CoChat

Raman characterization of synthetic magnesian calcites

The DOI matches its Crossref record; 46 of the 48 references it cites were found in a registry or an index.

Abstract

Magnesian calcites are important components of sediments and biominerals. Although Raman spectra of calcite, dolomite, and magnesite are well known, those of magnesian calcites deserve further investigation. Nineteen syntheses of magnesian calcites covering the range 0–50 mol% MgCO 3 have been carried out at high pressure and temperature (1–1.5 GPa, 1000–1100 ℃). The crystalline run products have been characterized by μ-Raman spectroscopy. For all lattice and internal modes (L, T, ν 1 , ν 4 , 2ν 2 ) but ν 3 , wavenumbers align closer to the calcite– dolomite line than the calcite–magnesite line. The compositional dependence is strong and regression curves with high correlation coefficients have been determined. Full-width at half maximum (FWHM) plot along parabolas that depart from the calcite–dolomite or calcite–magnesite lines. The limited data dispersion of both shifts and FWHM allow using Raman spectral properties of magnesian calcites to determine the Mg content of abiotic calcites. A comparison with Raman data from the literature obtained on synthetic magnesian amorphous calcium carbonate (Mg ACC) shows that the wavenumber position of the ACC ν 1 mode is systematically shifted toward lower values, and that their FWHM are higher than those of their crystalline counterparts. The FWHM parameters of crystalline and amorphous materials do not overlap, which allows a clear-cut distinction between crystalline and amorphous materials. In synthetic magnesian calcites, the shift and FWHM of Raman bands as a function of magnesium can be interpreted in terms of changes of metal-O bond lengths resulting from the replacement of calcium by magnesium. The facts that the wavenumber of magnesian calcites are close to the calcite–dolomite line (not calcite-magnesite), that the FWHM of the T, L, and ν 4 modes reach a maximum around 30 ±5 mol% MgCO 3 , and that a peak specific to dolomite at 880 cm –1 is observed in high-magnesian calcites indicate that dolomite-like ordering is present above ~10 mol% MgCO 3 . Mg atom clustering in cation layers combined with ordering in successive cation basal layers may account for the progressive ordering observed in synthetic magnesian calcites.

Overview

Integrity signals

Registry

Crossref · 10.2138/am-2016-5714

Cites

46 of 46 references verified0 citation errors · 0 not checkable

Statistics

Recomputing p-values needs the paper’s full text.

Verification

Claims the paper makes

This paper’s full text isn’t openly available, so its claims and self-check weren’t run. The registry and citation checks still apply.

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Citations

Cites

Show all 46 references

Cited by

See all 89

Metadata

Authors
Perrin, J., Vielzeuf, D., Laporte, D., Ricolleau, A., Rossman, G. R., & Floquet, N.
Affiliations
  • Centre National de la Recherche Scientifique (FR)
  • California Institute of Technology (US)
Corresponding author
Perrin, Jonathan
Venue
American Mineralogist
Published
2016-11
Volume
101
Issue
11
Pages
2525-2538
ISSN
0003-004X (ISSN-L)
OpenAlex
W2547316874
Cited by
82
References
48
Citations by year
2026: 7 · 2025: 6 · 2024: 5 · 2023: 15 · 2022: 12 · 2021: 4 · 2020: 10 · 2019: 11 · 2018: 8 · 2017: 4
FWCI
3.14
Type
journal article
Language
en
Open access
closed
Locations
  • American Mineralogist (publishedVersion)
  • CaltechAUTHORS (California Institute of Technology) (submittedVersion)
  • HAL (submittedVersion)
Funders
Agence Nationale de la Recherche (ANR-11-IDEX-0001, ANR-11-LABX-0053)
Topics
  • Physical Sciences › Materials Science › Biomaterials › Calcium Carbonate Crystallization and Inhibition
  • Physical Sciences › Earth and Planetary Sciences › Geochemistry and Petrology › Mineralogy and Gemology Studies
  • Physical Sciences › Earth and Planetary Sciences › Geochemistry and Petrology › Geochemistry and Elemental Analysis
Keywords
magnesian calcite, Raman spectra, magnesium carbonate, amorphous calcium carbonate, cation ordering, high-pressure synthesis, biominerals, sediment minerals

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Raman characterization of synthetic magnesian calcites. https://app.cochat.ai/papers/10.2138/am-2016-5714
The paper
Perrin, J., Vielzeuf, D., Laporte, D., Ricolleau, A., Rossman, G. R., & Floquet, N. (2016). Raman characterization of synthetic magnesian calcites. American Mineralogist. https://doi.org/10.2138/am-2016-5714

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.