CoChat

A Low-Cost Tracking System for Running Race Applications Based on Bluetooth Low Energy Technology

Open access
Perez-Diaz-de-Cerio, David, Hernández-Solana, Ángela, Valdovinos, Antonio, Valenzuela, Jose · 2018 · Sensors

The DOI matches its Crossref record; 12 of the 12 references it cites were found in a registry or an index.

Abstract

Timing points used in running races and other competition events are generally based on radio-frequency identification (RFID) technology. Athletes’ times are calculated via passive RFID tags and reader kits. Specifically, the reader infrastructure needed is complex and requires the deployment of a mat or ramps which hide the receiver antennae under them. Moreover, with the employed tags, it is not possible to transmit additional and dynamic information such as pulse or oximetry monitoring, alarms, etc. In this paper we present a system based on two low complex schemes allowed in Bluetooth Low Energy (BLE): the non-connectable undirected advertisement process and a modified version of scannable undirected advertisement process using the new capabilities present in Bluetooth 5. After fully describing the system architecture, which allows full real-time position monitoring of the runners using mobile phones on the organizer side and BLE sensors on the participants’ side, we derive the mobility patterns of runners and capacity requirements, which are determinant for evaluating the performance of the proposed system. They have been obtained from the analysis of the real data measured in the last Barcelona Marathon. By means of simulations, we demonstrate that, even under disadvantageous conditions (50% error ratio), both schemes perform reliably and are able to detect the 100% of the participants in all the cases. The cell coverage of the system needs to be adjusted when non-connectable process is considered. Nevertheless, through simulation and experimental, we show that the proposed scheme based on the new events available in Bluetooth 5 is clearly the best implementation alternative for all the cases, no matter the coverage area and the runner speed. The proposal widely exceeds the detection requirements of the real scenario, surpassing the measured peaks of 20 sensors per second incoming in the coverage area, moving at speeds that range from 1.5 m/s to 6.25 m/s. The designed real test-bed shows that the scheme is able to detect 72 sensors below 600 ms, fulfilling comfortably the requirements determined for the intended application. The main disadvantage of this system would be that the sensors are active, but we have proved that its consumption can be so low (9.5 µA) that, with a typical button cell, the sensor battery life would be over 10,000 h of use.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.3390/s18030922

Cites

12 of 12 references verified0 citation errors · 0 not checkable

Statistics

Figures

Figure 1 RFID Solution.
Figure 1 RFID Solution.CC BY · PubMed Central
Figure 2 System deployment.
Figure 2 System deployment.CC BY · PubMed Central
Figure 3 Non-connectable and scannable undirected advertisement detection procedure.
Figure 3 Non-connectable and scannable undirected advertisement detection procedure.CC BY · PubMed Central
Figure 4 Runners under coverage at 5 km checkpoint for different coverage radii.
Figure 4 Runners under coverage at 5 km checkpoint for different coverage radii.CC BY · PubMed Central
Figure 5 Sensor flow at the 5 km checkpoint.
Figure 5 Sensor flow at the 5 km checkpoint.CC BY · PubMed Central
Figure 6 Cell coverage.
Figure 6 Cell coverage.CC BY · PubMed Central
Figure 7 Test-bed setup.
Figure 7 Test-bed setup.CC BY · PubMed Central
Figure 8 Detection and disconnection of 72 advertisers.
Figure 8 Detection and disconnection of 72 advertisers.CC BY · PubMed Central
Figure 9 Non-connectable undirected advertisement scheme. Rows ((1) to (4)) represent results for each of the four athlete groups running at different speeds. First column (a) represents the mean number of detections under coverage under a single scanner coverage. The second and third columns show the average time required to discover all devices under a single scanner coverage (b) and under two scanners (c) overlapped coverage, respectively, for several values of BLER, TadvIND and TadvInterval.
Figure 9 Non-connectable undirected advertisement scheme. Rows ((1) to (4)) represent results for each of the four athlete groups running at different speeds. First column (a) represents the mean number of detections under coverage under a single scanner coverage. The second and third columns show the average time required to discover all devices under a single scanner coverage (b) and under two scanners (c) overlapped coverage, respectively, for several values of BLER, TadvIND and TadvInterval.CC BY · PubMed Central
Figure 10 Non-connectable undirected advertisement scheme. Probability that all devices are detected under a single scanner coverage. Comparison between Group #1 (1), #2 (2), #3 (3) and #4 (4). Cases without a 100% of detection probability.
Figure 10 Non-connectable undirected advertisement scheme. Probability that all devices are detected under a single scanner coverage. Comparison between Group #1 (1), #2 (2), #3 (3) and #4 (4). Cases without a 100% of detection probability.CC BY · PubMed Central
Figure 11 Interrupted scannable undirected advertisement scheme. Probability that all devices are detected under a single scanner coverage. Comparison between Group #1 (1), #2 (2), #3 (3) and #4 (4). Cases without a 100% of detection probability.
Figure 11 Interrupted scannable undirected advertisement scheme. Probability that all devices are detected under a single scanner coverage. Comparison between Group #1 (1), #2 (2), #3 (3) and #4 (4). Cases without a 100% of detection probability.CC BY · PubMed Central

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 12 references

Cited by

See all 13

Metadata

Authors
Perez-Diaz-de-Cerio, D., Hernández-Solana, Á., Valdovinos, A., & Valenzuela, J.
Affiliations
  • Signal Theory and Communications Department, Universitat Politècnica de Catalunya, Esteve Terrades 7, 08860 Castelldefels, Spain
  • Aragon Institute for Engineering Research (I3A), University of Zaragoza, 50018 Zaragoza, Spain
  • Universidad de Zaragoza (ES)
  • Universitat Politècnica de Catalunya (ES)
Venue
Sensors
Publisher
MDPI AG
Published
2018-03-20
Volume
18
Issue
3
Pages
922
ISSN
1424-8220 (ISSN-L)
OpenAlex
W2790089474
Cited by
10
References
12
Citations by year
2026: 1 · 2025: 1 · 2024: 2 · 2023: 1 · 2022: 2 · 2019: 3
FWCI
0.46
Type
journal article
Language
en
Open access
Locations
  • Sensors (publishedVersion, cc-by)
  • Europe PMC (PubMed Central) (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
  • LA Referencia (Red Federada de Repositorios Institucionales de Publicaciones Científicas) (acceptedVersion, cc-by)
  • UPCommons institutional repository (Universitat Politècnica de Catalunya) (acceptedVersion, cc-by)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
  • RECERCAT (Consorci de Serveis Universitaris de Catalunya) (submittedVersion, cc-by)
  • Zaguan (Universidad de Zaragoza) (submittedVersion, cc-by)
Topics
  • Physical Sciences › Computer Science › Computer Networks and Communications › Bluetooth and Wireless Communication Technologies
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Indoor and Outdoor Localization Technologies
  • Physical Sciences › Computer Science › Computer Networks and Communications › RFID technology advancements
Keywords
Bluetooth Low Energy, athlete monitoring, Bluetooth 5, low-cost sensors, marathon running, sensor-based detection, battery life, cell coverage, RFID alternative

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: A Low-Cost Tracking System for Running Race Applications Based on Bluetooth Low Energy Technology. https://app.cochat.ai/papers/10.3390/s18030922
The paper
Perez-Diaz-de-Cerio, D., Hernández-Solana, Á., Valdovinos, A., & Valenzuela, J. (2018). A Low-Cost Tracking System for Running Race Applications Based on Bluetooth Low Energy Technology. Sensors. https://doi.org/10.3390/s18030922

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.