CoChat

Thermal Decomposition Study on Li2O2 for Li2NiO2 Synthesis as a Sacrificing Positive Additive of Lithium-Ion Batteries

Open access
Kim, Jaekwang, Kang, Hyunchul, Hwang, Keebum, Yoon, Songhun · 2019 · Molecules

The DOI matches its Crossref record; 22 of the 22 references it cites were found in a registry or an index; none of the 11 sources its claims cite is checked for support yet.

Abstract

Herein, thermal decomposition experiments of lithium peroxide (Li2O2) were performed to prepare a precursor (Li2O) for sacrificing cathode material, Li2NiO2. The Li2O2 was prepared by a hydrometallurgical reaction between LiOH·H2O and H2O2. The overall reaction during annealing was found to involve the following three steps: (1) dehydration of LiOH·H2O, (2) decomposition of Li2O2, and (3) pyrolysis of the remaining anhydrous LiOH. This stepwise reaction was elucidated by thermal gravimetric and quantitative X-ray diffraction analyses. Furthermore, over-lithiated lithium nickel oxide (Li2NiO2) using our lithium precursor was synthesized, which exhibited a larger yield of 90.9% and higher irreversible capacity of 261 to 265 mAh g−1 than the sample prepared by commercially purchased Li2O (45.6% and 177 to 185 mAh g−1, respectively) due to optimal powder preparation conditions.

Overview

CoChat Summary

TL;DR

Thermal decomposition of Li₂O₂ to Li₂O proceeds through dehydration of LiOH·H₂O, decomposition of Li₂O₂, and pyrolysis of residual anhydrous LiOH. Li₂NiO₂ made from the prepared Li₂O gave higher yield and first-cycle irreversible capacity than Li₂NiO₂ made from commercial Li₂O.

Key findings

  • Annealing Li₂O₂ involves three steps: dehydration of LiOH·H₂O at 90–200 °C, Li₂O₂ decomposition starting at 340 °C and ending at 420 °C, and pyrolysis of anhydrous LiOH giving a broad signal between 420 and 550 °C.
  • Li₂O₂ reacted thoroughly after 60 min at 400 °C; hydroxides were not found after reaction at 500 °C, and Li₂O content increased with thermal exposure time.
  • Li₂NiO₂ synthesized from prepared Li₂O (P-L2N) had 90.9% L2N yield and 261–265 mAh g⁻¹ first-cycle irreversible capacity, versus 45.6% and 177–185 mAh g⁻¹ for Li₂NiO₂ from commercial Li₂O (C-L2N).

Methods

  • Li₂O₂ was prepared by precipitation from LiOH·H₂O in 30% H₂O₂, stirred 1 h, filtered, and vacuum dried. Thermal decomposition used 10 g Li₂O₂ in an alumina crucible under N₂ flow, 5 °C/min ramp, 350–600 °C, and 30–120 min exposure.
  • Li₂NiO₂ was synthesized by solid-state reaction of stoichiometric NiO and Li₂O at 650 °C for 12 h under N₂, using either prepared or commercial Li₂O. Characterization included FE-SEM, XRD with Rietveld refinement, and TGA/DTG.
  • Electrochemical testing used 2032 coin half-cells with L2N working electrode, Li foil counter electrode, 1.0 M LiPF₆ in EC/EMC (1:2 v/v), and CCCV cycling between 3.0–4.25 V vs. Li/Li⁺ at 0.1 C, with three cells per material.

Limitations

  • Stated: comparison of anhydrous LiOH pyrolysis with prior work needs verification because that prior result used vacuum annealing, whereas this study used an N₂ atmosphere.
  • Stated: Li₂O₂ prepared by the hydrometallurgical reaction can be contaminated with LiOH·H₂O or anhydrous LiOH during vacuum drying, and the text says this contamination is inevitable.
  • Evident: both L2N samples showed residual NiO and Li₂O signals, and P-L2N appeared more sintered than C-L2N; the text also reports Li₂O decomposition for L2N synthesis as 450 °C for 10 h in Results but 450 °C for 2 h in Methods.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.3390/molecules24244624

Cites

22 of 22 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Figure 1 FE-SEM images of (a) Li2O2 and its decomposed products at (b) 450 °C and (c) 600 °C.
Figure 1 FE-SEM images of (a) Li2O2 and its decomposed products at (b) 450 °C and (c) 600 °C.CC BY · PubMed Central
Figure 2 (a) XRD spectra of the materials decomposed at 350, 450, 600 °C and (b) TGA (black) and differential thermal gravimetric (DTG, navy color).
Figure 2 (a) XRD spectra of the materials decomposed at 350, 450, 600 °C and (b) TGA (black) and differential thermal gravimetric (DTG, navy color).CC BY · PubMed Central
Figure 3 (a) Mole fraction of Li2O within a decomposed product according to reaction time. (b) Reaction rate of each exposure temperature derived from the slope of mole fraction of Li2O. (c) 3D graphical summary of Li2O transformation ratio (wt%) obtained from Table 1.
Figure 3 (a) Mole fraction of Li2O within a decomposed product according to reaction time. (b) Reaction rate of each exposure temperature derived from the slope of mole fraction of Li2O. (c) 3D graphical summary of Li2O transformation ratio (wt%) obtained from Table 1.CC BY · PubMed Central
Figure 4 Galvanostatic charge/discharge profiles obtained from three identically conditioned cells of (a) P-L2N and (b) C-L2N.
Figure 4 Galvanostatic charge/discharge profiles obtained from three identically conditioned cells of (a) P-L2N and (b) C-L2N.CC BY · PubMed Central

Verification

Claims the paper makes

0 Valid · 0 Not valid · 8 Not checked · 26 Own results and interpretations

12 more claims

Create a free account to see all 34 claims and to verify the 11 references still open.

See all claims — free account
  • It may state two separate claims as one. 12
  • The quote only partly states this claim. 2
  • Probably not a substantial claim. 6

Create a free account to see these claims.

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

1 of 1

Citations

Cites

Research works printed but not linked: 3

  1. Moeller, T. (2009). Inorganic Syntheses, McGraw Hill Book Company, Inc.
  2. Hart, W.A., Beumel, O., and Whaley, T.P. (2013). The Chemistry of Lithium, Sodium, Potassium, Rubidium, Cesium and Francium: Pergamon Texts in Inorganic Chemistry, Elsevier.
  3. Lewis, R.A. (2016). Hawley’s Condensed Chemical Dictionary, John Wiley & Sons.

Cited by

See all 21

Metadata

Authors
Kim, J., Kang, H., Hwang, K., & Yoon, S.
Affiliations
  • Department of Nanomaterials Science and Engineering, School of Integrative Engineering, Chung-Ang University, 84, Heukseok-ro, Dongjak-Gu, Seoul 06974, Korea
  • Chung-Ang University (KR)
Corresponding author
Yoon, Songhun
Venue
Molecules
Publisher
MDPI AG
Published
2019-12-17
Volume
24
Issue
24
Pages
4624
ISSN
1420-3049 (ISSN-L)
OpenAlex
W2996623440
Cited by
21
References
22
Citations by year
2026: 5 · 2023: 6 · 2022: 7 · 2021: 1 · 2020: 2
FWCI
0.90
Type
journal article
Language
en
Open access
Locations
  • Molecules (publishedVersion, cc-by)
  • PubMed (publishedVersion)
  • PubMed Central (publishedVersion, cc-by)
Funders
  • Chung-Ang University
  • Ministry of Trade, Industry and Energy (20006777)
Topics
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Advancements in Battery Materials
  • Physical Sciences › Materials Science › Metals and Alloys › Extraction and Separation Processes
  • Physical Sciences › Engineering › Automotive Engineering › Battery Modeling and Management
Keywords
lithium peroxide, thermal decomposition, lithium-ion batteries, lithium hydroxide, hydrogen peroxide, annealing, irreversible capacity
MeSH terms
Ions, Lithium, Nickel, Electric Power Supplies, X-Ray Diffraction

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

A language model drew the claims from the paper on 2026-11-20, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-11-20 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.