CoChat

Adsorption Removal of Phosphate from Rural Domestic Sewage by Ca-Modified Biochar Derived from Waste Eggshell and Sawdust

Open access

The DOI matches its Crossref record; 38 of the 38 references it cites were found in a registry or an index; 12 of the 55 sources its claims cite were checked for support.

Abstract

In recent years, in order to improve the rural living environment, rural domestic sewage treatment has received more and more attention in China. However, the standard compliance rate of total phosphorus (TP) in rural domestic sewage after treatment is very low, and TP has become the main pollutant that prevents rural domestic sewage treatment facilities from meeting water pollutants discharge standards. In this study, to prepare calcium-modified biochar composites (E-BC) by one-step pyrolysis, waste eggshell (E) was employed as a calcium source and waste pine sawdust (BC) was employed as a carbon source. The E-BC composites produced were effective in adsorbing phosphate (P) from aqueous solutions in a broad pH range of 3–11, with good adsorption selectivity. E-BC’s adsorption capacity for P increased as the pyrolysis temperature increased from 700 °C to 900 °C, which was attributed to the higher specific surface area and calcium oxide content at higher pyrolysis temperatures. The E-BC sample, which was made from eggshell (filtered through 100 mesh sieves) and pine sawdust (filtered through 100 mesh sieves) with a mass ratio of 2:1 and a pyrolysis temperature of 900 °C, had a maximum adsorption capacity of 301 mg/g. The Langmuir model and pseudo second-order model were the best at describing the adsorption process, and the predominant sorption mechanism for P is the chemisorption reaction of calcium oxide or calcium hydroxide with phosphate to create hydroxyapatite. E-BC can effectively remove P from rural domestic sewage. The total phosphorus (TP) removal rate in rural domestic sewage ranges from 95.3 to 99.5%. After adsorption treatment, the discharge of TP in rural sewage meets the second-grade (TP < 3 mg/L) or even the first-grade (TP < 2 mg/L). This study provides an experimental basis for efficient P removal using E-BC adsorbent materials and suggests possible applications in rural domestic sewage.

Overview

CoChat Summary

TL;DR

Ca-modified biochar (E-BC) was prepared by one-step pyrolysis from waste eggshell and pine sawdust and tested for phosphate removal from aqueous solution and rural domestic sewage. The optimized E-BC (2:1)-T900 reached a maximum experimental P adsorption capacity of 301 mg/g and removed 95.3–99.5% of TP from actual rural sewage.

Key findings

  • The best adsorbent was E-BC made from eggshell and pine sawdust at a 2:1 mass ratio, both passed through 100 mesh sieves, and pyrolyzed at 900 °C; its experimental maximum P adsorption capacity was 301 mg/g, and the Langmuir model gave qmax = 302.9 mg/g, KL = 4.1 L/mg, R² = 0.999.
  • Adsorption increased with pyrolysis temperature, from 30.2 mg/g at 700 °C to 301 mg/g at 900 °C, and with smaller particle size; pure biochar (BC) had the lowest tested adsorption amount at 5.5 mg/g.
  • The pseudo-second-order model fit kinetics better (R² = 0.999) than pseudo-first-order (R² = 0.882), and P adsorption remained high over pH 3–11, with 292.2 mg/g at pH 3, 301 mg/g at pH 7, 298.5 mg/g at pH 9, and 296.7 mg/g at pH 11.
  • In actual rural domestic sewage with TP of 2.41–11.5 mg/L, E-BC (2:1)-T900 reduced TP to 0.019–0.33 mg/L, giving 95.3–99.5% removal and meeting the second-grade (TP < 3 mg/L) and first-grade (TP < 2 mg/L) discharge standards; the dominant mechanism was chemisorption forming Ca5(PO4)3OH from CaO or Ca(OH)2 reacting with phosphate.

Methods

  • E-BC adsorbents were prepared by mixing waste eggshell as Ca source and pine sawdust as carbon source, then calcining under nitrogen at 700, 800, or 900 °C for 2 h; the effects of eggshell:sawdust ratio, sieve mesh size, and pyrolysis temperature were tested.
  • Batch adsorption experiments used 0.2 g/L adsorbent, 50 mL P solutions, pH 7 and 25 °C unless varied; isotherm tests used initial P concentrations of 10, 20, 50, 70, 100, 150, and 200 mg/L, and kinetic tests used 100 mg/L P with sampling from 5 min to 1440 min.
  • Characterization included ammonium molybdate spectrophotometry, SEM-EDS, XRD, FTIR, and physisorption for surface area/pore properties; actual sewage tests used 0.01 g E-BC in 50 mL rural sewage from a centralized A²O facility (design capacity 20 t/d), shaken 4 h at 25 °C.

Limitations

  • Stated: the paper says in-depth mechanism studies for the effect of pH and coexisting anions on P adsorption by E-BC (2:1)-T900 should be carried out in future experiments.
  • Stated: the paper notes that apart from raw material cost, the energy cost of calcination is a major cost, and the P removal effect, adsorbent cost, and P recovery benefit should be comprehensively evaluated for future engineering application.
  • Evident from the text: the adsorption performance is demonstrated mainly in batch tests with synthetic KH2PO4 solutions and one actual rural sewage facility; no continuous-flow, column, or long-term field trial is reported.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.3390/w15173087

Cites

38 of 38 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Verification

Claims the paper makes

12 Valid · 0 Not valid · 28 Not checked · 65 Own results and interpretations

50 more claims · 2 with their cited sources checked

Create a free account to see all 105 claims and to verify the 1 reference still open.

See all claims — free account
  • Probably not a substantial claim. 20
  • It may state two separate claims as one. 33

Create a free account to see these claims.

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

1 of 1

Citations

Cites

Show all 38 references

Cited by

Metadata

Authors
Xu, C., Liu, R., Tang, Q., Hou, Y., Chen, L., & Wang, Q.
Affiliations
  • Shanghai Normal University (CN)
  • Tsinghua University (CN)
  • Changzhou University (CN)
Corresponding author
  • Liu, Rui
  • Wang, Quanxi
Venue
Water
Publisher
MDPI AG
Published
2023-08-28
Volume
15
Issue
17
Pages
3087
ISSN
2073-4441 (ISSN-L)
OpenAlex
W4386245330
Cited by
15
References
38
Citations by year
2026: 3 · 2025: 7 · 2024: 4 · 2023: 1
FWCI
2.14
Type
journal article
Language
en
Open access
Locations
  • Water (publishedVersion, cc-by)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion)
Funders
  • National Key Research and Development Program of China (2020YFD1100103-2, 2020R52039)
  • Leading Talent of the Science &amp; Technology Nova Program of Zhejiang (2020YFD1100103-2, 2020R52039)
  • Outstanding Innovative Team Supporting Plan of Jiaxing City (2020YFD1100103-2, 2020R52039)
Topics
  • Physical Sciences › Environmental Science › Waste Management and Disposal › Phosphorus and nutrient management
  • Physical Sciences › Environmental Science › Water Science and Technology › Adsorption and biosorption for pollutant removal
  • Health Sciences › Medicine › Nephrology › Parathyroid Disorders and Treatments
Keywords
phosphate adsorption, rural domestic sewage, eggshell waste, pine sawdust, biochar composites, pyrolysis temperature, calcium oxide, hydroxyapatite formation, chemisorption, total phosphorus removal, low-cost adsorbent, Langmuir isotherm, pseudo-second-order kinetics

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-10-05, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-05 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Cited sources are checked with a language model’s help (gpt-6-sol).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.