 Gas production from LDPE exposed to ambient solar radiation and identification of plastic collected in the open ocean. The cumulative amount of hydrocarbon gases normalized to weight and production rates of CH4, C2H4, C2H6 and C3H6 from (A) & (C) virgin LDPE pellets (0.2 g) and (B) & (D) LDPE plastic pieces (0.2 g) collected from the open ocean. Measurements were taken at approximately two-week intervals during the incubation period. Error bars represent the error propagation of the standard deviation of the mean for each time point. Panel (E) represents the micro-Raman spectra for the aged LDPE collected in the open ocean (red) and the virgin LDPE pellets (blue).
Fig 1 Gas production from LDPE exposed to ambient solar radiation and identification of plastic collected in the open ocean. The cumulative amount of hydrocarbon gases normalized to weight and production rates of CH4, C2H4, C2H6 and C3H6 from (A) & (C) virgin LDPE pellets (0.2 g) and (B) & (D) LDPE plastic pieces (0.2 g) collected from the open ocean. Measurements were taken at approximately two-week intervals during the incubation period. Error bars represent the error propagation of the standard deviation of the mean for each time point. Panel (E) represents the micro-Raman spectra for the aged LDPE collected in the open ocean (red) and the virgin LDPE pellets (blue).CC BY · PubMed Central
Fig 2 Production rates of CH4 and C2H4 from virgin LDPE pellets exposed to sunlight in air. Mean production rates of CH4 (A) and C2H4 (B) from LDPE virgin pellets incubated in air under ambient solar radiation for 1, 3, 9 and 17 days. The error bars represent the standard deviation of triplicate samples. The emission of CH4 in the dark treatment was below the detection limit and less than 0.3 nmol g-1d-1 for C2H4. The black arrow indicates the production rate of CH4 and C2H4 from virgin LDPE pellets incubated in MilliQ water for 14 days (Fig 1).
Fig 2 Production rates of CH4 and C2H4 from virgin LDPE pellets exposed to sunlight in air. Mean production rates of CH4 (A) and C2H4 (B) from LDPE virgin pellets incubated in air under ambient solar radiation for 1, 3, 9 and 17 days. The error bars represent the standard deviation of triplicate samples. The emission of CH4 in the dark treatment was below the detection limit and less than 0.3 nmol g-1d-1 for C2H4. The black arrow indicates the production rate of CH4 and C2H4 from virgin LDPE pellets incubated in MilliQ water for 14 days (Fig 1).CC BY · PubMed Central
Fig 3 Effect of spectral irradiance on hydrocarbon gas production from LDPE. Production rates of hydrocarbon gases (CH4, C2H4, C2H6 and C3H6) from virgin LDPE pellets kept in the dark, exposed to full solar radiation (280–700 nm) or to solar radiation filtered for UVB (320–700 nm). Error bars represent the standard deviation of triplicate samples.
Fig 3 Effect of spectral irradiance on hydrocarbon gas production from LDPE. Production rates of hydrocarbon gases (CH4, C2H4, C2H6 and C3H6) from virgin LDPE pellets kept in the dark, exposed to full solar radiation (280–700 nm) or to solar radiation filtered for UVB (320–700 nm). Error bars represent the standard deviation of triplicate samples.CC BY · PubMed Central

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Research works printed but not linked: 2

  1. CL Beyler, 2001, Thermal decomposition of polymers, SPE Handbook of Fire Protection Engineering, 111
  2. C Arthur, 2009, Proceedings of the international research workshop on the occurrence, effects, and fate of microplastic marine debris, NOAA Tech Memo NOS-OR&R-30, 530

Cited by

See all 572

Metadata

Authors
Royer, S.-J., Ferrón, S., Wilson, S. T., & Karl, D. M.
Affiliations
University of Hawaiʻi at Mānoa (US)
Corresponding author
  • Royer, Sarah-Jeanne
  • Ferrón, Sara
  • Wilson, Samuel T.
  • Karl, David M.
Venue
PLOS ONE
Published
2018-08-01
Volume
13
Issue
8
Pages
e0200574
ISSN
1932-6203 (ISSN-L)
OpenAlex
W2885548680
Cited by
572
References
40
Citations by year
2026: 38 · 2025: 68 · 2024: 111 · 2023: 92 · 2022: 94 · 2021: 72 · 2020: 58 · 2019: 31 · 2018: 6
FWCI
15.65
Type
journal article
Language
en
Open access
Locations
  • PLoS ONE (publishedVersion, cc-by)
  • Europe PMC (PubMed Central) (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
  • Newcastle University ePrints (Newcastle Univesity) (cc-by)
Funders
  • National Foundation for Science and Technology Development (DBI-0424599, OCE-1260164)
  • Simons Foundation (329108)
  • Balzan Prize for Oceanography
  • Gordon and Betty Moore Foundation’s Marine Microbiology Initiative (3794)
Topics
  • Physical Sciences › Environmental Science › Pollution › Microplastics and Plastic Pollution
  • Physical Sciences › Environmental Science › Global and Planetary Change › Atmospheric and Environmental Gas Dynamics
  • Physical Sciences › Materials Science › Polymers and Plastics › Polymer Science and PVC
Keywords
plastic degradation, low-density polyethylene, methane emissions, ethylene release, greenhouse gases, trace gases, solar radiation, plastic waste, hydrocarbon emissions, plastic pollution
MeSH terms
Ethylenes, Hydrocarbons, Methane, Plastics, Sunlight, Polyethylene

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.