The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Analysis of variance (ANOVA) comparing means of more than two groups
Open accessAbstract
Mean values obtained from different groups with different conditions are frequently compared in clinical studies. For example, two mean bond strengths between tooth surface and resin cement may be compared using the parametric Student's t test when independent groups are subjected to the comparison under the assumptions of normal distribution and equal variances (or standard deviation). In a condition of unequal variances we may apply the Welch's t test as an adaptation of the t test. As the nature and specific shape of distributions are predetermined by the assumption, the t test compares only the locations of the distribution represented by means, which is simple and intuitive. The t statistic is the ratio of mean difference and standard errors of the mean difference. Even when more than two groups are compared, some researchers erroneously apply the t test by implementing multiple t tests on multiple pairs of means. It is inappropriate because the repetition of the multiple tests may repeatedly add multiple chances of error, which may result in a larger α error level than the pre-set α level. When we try to compare means of three groups, A, B, and C, using the t test, we need to implement 3 pairwise tests, i.e., A vs B, A vs C, and B vs C. Similarly if comparisons are repeated k times in an experiment and the α level 0.05 was set for each comparison, an unacceptably increased total error rate of 1-(0.95)k may be expected for the total comparison procedure in the experiment. For a comparison of more than two group means the one-way analysis of variance (ANOVA) is the appropriate method instead of the t test. As the ANOVA is based on the same assumption with the t test, the interest of ANOVA is on the locations of the distributions represented by means too. Then why is the method comparing several means the 'analysis of variance', rather than 'analysis of means' themselves? It is because that the relative location of the several group means can be more conveniently identified by variance among the group means than comparing many group means directly when number of means are large. The ANOVA method assesses the relative size of variance among group means (between group variance) compared to the average variance within groups (within group variance). Figure 1 shows two comparative cases which have similar 'between group variances' (the same distance among three group means) but have different 'within group variances'. When the between group variances are the same, mean differences among groups seem more distinct in the distributions with smaller within group variances (a) compared to those with larger within group variances (b). Therefore the ratio of between group variance to within group variance is of the main interest in the ANOVA. Figure 1 Distributions with the same between group variance. (a) smaller variance within groups; (b) larger variance within groups. Table 1 displays an artificial data of bond strength according to different resin types and Table 2 shows the result of the one-way ANOVA. The 'SSB' represents the sum of squares between groups which is the variation of group means from the total grand mean, and the mean of squares between groups (MSB) is subsequently obtained by dividing SSB with degrees of freedom. The 'SSW' represents sum of squares within groups which is the sum of squared deviations from the group means and individual observations because the equal variances in all the groups were already assumed. The mean of square within groups (MSW) is subsequently obtained by dividing SSW with degrees of freedom, in the same way. The ratio of MSB and MSW determines the degree of how relatively greater the difference is between group means (between group variance) compared to within group variance. If the ratio is greater than expected by chance we may think not all the group means are the same which means that at least one mean is substantially different. As the result is interpreted about the whole set of groups, it is called as a global or overall test. The ratio of MSB and MSW is known to follow the F distribution. Therefore, to get a statistical conclusion we may compare the F value calculated from the observed data with the critical value at an α error level of 0.05 in the F table. Table 1 Measurements of bonding strength according to three different types of resin (artificial data) Table 2 One-way ANOVA table Larger F value implies that means of the groups are greatly different from each other compared to the variation of the individual observations in each groups. Larger F value than the critical value supports that the differences between group means are larger than what would be expected by chance. In this example the critical F value is 3.23 in the F table when the degrees of freedom of numerator and denominator are 2 and 42 respectively at the α error level 0.05. As the observed F value 8.4 is larger than the cri
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Fundamentals of Biostatistics.
(1969) · Annals of Internal Medicine · doi:10.7326/0003-4819-70-4-873 · Cited by 4,575
Sanjeev, B. (2006) · Jaypee Brothers Medical Publishers (P) Ltd. eBooks · doi:10.5005/jp/books/10313 · Cited by 995
Cited by
Application of Student's t-test, Analysis of Variance, and Covariance
Mishra, P., Singh, U., Pandey, C. M., Mishra, P., & Pandey, G. (2019) · Annals of Cardiac Anaesthesia · doi:10.4103/aca.aca_94_19 · Cited by 949
Prediction of Type 2 Diabetes Based on Machine Learning Algorithm
Deberneh, H. M., & Kim, I. (2021) · International Journal of Environmental Research and Public Health · doi:10.3390/ijerph18063317 · Cited by 261
eHealth for inflammatory bowel disease self-management – the patient perspective
Con, D., Jackson, B., Gray, K., & De Cruz, P. (2017) · Scandinavian Journal of Gastroenterology · doi:10.1080/00365521.2017.1333625 · Cited by 38
Metadata
- Authors
- Kim, H.-Y.
- Venue
- Restorative Dentistry & Endodontics
- Published
- 2014
- Volume
- 39
- Issue
- 1
- Pages
- 74
- ISSN
- 2234-7658 (ISSN-L)
- 2234-7666
- OpenAlex
- W2021108748
- Cited by
- 411
- References
- 2
- FWCI
- 4.81
- Type
- journal article
- Language
- en
- Open access
- diamond
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Analysis of variance (ANOVA) comparing means of more than two groups. https://app.cochat.ai/papers/10.5395/rde.2014.39.1.74
- The paper
- Kim, H.-Y. (2014). Analysis of variance (ANOVA) comparing means of more than two groups. Restorative Dentistry & Endodontics. https://doi.org/10.5395/rde.2014.39.1.74
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.