The DOI matches its Crossref record; 15 of the 15 references it cites were found in a registry or an index.
Electrical and Optical Properties of Fluorine Doped Tin Oxide Thin Films Prepared by Magnetron Sputtering
Open accessAbstract
Fluorine doped tin oxide (FTO) coatings have been prepared using the mid-frequency pulsed DC closed field unbalanced magnetron sputtering technique in an Ar/O2 atmosphere using blends of tin oxide and tin fluoride powder formed into targets. FTO coatings were deposited with a thickness of 400 nm on glass substrates. No post-deposition annealing treatments were carried out. The effects of the chemical composition on the structural (phase, grain size), optical (transmission, optical band-gap) and electrical (resistivity, charge carrier, mobility) properties of the thin films were investigated. Depositing FTO by magnetron sputtering is an environmentally friendly technique and the use of loosely packed blended powder targets gives an efficient means of screening candidate compositions, which also provides a low cost operation. The best film characteristics were achieved using a mass ratio of 12% SnF2 to 88% SnO2 in the target. The thin film produced was polycrystalline with a tetragonal crystal structure. The optimized conditions resulted in a thin film with average visible transmittance of 83% and optical band-gap of 3.80 eV, resistivity of 6.71 × 10−3 Ω·cm, a carrier concentration (Nd) of 1.46 × 1020 cm−3 and a mobility of 15 cm2/Vs.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Optical Properties and Electronic Structure of Amorphous Germanium
Tauc, J., Grigorovici, R., & Vancu, A. (1966) · physica status solidi (b) · doi:10.1002/pssb.19660150224 · Cited by 11,071
Barrett, C. S. (2007) · Cited by 2,354
A METHOD OF MEASURING SPECIFIC RESISTIVITY AND HALL EFFECT OF DISCS OF ARBITRARY SHAPE
van der PAUW, L. J. (1991) · Semiconductor Devices: Pioneering Papers · doi:10.1142/9789814503464_0017 · Cited by 1,346
TCO/metal/TCO structures for energy and flexible electronics
Guillén, C., & Herrero, J. (2011) · Thin Solid Films · doi:10.1016/j.tsf.2011.06.091 · Cited by 490
Discovery-based design of transparent conducting oxide films
Exarhos, G. J., & Zhou, X.-D. (2007) · Thin Solid Films · doi:10.1016/j.tsf.2007.03.014 · Cited by 363
A study on low cost-high conducting fluorine and antimony-doped tin oxide thin films
Elangovan, E., & Ramamurthi, K. (2005) · Applied Surface Science · doi:10.1016/j.apsusc.2004.11.074 · Cited by 234
Transparent conducting F-doped SnO2 thin films grown by pulsed laser deposition
Kim, H., Auyeung, R. C. Y., & Piqué, A. (2007) · Thin Solid Films · doi:10.1016/j.tsf.2007.11.079 · Cited by 231
Elangovan, E., & Ramamurthi, K. (2004) · Thin Solid Films · doi:10.1016/j.tsf.2004.09.022 · Cited by 170
Moholkar, A. V., Pawar, S. M., Rajpure, K. Y., Bhosale, C. H., & Kim, J. H. (2009) · Applied Surface Science · doi:10.1016/j.apsusc.2009.07.035 · Cited by 155
Yadav, A. A., Masumdar, E. U., Moholkar, A. V., Neumann-Spallart, M., Rajpure, K. Y., & Bhosale, C. H. (2009) · Journal of Alloys and Compounds · doi:10.1016/j.jallcom.2009.08.130 · Cited by 135
Cited by
Tin oxide for optoelectronic, photovoltaic and energy storage devices: a review
Dalapati, G. K., Sharma, H., Guchhait, A., Chakrabarty, N., Bamola, P., Liu, Q., Saianand, G., Sai Krishna, A. M., Mukhopadhyay, S., Dey, A., et al. (2021) · Journal of Materials Chemistry A · doi:10.1039/d1ta01291f · Cited by 406
Tin dioxide as a photocatalyst for water treatment: A review
Al-Hamdi, A. M., Rinner, U., & Sillanpää, M. (2017) · Process Safety and Environmental Protection · doi:10.1016/j.psep.2017.01.022 · Cited by 280
Naghdi, S., Rhee, K. Y., Hui, D., & Park, S. J. (2018) · Coatings · doi:10.3390/coatings8080278 · Cited by 258
Jamil, A., Fareed, S., Afsar, F., Siddique, F., Sher, F., & Rafiq, M. A. (2019) · Materials Research Express · doi:10.1088/2053-1591/ab4452 · Cited by 7
Metadata
- Authors
- Banyamin, Z., Kelly, P., West, G., & Boardman, J.
- Venue
- Coatings
- Publisher
- MDPI AG
- Published
- 2014-10-30
- Volume
- 4
- Issue
- 4
- Pages
- 732-746
- ISSN
- 2079-6412 (ISSN-L)
- OpenAlex
- W2056616404
- Cited by
- 281
- References
- 15
- FWCI
- 5.96
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.