Effect of nanoparticles on heat capacity of nanofluids based on molten salts as PCM for thermal energy storage
Open accessThe DOI matches its Crossref record; 55 of the 56 references it cites were found in a registry or an index.
Abstract
In this study, different nanofluids with phase change behavior were developed by mixing a molten salt base fluid (selected as phase change material) with nanoparticles using the direct-synthesis method. The thermal properties of the nanofluids obtained were investigated. These nanofluids can be used in concentrating solar plants with a reduction of storage material if an improvement in the specific heat is achieved. The base salt mixture was a NaNO3-KNO3 (60:40 ratio) binary salt. The nanoparticles used were silica (SiO2), alumina (Al2O3), titania (TiO2), and a mix of silica-alumina (SiO2-Al2O3). Three weight fractions were evaluated: 0.5, 1.0, and 1.5 wt.%. Each nanofluid was prepared in water solution, sonicated, and evaporated. Measurements on thermophysical properties were performed by differential scanning calorimetry analysis and the dispersion of the nanoparticles was analyzed by scanning electron microscopy (SEM). The results obtained show that the addition of 1.0 wt.% of nanoparticles to the base salt increases the specific heat of 15% to 57% in the solid phase and of 1% to 22% in the liquid phase. In particular, this research shows that the addition of silica-alumina nanoparticles has a significant potential for enhancing the thermal storage characteristics of the NaNO3-KNO3 binary salt. These results deviated from the predictions of the theoretical model used. SEM suggests a greater interaction between these nanoparticles and the salt.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Figures






Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The cited source says what the claim attributes to it.
In the citing paper
“All of the NPs reduced the onset and melting temperatures of the PCM.”
From Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review (2021) · cites this paper as [66]
The cited source says what the claim attributes to it.
In the citing paper
“The NPs also increased the specific heat and heat of fusion.”
From Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review (2021) · cites this paper as [66]
The cited source says what the claim attributes to it.
In the citing paper
“The 1.0 wt % concentration was the most effective by far, as were the SiO 2 -Al 2 O 3 NPs, although the other types of NPs were also effective [66].”
From Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review (2021) · cites this paper as [66]
The cited source says what the claim attributes to it.
In the citing paper
“1.0 wt % SiO 2 -Al 2 O 3 were the most effective”
From Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review (2021) · cites this paper as [66]
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Convective Transport in Nanofluids
Buongiorno, J. (2006) · Journal of Heat Transfer · doi:10.1115/1.2150834 · Cited by 7,013 · cited 1×
“The measurements were also compared with a theoretical model based on the assumption of thermal equilibrium between the particles and the surrounding fluid [26,31]:”
Review on thermal energy storage with phase change materials and applications
Sharma, A., Tyagi, V. V., Chen, C. R., & Buddhi, D. (2009) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2007.10.005 · Cited by 5,936 · cited 2×
“Therefore, several studies on PCM used as thermal energy storage material have been published [10-16].”
BackgroundZalba, B., Marı́n, J. M., Cabeza, L. F., & Mehling, H. (2003) · Applied Thermal Engineering · doi:10.1016/s1359-4311(02)00192-8 · Cited by 4,738 · cited 1×
“Therefore, several studies on PCM used as thermal energy storage material have been published [10-16].”
BackgroundA review on phase change energy storage: materials and applications
Farid, M. M., Khudhair, A. M., Razack, S. A. K., & Al-Hallaj, S. (2004) · Energy Conversion and Management · doi:10.1016/j.enconman.2003.09.015 · Cited by 3,097 · cited 1×
“Therefore, several studies on PCM used as thermal energy storage material have been published [10-16].”
BackgroundMaterials used as PCM in thermal energy storage in buildings: A review
Cabeza, L. F., Castell, A., Barreneche, C., de Gracia, A., & Fernández, A. I. (2011) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2010.11.018 · Cited by 1,889
Gil, A., Medrano, M., Martorell, I., Lázaro, A., Dolado, P., Zalba, B., & Cabeza, L. F. (2010) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2009.07.035 · Cited by 1,762
Yu, W., & Choi, S. U. S. (2003) · Journal of Nanoparticle Research · doi:10.1023/a:1024438603801 · Cited by 1,737
Role of Brownian motion in the enhanced thermal conductivity of nanofluids
Jang, S. P., & Choi, S. U. S. (2004) · Applied Physics Letters · doi:10.1063/1.1756684 · Cited by 1,596
Enhanced thermal conductivity of TiO2—water based nanofluids
Murshed, S. M. S., Leong, K. C., & Yang, C. (2005) · International Journal of Thermal Sciences · doi:10.1016/j.ijthermalsci.2004.12.005 · Cited by 1,395
Hasnain, S. M. (1998) · Energy Conversion and Management · doi:10.1016/s0196-8904(98)00025-9 · Cited by 1,267 · cited 2×
“Low-temperature storage systems are based almost entirely on sensible heat storage using liquid water [3], but for temperatures exceeding 100°C (concentrated solar power plants), non-pressurized liquid water and the use of pressure vessels make this technology unattractive.”
Background
Research works printed but not linked: 3
- Laing D Solar thermal energy storage technologies Energy Forum 10000 Solar Gigawatts, 23 April 2008 2008 Hannover: Hannover Messe http://www.dlr.de/Portaldata/41/Resources/dokumente/institut/thermischept/Solar_Thermal_Energy_Storage_Technologies_Hannover2008.pdf
- Choi SUS Developments Applications of Non-Newtonian Flows 1995 New York: ASME
- Little F Molten salt carbon nanotube thermal energy storage for concentrating solar power systems DOE Peer Review 2011 Texas A&M University: Space Engineering Research Center
Cited by
Towards hybrid nanofluids: Preparation, thermophysical properties, applications, and challenges
Babar, H., & Ali, H. M. (2019) · Journal of Molecular Liquids · doi:10.1016/j.molliq.2019.02.102 · Cited by 485
Shah, T. R., & Ali, H. M. (2019) · Solar Energy · doi:10.1016/j.solener.2019.03.012 · Cited by 366
Chandel, S. S., & Agarwal, T. (2017) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2016.09.070 · Cited by 359
A review on the applications of nanofluids in solar energy field
Khanafer, K., & Vafai, K. (2018) · Renewable Energy · doi:10.1016/j.renene.2018.01.097 · Cited by 350
Mainstreaming commercial CSP systems: A technology review
Fernández, A. G., Gomez-Vidal, J., Oró, E., Kruizenga, A., Solé, A., & Cabeza, L. F. (2019) · Renewable Energy · doi:10.1016/j.renene.2019.03.049 · Cited by 311
Metadata
- Authors
- Chieruzzi, M., Cerritelli, G. F., Miliozzi, A., & Kenny, J. M.
- Affiliations
- University of Perugia (IT)
- National Agency for New Technologies, Energy and Sustainable Economic Development (IT)
- Corresponding author
- Chieruzzi, Manila
- Venue
- Nanoscale Research Letters
- Published
- 2013-10-29
- Volume
- 8
- Issue
- 1
- Pages
- 448-448
- ISSN
- 1556-276X (ISSN-L)
- PMC
- PMC4231368
- OpenAlex
- W2144901898
- Cited by
- 381
- References
- 56
- Citations by year
- 2026: 18 · 2025: 28 · 2024: 23 · 2023: 29 · 2022: 41 · 2021: 44 · 2020: 52 · 2019: 42 · 2018: 28 · 2017: 28 · 2016: 25 · 2015: 19 · 2014: 4
- FWCI
- 21.23
- Type
- journal article
- Language
- en
- Open access
- gold
- doi.org
- Licence
- cc-by
- creativecommons.org/licenses/by/2.0 (tdm)
- Locations
- Nanoscale Research Letters (publishedVersion, cc-by)
- Europe PMC (PubMed Central) (publishedVersion, cc-by)
- PubMed Central (publishedVersion, cc-by)
- PubMed (publishedVersion)
- DIGITAL.CSIC (Spanish National Research Council (CSIC)) (submittedVersion, other-oa)
- ENEA Open Archive (National Agency for New Technologies, Energy and Sustainable Economic Development) (submittedVersion)
- Funders
- Agenzia Nazionale per le Nuove Tecnologie, l'Energia e lo Sviluppo Economico Sostenibile
- Topics
- Physical Sciences › Engineering › Mechanical Engineering › Phase Change Materials Research
- Physical Sciences › Chemical Engineering › Fluid Flow and Transfer Processes › Nanofluid Flow and Heat Transfer
- Physical Sciences › Engineering › Mechanical Engineering › Adsorption and Cooling Systems
- Keywords
- nanofluids, molten salts, phase change materials, thermal energy storage, specific heat enhancement, Al2O3 nanoparticles, titanium dioxide nanoparticles, silica nanoparticles, nanoparticle dispersion, concentrated solar power, direct synthesis
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Effect of nanoparticles on heat capacity of nanofluids based on molten salts as PCM for thermal energy storage. https://app.cochat.ai/papers/10.1186/1556-276x-8-448
- The paper
- Chieruzzi, M., Cerritelli, G. F., Miliozzi, A., & Kenny, J. M. (2013). Effect of nanoparticles on heat capacity of nanofluids based on molten salts as PCM for thermal energy storage. Nanoscale Research Letters. https://doi.org/10.1186/1556-276x-8-448
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.