Student or educator? Sign up with your school email and get 6 months of Pro free.
CoChat

The DOI matches its Crossref record; 30 of the 30 references it cites were found in a registry or an index.

Valorization of Waste Orange Peels: Aqueous Antioxidant Polyphenol Extraction as Affected by Organic Acid Addition

Open access

Abstract

Waste orange peels (WOP) are a food processing residue rich in bioactive polyphenols. However, data on aqueous extraction processes for efficient polyphenol recovery are rather limited. The present study dealt with the optimization of WOP polyphenols, using a batch stirred-tank mode and water as solvent. After a preliminary single-factor examination, the implementation of response surface methodology revealed that optimum extraction time and temperature were 60 min and 55 °C, respectively. Under these conditions, the extraction afforded a total polyphenol yield of 26.13 ± 0.78 mg gallic acid equivalents per g dry mass. The use of aqueous solutions of citric, tartaric and lactic acid showed that total polyphenol yield may be significantly increased with 1% tartaric acid or equally with 2.5% citric acid. However, the effect on individual polyphenolic constituents was rather negligible, as determined by high-performance liquid chromatography. The discrepancies observed in the antioxidant properties of the extracts produced with water and acidified water were putatively attributed to some differences in the polyphenolic composition. The extraction methodology proposed is environmentally green and of low cost, and it could certainly be used as an effective means of recovering WOP polyphenols.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.3390/beverages8040071

Cites

30 of 30 references verified0 citation errors · 0 not checkable

Statistics

Figures

Figure 1 WOP aqueous extraction to test temperature effects on total polyphenol yield. The extrac -tions were carried out with a liquid -to -solid ratio of 20 mL g -1 , for 1 h, under stirring at 500 rpm. Figure 1. WOP aqueous extraction to test temperature effects on total polyphenol yield. The extractions were carried out with a liquid-to-solid ratio of 20 mL g -1 , for 1 h, under stirring at 500 rpm. Figure 1. WOP aqueous extraction to test temperature effects on total polyphenol yield. The extrac tions were carried out with a liquid -to -solid ratio of 20 mL g -1 , for 1 h, under stirring at 500 rpm.
Figure 1 WOP aqueous extraction to test temperature effects on total polyphenol yield. The extrac -tions were carried out with a liquid -to -solid ratio of 20 mL g -1 , for 1 h, under stirring at 500 rpm. Figure 1. WOP aqueous extraction to test temperature effects on total polyphenol yield. The extractions were carried out with a liquid-to-solid ratio of 20 mL g -1 , for 1 h, under stirring at 500 rpm. Figure 1. WOP aqueous extraction to test temperature effects on total polyphenol yield. The extrac tions were carried out with a liquid -to -solid ratio of 20 mL g -1 , for 1 h, under stirring at 500 rpm.CC-BY · From the PDF
Figure 2 WOP aqueous extraction to test time effects on total polyphenol yield. The extractions were carried out with a liquid -to -solid ratio of 20 mL g -1 , at 50 °C, under stirring at 500 rpm. Figure 2. WOP aqueous extraction to test time effects on total polyphenol yield. The extractions were carried out with a liquid -to -solid ratio of 20 mL g -1 , at 50 °C, under stirring at 500 rpm. Figure 2. WOPaqueous extraction to test time effects on total polyphenol yield. The extractions were carried out with a liquid-to-solid ratio of 20 mL g -1 , at 50 ◦ C, under stirring at 500 rpm.
Figure 2 WOP aqueous extraction to test time effects on total polyphenol yield. The extractions were carried out with a liquid -to -solid ratio of 20 mL g -1 , at 50 °C, under stirring at 500 rpm. Figure 2. WOP aqueous extraction to test time effects on total polyphenol yield. The extractions were carried out with a liquid -to -solid ratio of 20 mL g -1 , at 50 °C, under stirring at 500 rpm. Figure 2. WOPaqueous extraction to test time effects on total polyphenol yield. The extractions were carried out with a liquid-to-solid ratio of 20 mL g -1 , at 50 ◦ C, under stirring at 500 rpm.CC-BY · From the PDF
Figure 3 Statistical analyses pertaining to the response surface optimization of WOP aqueous pol -yphenol extraction. ( A ), desirability function; ( B ), plot showing actual vs. predicted YTP values. The values marked with asterisks in the inset table 'Parameter estimates' are statistically significant. The values in different color denote different level of significance. Pink area in B plot indicates the confidence interval of the model. Figure 3. Statistical analyses pertaining to the response surface optimization of WOP aqueous polyphenol extraction. ( A ), desirability function; ( B ), plot showing actual vs. predicted YTP values. The values marked with asterisks in the inset table 'Parameter estimates' are statistically significant. The values in different color denote different level of significance. Pink area in B plot indicates the confidence interval of the model.
Figure 3 Statistical analyses pertaining to the response surface optimization of WOP aqueous pol -yphenol extraction. ( A ), desirability function; ( B ), plot showing actual vs. predicted YTP values. The values marked with asterisks in the inset table 'Parameter estimates' are statistically significant. The values in different color denote different level of significance. Pink area in B plot indicates the confidence interval of the model. Figure 3. Statistical analyses pertaining to the response surface optimization of WOP aqueous polyphenol extraction. ( A ), desirability function; ( B ), plot showing actual vs. predicted YTP values. The values marked with asterisks in the inset table 'Parameter estimates' are statistically significant. The values in different color denote different level of significance. Pink area in B plot indicates the confidence interval of the model.CC-BY · From the PDF
Figure 4 The three -dimensional diagram illustrating the effect of process (independent) variables on the response (YTP). Figure 4. The three-dimensional diagram illustrating the effect of process (independent) variables on the response (YTP).
Figure 4 The three -dimensional diagram illustrating the effect of process (independent) variables on the response (YTP). Figure 4. The three-dimensional diagram illustrating the effect of process (independent) variables on the response (YTP).CC-BY · From the PDF
Figure 5 The bar plot presenting the effect of various acids and their concentration on YTP. The extractions were performed at 55 °C, for 60 min, under stirring at 500 rpm. The bar denoted with different letters represent statistically different values ( p < 0.05). Figure 5. The bar plot presenting the effect of various acids and their concentration on YTP. The extractions were performed at 55 ◦ C, for 60 min, under stirring at 500 rpm. The bar denoted with different letters represent statistically different values ( p < 0.05).
Figure 5 The bar plot presenting the effect of various acids and their concentration on YTP. The extractions were performed at 55 °C, for 60 min, under stirring at 500 rpm. The bar denoted with different letters represent statistically different values ( p < 0.05). Figure 5. The bar plot presenting the effect of various acids and their concentration on YTP. The extractions were performed at 55 ◦ C, for 60 min, under stirring at 500 rpm. The bar denoted with different letters represent statistically different values ( p < 0.05).CC-BY · From the PDF
Figure 6 A typical chromatogram of a WOP aqueous extract, obtained under optimized conditions (55 °C, 60 min). The eluent was monitored at 320 nm. Peak assignment: 1, neochlorogenic acid; 2, chlorogenic acid; 3, caffeic acid; 4, ferulic acid; 5, narirutin; 6, hesperidin, 7, didymin; 8, sinensetin; 9, nobiletin; 10, dimethylnobiletin. Figure 6. Atypical chromatogram of a WOP aqueous extract, obtained under optimized conditions (55 ◦ C, 60 min). The eluent was monitored at 320 nm. Peak assignment: 1, neochlorogenic acid; 2, chlorogenic acid; 3, caffeic acid; 4, ferulic acid; 5, narirutin; 6, hesperidin, 7, didymin; 8, sinensetin; 9, nobiletin; 10, dimethylnobiletin.
Figure 6 A typical chromatogram of a WOP aqueous extract, obtained under optimized conditions (55 °C, 60 min). The eluent was monitored at 320 nm. Peak assignment: 1, neochlorogenic acid; 2, chlorogenic acid; 3, caffeic acid; 4, ferulic acid; 5, narirutin; 6, hesperidin, 7, didymin; 8, sinensetin; 9, nobiletin; 10, dimethylnobiletin. Figure 6. Atypical chromatogram of a WOP aqueous extract, obtained under optimized conditions (55 ◦ C, 60 min). The eluent was monitored at 320 nm. Peak assignment: 1, neochlorogenic acid; 2, chlorogenic acid; 3, caffeic acid; 4, ferulic acid; 5, narirutin; 6, hesperidin, 7, didymin; 8, sinensetin; 9, nobiletin; 10, dimethylnobiletin.CC-BY · From the PDF
Figure 7 Antiradical activity (AAR) ( A ) and ferric -reducing power (PR) ( B ) of WOP extracts. All ex -tracts were produced at 55 °C, for 60 min. TA and CA denote tartaric and citric acid, respectively. Figure 7. Antiradical activity (AAR) ( A ) and ferric-reducing power (PR) ( B ) of WOP extracts. All extracts were produced at 55 ◦ C, for 60 min. TA and CA denote tartaric and citric acid, respectively.
Figure 7 Antiradical activity (AAR) ( A ) and ferric -reducing power (PR) ( B ) of WOP extracts. All ex -tracts were produced at 55 °C, for 60 min. TA and CA denote tartaric and citric acid, respectively. Figure 7. Antiradical activity (AAR) ( A ) and ferric-reducing power (PR) ( B ) of WOP extracts. All extracts were produced at 55 ◦ C, for 60 min. TA and CA denote tartaric and citric acid, respectively.CC-BY · From the PDF

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 21

Metadata

Authors
Kalompatsios, D., Athanasiadis, V., Palaiogiannis, D., Lalas, S. I., & Makris, D. P.
Affiliations
  • Green Processes & Biorefinery Group, Department of Food Science & Nutrition, School of Agricultural Sciences, University of Thessaly, N. Temponera Street, 43100 Karditsa, Greece
  • University of Thessaly (GR)
Corresponding author
Makris, Dimitris P.
Venue
Beverages
Publisher
MDPI AG
Published
2022-11-07
Volume
8
Issue
4
Pages
71
ISSN
2306-5710 (ISSN-L)
OpenAlex
W4308532085
Cited by
21
References
30
Citations by year
2026: 7 · 2025: 2 · 2024: 8 · 2023: 4
FWCI
1.83
Type
journal article
Language
en
Open access
Locations
  • Beverages (publishedVersion, cc-by)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
  • University of Thessaly Institutional Repository (University of Thessaly) (submittedVersion)
Topics
  • Health Sciences › Medicine › Biochemistry (medical) › Phytochemicals and Antioxidant Activities
  • Life Sciences › Agricultural and Biological Sciences › Food Science › Agricultural and Biological Research
  • Physical Sciences › Chemistry › Organic Chemistry › Edible Oils Quality and Analysis
Keywords
orange peel waste, polyphenol extraction, water extraction, organic acids, tartaric acid, citric acid, lactic acid, antioxidant activity, food processing residues, extraction optimization, green extraction

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.