Effect of Particle Size and Operating Conditions on Pt3Co PEMFC Cathode Catalyst Durability
Open accessThe DOI matches its Crossref record; 11 of the 11 references it cites were found in a registry or an index.
Abstract
The initial performance and decay trends of polymer electrolyte membrane fuel cells (PEMFC) cathodes with Pt3Co catalysts of three mean particle sizes (4.9 nm, 8.1 nm, and 14.8 nm) with identical Pt loadings are compared. Even though the cathode based on 4.9 nm catalyst exhibited the highest initial electrochemical surface area (ECA) and mass activity, the cathode based on 8.1 nm catalyst showed better initial performance at high currents. Owing to the low mass activity of the large particles, the initial performance of the 14.8 nm Pt3Co-based electrode was the lowest. The performance decay rate of the electrodes with the smallest Pt3Co particle size was the highest and that of the largest Pt3Co particle size was lowest. Interestingly, with increasing number of decay cycles (0.6 to 1.0 V, 50 mV/s), the relative improvement in performance of the cathode based on 8.1 nm Pt3Co over the 4.9 nm Pt3Co increased, owing to better stability of the 8.1 nm catalyst. The electron microprobe analysis (EMPA) of the decayed membrane-electrode assembly (MEA) showed that the amount of Co in the membrane was lower for the larger particles, and the platinum loss into the membrane also decreased with increasing particle size. This suggests that the higher initial performance at high currents with 8.1 nm Pt3Co could be due to lower contamination of the ionomer in the electrode. Furthermore, lower loss of Co from the catalyst with increased particle size could be one of the factors contributing to the stability of ECA and mass activity of electrodes with larger cathode catalyst particles. To delineate the impact of particle size and alloy effects, these results are compared with prior work from our research group on size effects of pure platinum catalysts. The impact of PEMFC operating conditions, including upper potential, relative humidity, and temperature on the alloy catalyst decay trends, along with the EMPA analysis of the decayed MEAs, are reported.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Trends in electrocatalysis on extended and nanoscale Pt-bimetallic alloy surfaces
Stamenkovic, V. R., Mun, B. S., Arenz, M., Mayrhofer, K. J. J., Lucas, C. A., Wang, G., Ross, P. N., & Markovic, N. M. (2007) · Nature Materials · doi:10.1038/nmat1840 · Cited by 3,252
Lattice-strain control of the activity in dealloyed core–shell fuel cell catalysts
Strasser, P., Koh, S., Anniyev, T., Greeley, J., More, K., Yu, C., Liu, Z., Kaya, S., Nordlund, D., Ogasawara, H., et al. (2010) · Nature Chemistry · doi:10.1038/nchem.623 · Cited by 2,984
Wang, D., Xin, H. L., Hovden, R., Wang, H., Yu, Y., Muller, D. A., DiSalvo, F. J., & Abruña, H. D. (2013) · Nature Materials · doi:10.1038/nmat3458 · Cited by 2,082
Enhancement of the Electroreduction of Oxygen on Pt Alloys with Fe, Ni, and Co
Toda, T., Igarashi, H., Uchida, H., & Watanabe, M. (1999) · Journal of The Electrochemical Society · doi:10.1149/1.1392544 · Cited by 1,336
Stamenkovic, V. R., Mun, B. S., Mayrhofer, K. J. J., Ross, P. N., & Markovic, N. M. (2006) · Journal of the American Chemical Society · doi:10.1021/ja0600476 · Cited by 974
Shao, M., Peles, A., & Shoemaker, K. (2011) · Nano Letters · doi:10.1021/nl2017459 · Cited by 878
Particle Size Effects for Oxygen Reduction on Highly Dispersed Platinum in Acid Electrolytes
Kinoshita, K. (1990) · Journal of The Electrochemical Society · doi:10.1149/1.2086566 · Cited by 854
Platinum Monolayer Fuel Cell Electrocatalysts
Adzic, R. R., Zhang, J., Sasaki, K., Vukmirovic, M. B., Shao, M., Wang, J. X., Nilekar, A. U., Mavrikakis, M., Valerio, J. A., & Uribe, F. (2007) · Topics in Catalysis · doi:10.1007/s11244-007-9003-x · Cited by 850
Paulus, U. A., Wokaun, A., Scherer, G. G., Schmidt, T. J., Stamenkovic, V., Markovic, N. M., & Ross, P. N. (2002) · Electrochimica Acta · doi:10.1016/s0013-4686(02)00349-3 · Cited by 560 · cited 1×
“5 to 2 for supported Pt3X catalysts, and 2 to 3 for PtCo catalyst [7].”
BackgroundImportance of Interatomic Spacing in Catalytic Reduction of Oxygen in Phosphoric Acid
Jalan, V., & Taylor, E. J. (1983) · Journal of The Electrochemical Society · doi:10.1149/1.2119574 · Cited by 363
Cited by
New roads and challenges for fuel cells in heavy-duty transportation
Cullen, D. A., Neyerlin, K. C., Ahluwalia, R. K., Mukundan, R., More, K. L., Borup, R. L., Weber, A. Z., Myers, D. J., & Kusoglu, A. (2021) · Nature Energy · doi:10.1038/s41560-021-00775-z · Cited by 1,277
Self-citationWang, X. X., Swihart, M. T., & Wu, G. (2019) · Nature Catalysis · doi:10.1038/s41929-019-0304-9 · Cited by 1,174
Banham, D., & Ye, S. (2017) · ACS Energy Letters · doi:10.1021/acsenergylett.6b00644 · Cited by 583
Durability of platinum-based fuel cell electrocatalysts: Dissolution of bulk and nanoscale platinum
Cherevko, S., Kulyk, N., & Mayrhofer, K. J. J. (2016) · Nano Energy · doi:10.1016/j.nanoen.2016.03.005 · Cited by 377
Carbon and non-carbon support materials for platinum-based catalysts in fuel cells
Samad, S., Loh, K. S., Wong, W. Y., Lee, T. K., Sunarso, J., Chong, S. T., & Wan Daud, W. R. (2018) · International Journal of Hydrogen Energy · doi:10.1016/j.ijhydene.2018.02.154 · Cited by 306
Metadata
- Authors
- Gummalla, M., Ball, S., Condit, D., Rasouli, S., Yu, K., Ferreira, P., Myers, D., & Yang, Z.
- Venue
- Catalysts
- Publisher
- MDPI AG
- Published
- 2015-05-29
- Volume
- 5
- Issue
- 2
- Pages
- 926-948
- ISSN
- 2073-4344 (ISSN-L)
- OpenAlex
- W1918425564
- Cited by
- 73
- References
- 11
- FWCI
- 2.73
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Effect of Particle Size and Operating Conditions on Pt3Co PEMFC Cathode Catalyst Durability. https://app.cochat.ai/papers/10.3390/catal5020926
- The paper
- Gummalla, M., Ball, S., Condit, D., Rasouli, S., Yu, K., Ferreira, P., Myers, D., & Yang, Z. (2015). Effect of Particle Size and Operating Conditions on Pt3Co PEMFC Cathode Catalyst Durability. Catalysts. https://doi.org/10.3390/catal5020926
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.