The DOI matches its Crossref record; 6 of the 6 references it cites were found in a registry or an index.
Effective Inflow Conditions for Turbulence Models in Aerodynamic Calculations
Open accessAbstract
The selection of inflow values at boundaries far upstream of an aircraft is considered, for one- and two-equation turbulence models. Inflow values are distinguished from the ambient values near the aircraft, which may be much smaller. Ambient values should be selected first, and inflow values that will lead to them after the decay second; this is not always possible, especially for the time scale. The two-equation decay during the approach to the aircraft is shown; often, the time scale has been set too short for this decay to be calculated accurately on typical grids. A simple remedy for both issues is to impose floor values for the turbulence variables, outside the viscous sublayer, and it is argued that overriding the equations in this manner is physically justified. Selecting laminar ambient values is easy, if the boundary layers are to be tripped, but a more common practice is to seek ambient values that will cause immediate transition in boundary layers. This opens up a wide range of values, and selection criteria are discussed. The turbulent Reynolds number, or ratio of eddy viscosity to laminar viscosity has a huge dynamic range that makes it unwieldy; it has been widely mis-used, particularly by codes that set upper limits on it. The value of turbulent kinetic energy in a wind tunnel or the atmosphere is also of dubious value as an input to the model. Concretely, the ambient eddy viscosity must be small enough to preserve potential cores in small geometry features, such as flap gaps. The ambient frequency scale should also be small enough, compared with shear rates in the boundary layer. Specific values are recommended and demonstrated for airfoil flows
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Two-equation eddy-viscosity turbulence models for engineering applications
Menter, F. R. (1994) · AIAA Journal · doi:10.2514/3.12149 · Cited by 21,593
A one-equation turbulence model for aerodynamic flows
SPALART, P., & ALLMARAS, S. (1992) · 30th Aerospace Sciences Meeting and Exhibit · doi:10.2514/6.1992-439 · Cited by 9,499
Self-citationWilcox, D. C. (1993) · Infoscience (Ecole Polytechnique Fédérale de Lausanne) · Cited by 7,475
Influence of freestream values on k-omega turbulence model predictions
Menter, F. R. (1992) · AIAA Journal · doi:10.2514/3.11115 · Cited by 426
Eddy Viscosity Transport Equations and Their Relation to the k-ε Model
Menter, F. R. (1997) · Journal of Fluids Engineering · doi:10.1115/1.2819511 · Cited by 355
Apparent transition behavior of widely-used turbulence models
Rumsey, C. L. (2007) · International Journal of Heat and Fluid Flow · doi:10.1016/j.ijheatfluidflow.2007.04.003 · Cited by 142
Self-citation
Cited by
Data-Driven Aerospace Engineering: Reframing the Industry with Machine Learning
Brunton, S. L., Nathan Kutz, J., Manohar, K., Aravkin, A. Y., Morgansen, K., Klemisch, J., Goebel, N., Buttrick, J., Poskin, J., Blom-Schieber, A. W., et al. (2021) · AIAA Journal · doi:10.2514/1.j060131 · Cited by 270
Metadata
- Authors
- Spalart, P. R., & Rumsey, C. L.
- Venue
- AIAA Journal
- Published
- 2007-10
- Volume
- 45
- Issue
- 10
- Pages
- 2544-2553
- ISSN
- 0001-1452 (ISSN-L)
- 1533-385X
- OpenAlex
- W1979787043
- Cited by
- 523
- References
- 6
- FWCI
- 8.07
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Effective Inflow Conditions for Turbulence Models in Aerodynamic Calculations. https://app.cochat.ai/papers/10.2514/1.29373
- The paper
- Spalart, P. R., & Rumsey, C. L. (2007). Effective Inflow Conditions for Turbulence Models in Aerodynamic Calculations. AIAA Journal. https://doi.org/10.2514/1.29373
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.