The DOI matches its Crossref record; 24 of the 24 references it cites were found in a registry or an index.
Online Internal Resistance Measurement Application in Lithium Ion Battery Capacity and State of Charge Estimation
Open accessAbstract
State of charge (SOC) and state of health (SOH) are two significant state parameters for the lithium ion batteries (LiBs). In obtaining these states, the capacity of the battery is an indispensable parameter that is hard to detect directly online. However, there is a strong correlation relationship between this parameter and battery internal resistance. This article first shows a simple and effective online internal resistance detection method. Secondly, the relationship between the measured internal resistance and the LiBs capacity is established by linear fitting. Finally, the capacity through internal resistance conversion is applied in SOC estimation. The estimation results show that this method can effectively enhance the SOC estimation accuracy regardless of temperature change and battery degradation.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Shen et al. [64] were among the frst to apply DL algorithms for online LIBs capacity estimation, using a deep convolutional neural network (DCNN) to analyze current, voltage, and charge capacity during a limited charging cycle.”
In the citing paper
“In the LIB, there are two main components of internal resistance that can be described in [64].”
Citations
Cites
Armand, M., & Tarascon, J.-M. (2008) · Nature · doi:10.1038/451652a · Cited by 19,612 · cited 1×
“At present, lithium ion batteries (LiBs) are widely used in electric vehicles (EVs) due to their high specific power and energy [1].”
BackgroundNg, K. S., Moo, C.-S., Chen, Y.-P., & Hsieh, Y.-C. (2009) · Applied Energy · doi:10.1016/j.apenergy.2008.11.021 · Cited by 1,636 · cited 1×
“Another widely used method is the coulomb counting method, which can estimate battery capacity by the simple current integration over time [9].”
MethodExtended Kalman filtering for battery management systems of LiPB-based HEV battery packs
Plett, G. L. (2004) · Journal of Power Sources · doi:10.1016/j.jpowsour.2004.02.031 · Cited by 1,385
Waag, W., Käbitz, S., & Sauer, D. U. (2013) · Applied Energy · doi:10.1016/j.apenergy.2012.09.030 · Cited by 987
Lee, S., Kim, J., Lee, J., & Cho, B. H. (2008) · Journal of Power Sources · doi:10.1016/j.jpowsour.2008.08.103 · Cited by 698 · cited 4×
“References 1.”
BackgroundMethodInfluentialCapacity fade study of lithium-ion batteries cycled at high discharge rates
Ning, G., Haran, B., & Popov, B. N. (2003) · Journal of Power Sources · doi:10.1016/s0378-7753(03)00029-6 · Cited by 614 · cited 2×
“In addition, the pulse discharge method is a commonly used detection method [16], but the pulse time of this method is in units of seconds and cannot accurately obtain the battery internal resistance when the battery is loaded.”
MethodHu, C., Youn, B. D., & Chung, J. (2012) · Applied Energy · doi:10.1016/j.apenergy.2011.08.002 · Cited by 560
Sigma-point Kalman filtering for battery management systems of LiPB-based HEV battery packs
Plett, G. L. (2006) · Journal of Power Sources · doi:10.1016/j.jpowsour.2006.06.004 · Cited by 546 · cited 2×
“Moreov , battery model-based dual/joint Kalman filters method can estimate the LiBs capacity and SOC concurrently [11,12].”
MethodEddahech, A., Briat, O., Bertrand, N., Delétage, J.-Y., & Vinassa, J.-M. (2012) · International Journal of Electrical Power & Energy Systems · doi:10.1016/j.ijepes.2012.04.050 · Cited by 462 · cited 1×
“As an artificial intelligence algorithm, neural network (NN) is also used to predict the capacity of a battery [10].”
MethodKim, I.-S. (2010) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2009.2034966 · Cited by 438 · cited 1×
“A simple battery circuit model with a modified OCV-SOC relationship has been proven to be effective and accurate in SOC estimation [6,7].”
MethodIntelligent prognostics for battery health monitoring based on sample entropy
Widodo, A., Shim, M.-C., Caesarendra, W., & Yang, B.-S. (2011) · Expert Systems with Applications · doi:10.1016/j.eswa.2011.03.063 · Cited by 392 · cited 1×
“For instance, the most used SOH indicator in the literature is defined by the capacity loss rate [4].”
MethodChu, A. (2002) · Journal of Power Sources · doi:10.1016/s0378-7753(02)00364-6 · Cited by 389
Smith, K., & Wang, C.-Y. (2006) · Journal of Power Sources · doi:10.1016/j.jpowsour.2006.03.050 · Cited by 373 · cited 1×
“For example, the battery internal resistance can be easily obtained by the direct current internal resistance (DCIR) method or the hybrid pulse power characterization (HPPC) method [18,19].”
MethodModeling Li-ion Battery Capacity Depletion in a Particle Filtering Framework
Saha, B., & Goebel, K. (2009) · Annual Conference of the PHM Society · Cited by 330
Xiong, R., Tian, J., Mu, H., & Wang, C. (2017) · Applied Energy · doi:10.1016/j.apenergy.2017.05.124 · Cited by 283 · cited 2×
“The relations between various battery parameters can be found through this correlation research [21,22], which can thus be used to establish the algorithm model to estimate the SOC and SOH of a battery.”
MethodMulti-time-scale observer design for state-of-charge and state-of-health of a lithium-ion battery
Zou, C., Manzie, C., Nešić, D., & Kallapur, A. G. (2016) · Journal of Power Sources · doi:10.1016/j.jpowsour.2016.10.040 · Cited by 235 · cited 2×
“e ext l filt r ( ) algorith base on t e is a i ely used S online esti ation ethod [23].”
MethodSepasi, S., Ghorbani, R., & Liaw, B. Y. (2014) · Journal of Power Sources · doi:10.1016/j.jpowsour.2013.06.108 · Cited by 218 · cited 4×
“In fact, all parameters in the battery model (Figure 1) should be functions of the SOC or SOH [13,14].”
BackgroundMethodInfluentialModel-Based Battery Thermal Fault Diagnostics: Algorithms, Analysis, and Experiments
Dey, S., Perez, H. E., & Moura, S. J. (2019) · IEEE Transactions on Control Systems Technology · doi:10.1109/tcst.2017.2776218 · Cited by 191
Wang, D., Bao, Y., & Shi, J. J. (2017) · Energies · doi:10.3390/en10091284 · Cited by 118 · cited 3×
“In this p per, the battery internal resistance is measured using the direct current short-pulse (DCSP) method [17].”
MethodResultSelf-citationBarré, A., Suard, F., Gérard, M., Montaru, M., & Riu, D. M. (2013) · Journal of Power Sources · doi:10.1016/j.jpowsour.2013.07.052 · Cited by 110 · cited 2×
“The relations between various battery parameters can be found through this correlation research [21,22], which can thus be used to establish the algorithm model to estimate the SOC and SOH of a battery.”
MethodInline state of health estimation of lithium-ion batteries using state of charge calculation
Sepasi, S., Ghorbani, R., & Liaw, B. Y. (2015) · Journal of Power Sources · doi:10.1016/j.jpowsour.2015.08.091 · Cited by 105 · cited 4×
“In fact, all parameters in the battery model (Figure 1) should be functions of the SOC or SOH [13,14].”
BackgroundMethodInfluentialDey, S., & Ayalew, B. (2016) · Journal of Dynamic Systems Measurement and Control · doi:10.1115/1.4034801 · Cited by 28 · cited 1×
“The electrochemical method can accurately detect battery capacity [8].”
MethodDey, S., Mohon, S., Ayalew, B., Arunachalam, H., & Onori, S. (2017) · IEEE Transactions on Control Systems Technology · doi:10.1109/tcst.2017.2781650 · Cited by 25 · cited 1×
“The aging of lithium batteries is often accompanied by the loss of capacity and the increase of internal resistance [20].”
BackgroundMaximum pulse current estimation for high accuracy power capability prediction of a Li-Ion battery
Lee, S., Kim, J., & Cho, B. H. (2015) · Microelectronics Reliability · doi:10.1016/j.microrel.2014.12.016 · Cited by 20
Cited by
Wang, Y., Tian, J., Sun, Z., Wang, L., Xu, R., Li, M., & Chen, Z. (2020) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2020.110015 · Cited by 1,377
Ali, M. U., Zafar, A., Nengroo, S. H., Hussain, S., Junaid Alvi, M., & Kim, H.-J. (2019) · Energies · doi:10.3390/en12030446 · Cited by 442
“2013 [33] Unspecified Bao et al. 2018 [34] ≤± 1.4% IS Coleman et al. 2007 [31] Unspecified Xu et al. 2013 [37] ≤± 1% Westerhoff et al. 2016 [36] ≤± 2.75% Wu et al. 2018 [38] ≤± 4%”
MethodInfluentialGe, M.-F., Liu, Y., Jiang, X., & Liu, J. (2021) · Measurement · doi:10.1016/j.measurement.2021.109057 · Cited by 418
Gao, Y., Liu, K., Zhu, C., Zhang, X., & Zhang, D. (2022) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2021.3066946 · Cited by 418
Waseem, M., Ahmad, M., Parveen, A., & Suhaib, M. (2023) · Journal of Power Sources · doi:10.1016/j.jpowsour.2023.233349 · Cited by 288
Metadata
- Authors
- Bao, Y., Dong, W., & Wang, D.
- Affiliations
- Donghua University (CN)
- Corresponding author
- Bao, Yun
- ORCID
- Venue
- Energies
- Publisher
- MDPI AG
- Published
- 2018-04-26
- Volume
- 11
- Issue
- 5
- Pages
- 1073
- ISSN
- 1996-1073 (ISSN-L)
- OpenAlex
- W2802993111
- Cited by
- 108
- References
- 24
- Citations by year
- 2026: 6 · 2025: 18 · 2024: 16 · 2023: 27 · 2022: 15 · 2021: 15 · 2020: 5 · 2019: 3 · 2018: 3
- FWCI
- 3.46
- Type
- journal article
- Language
- en
- Open access
- gold
- doi.org
- Licence
- Locations
- Energies (publishedVersion, cc-by)
- RePEc: Research Papers in Economics (submittedVersion)
- DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
- Funders
- Donghua University
- Topics
- Physical Sciences › Engineering › Automotive Engineering › Battery Modeling and Management
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advancements in Battery Materials
- Physical Sciences › Engineering › Control and Systems Engineering › Control Systems and Identification
- Keywords
- lithium-ion batteries, internal resistance measurement, battery capacity estimation, state of charge estimation, health status (engineering condition monitoring), battery degradation, temperature effects
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.