Flow Loop Experiments Using Polyalphaolefin Nanofluids
The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Abstract
Experiments were performed using a flow-loop apparatus to explore the performance of nanofluids in cooling applications. The experiments were performed using exfoliated graphite nanoparticle fibers suspended in polyalphaolefin at mass concentrations of 0.6 and 0.3 %. The experimental setup consisted of a test section containing a plain offset fin cooler apparatus (gap or nongap fin), which was connected to a flow loop consisting of a gear pump, a shell and tube heat exchanger (that was cooled or heated by a constant temperature bath chiller/heater), and a reservoir. Experiments were conducted using nanofluid and polyalphaolefin for two different fin strip layouts. Heat transfer data were obtained by parametrically varying the operating conditions (heat flux and flow rates). The heat transfer data for nanofluids were compared with the heat transfer data for neat polyalphaolefin fluid under similar conditions. The change in surface morphology of the fins was investigated using scanning electron micrography. The nanofluid properties were measured using rheometry for the viscosity, differential scanning calorimetry for the specific heat, and laser flash apparatus for the thermal diffusivity. It was observed that the viscosity was ∼10 times higher for nanofluids compared with polyalphaolefin and increased with temperature (in contrast, the viscosity of polyalphaolefin decreased with temperature). The specific heat of nanofluids was found to be 50% higher for nanofluids compared with polyalphaolefin and increased with temperature. The thermal diffusivity was found to be 4 times higher for nanofluids compared with polyalphaolefin and increased with temperature. It was found that, in general, the convective heat transfer was enhanced by ∼10% using nanofluids compared with using polyalphaolefin. Scanning electron micrography measurements show that the nanofluids deposit nanoparticles on the surface, which act as enhanced heat transfer surfaces (nanofins).
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Thermal Conductivity of Heterogeneous Two-Component Systems
Hamilton, R. L., & Crosser, O. K. (1962) · Industrial & Engineering Chemistry Fundamentals · doi:10.1021/i160003a005 · Cited by 3,672
Cited by
A Review on Nanofluids: Preparation, Stability Mechanisms, and Applications
Yu, W., & Xie, H. (2012) · Journal of Nanomaterials · doi:10.1155/2012/435873 · Cited by 1,770
Shin, D., & Banerjee, D. (2011) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2010.11.017 · Cited by 534
Self-citationReview on thermal properties of nanofluids: Recent developments
Angayarkanni, S. A., & Philip, J. (2015) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2015.08.014 · Cited by 492
A review on the applications of nanofluids in solar energy systems
Kasaeian, A., Eshghi, A. T., & Sameti, M. (2015) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2014.11.020 · Cited by 384
Chieruzzi, M., Cerritelli, G. F., Miliozzi, A., & Kenny, J. M. (2013) · Nanoscale Research Letters · doi:10.1186/1556-276x-8-448 · Cited by 381
“However, research work on the specific heat of nanofluids has been limited compared to that on thermal conductivity especially those prepared by adding nanoparticles [21,25-29].”
Background
Metadata
- Authors
- Nelson, I. C., Banerjee, D., & Ponnappan, R.
- Venue
- Journal of Thermophysics and Heat Transfer
- Published
- 2009-10
- Volume
- 23
- Issue
- 4
- Pages
- 752-761
- ISSN
- 0887-8722 (ISSN-L)
- 1533-6808
- OpenAlex
- W1989775759
- Cited by
- 140
- References
- 1
- FWCI
- 5.24
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.