The DOI matches its Crossref record; 28 of the 28 references it cites were found in a registry or an index.
Potassium hydroxide activation of activated carbon: a commentary
Open accessAbstract
Copyright © Korean Carbon Society http://carbonlett.org Over the years, the furnace has been used as a common heating method to manufacture activated carbon. In a furnace, heat is transferred through conduction and convection. The outer surface of the sample is in contact with the generated heat, which slowly diffuses inwards as a result of the thermal gradient between the surface and the core of the material’s particles. Another method of heating employs microwave irradiation. Even though it is less energyand time-consuming, the microwave method has several critical issues with respect to temperature control and thermal runaway, especially in the scaling-up of the microwave heating process [1]. Generally, the activation of a carbonaceous precursor can be performed through physical (steam, air or CO2) or chemical activation (activators such as ZnCl2, KOH, etc.) or a combination of both. The chemical activation is normally preferable over physical activation since it is a faster process with a lower activation temperature. Moreover, the activated carbon produced via chemical activation usually possesses high specific surface area (as determined by the Brunauer-Emmett-Teller, BET method), good pore development and high carbon yield [2,3]. In recent years, potassium salts such as KOH and K2CO3 have been widely used in the manufacture of low cost activated carbon. It has been found that activated carbon prepared by KOH activation is highly microporous when compared to that produced through ZnCl2 or H3PO4 activation [4-6]. Besides, KOH also enhances the specific surface area and the formation of—OH functional groups on the carbon surface [7]. Over the past 5 years, many advantages of KOH activation have been revealed in the literature [8]. However, the adverse drawbacks of employing KOH have been overlooked in many of the published studies. In this paper, the preparation of activated carbon by KOH activation using conventional heating is reviewed and discussed. The limitations and implications of using KOH in the activation process are highlighted. The selection of appropriate potassium salts for activated carbon preparation is also recommended. The physical preparation of activated carbon is comprised of two major processes, namely, carbonization and activation of the carbonized sample [4]. Chemical activation is a single step process, as both carbonization and activation occur simultaneously at temperatures ranging between 400oC and 700oC, which is lower than that of physical activation [9]. However, in some cases, additional carbonization or a pre-carbonization step is performed to produce char prior to chemical impregnation and activation [5,4,10-13]. Thus, potassium hydroxide activation can be achieved through either direct chemical activation or char-impregnated chemical activation. In direct chemical activation, a selected carbonaceous precursor is first dried overnight to remove moisture and then chemically treated at a desired impregnation ratio (weight of KOH over weight of precursor). The impregnated solid is then heated in a furnace at a specified temperature and time. Carbonization of the precursor is often omitted when the impregnated solid is already suitable for activation. Table 1 exhibits recently developed activated carbon preparation methods using various precursors and KOH activation with conventional heating. From Table 1, it can be seen that DOI: http://dx.doi.org/ DOI:10.5714/CL.2015.16.4.275
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Understanding chemical reactions between carbons and NaOH and KOH
Lillo-Ródenas, M. A., Cazorla-Amorós, D., & Linares-Solano, A. (2003) · Carbon · doi:10.1016/s0008-6223(02)00279-8 · Cited by 1,199
Prahas, D., Kartika, Y., Indraswati, N., & Ismadji, S. (2008) · Chemical Engineering Journal · doi:10.1016/j.cej.2007.08.032 · Cited by 873
AL-Othman, Z. A., Ali, R., & Naushad, M. (2012) · Chemical Engineering Journal · doi:10.1016/j.cej.2012.01.048 · Cited by 748
Electrochemical energy storage in ordered porous carbon materials
Vix-Guterl, C., Frackowiak, E., Jurewicz, K., Friebe, M., Parmentier, J., & Béguin, F. (2005) · Carbon · doi:10.1016/j.carbon.2004.12.028 · Cited by 713
Smith, K. M., Fowler, G. D., Pullket, S., & Graham, N. J. D. (2009) · Water Research · doi:10.1016/j.watres.2009.02.038 · Cited by 518
Altenor, S., Carene, B., Emmanuel, E., Lambert, J., Ehrhardt, J.-J., & Gaspard, S. (2009) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2008.10.133 · Cited by 476
Muniandy, L., Adam, F., Mohamed, A. R., & Ng, E.-P. (2014) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2014.06.020 · Cited by 383
Mesoporous high-surface-area activated carbon
Hu, Z., & Srinivasan, M. P. (2001) · Microporous and Mesoporous Materials · doi:10.1016/s1387-1811(00)00355-3 · Cited by 260
The comparison of two activation techniques to prepare activated carbon from corn cob
Song, M., Jin, B., Xiao, R., Yang, L., Wu, Y., Zhong, Z., & Huang, Y. (2013) · Biomass and Bioenergy · doi:10.1016/j.biombioe.2012.11.007 · Cited by 240
Okman, I., Karagöz, S., Tay, T., & Erdem, M. (2014) · Applied Surface Science · doi:10.1016/j.apsusc.2013.12.117 · Cited by 217
Mestre, A. S., Bexiga, A. S., Proença, M., Andrade, M., Pinto, M. L., Matos, I., Fonseca, I. M., & Carvalho, A. P. (2011) · Bioresource Technology · doi:10.1016/j.biortech.2011.06.024 · Cited by 177
Activated carbons from sewage sludge
Monsalvo, V. M., Mohedano, A. F., & Rodriguez, J. J. (2011) · Desalination · doi:10.1016/j.desal.2011.04.059 · Cited by 151
Hunsom, M., & Autthanit, C. (2013) · Chemical Engineering Journal · doi:10.1016/j.cej.2013.05.120 · Cited by 145
Preparation and characterization of activated carbon from palm kernel shell by chemical activation.
Abechi, S. E., Gimba, C. E., Uzairu, A., & Dallatu, Y. A. (2013) · Cited by 129
Kaçan, E., & Aslani, C. K. (2012) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2012.06.006 · Cited by 122
Adibfar, M., Kaghazchi, T., Asasian, N., & Soleimani, M. (2014) · Chemical Engineering & Technology · doi:10.1002/ceat.201200719 · Cited by 105
Wu, M., Guo, Q., & Fu, G. (2013) · Powder Technology · doi:10.1016/j.powtec.2013.07.013 · Cited by 92
Sun, K., Jiang, J., & Dan-dan, C. (2011) · Biomass and Bioenergy · doi:10.1016/j.biombioe.2011.05.007 · Cited by 74
Adsorption Capacities Of Activated Carbons Prepared From Bamboo By Koh Activation
Hirunpraditkoon, S., Tunthong, N., Ruangchai, A., & Nuithitikul, K. (2011) · Zenodo (CERN European Organization for Nuclear Research) · doi:10.5281/zenodo.1055444 · Cited by 71
Critical issues in microwave-assisted activated carbon preparation
Zaini, M. A. A., & Kamaruddin, M. J. (2013) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2013.02.003 · Cited by 69
Self-citationPreparation and characterization of activated carbon from Kraft lignin via KOH activation
Li, X., Xu, Q., Fu, Y., & Guo, Q. (2014) · Environmental Progress & Sustainable Energy · doi:10.1002/ep.11794 · Cited by 65 · cited 1×
“[18] stated that KOH activation of carbon-rich kraft lignin produces activated carbon with the superior surface area of 2763 m2/g.”
BackgroundA novel route for preparation of high-performance porous carbons from hydrochars by KOH activation
Wang, L., Zhang, Z., Qu, Y., Guo, Y., Wang, Z., & Wang, X. (2014) · Colloids and Surfaces A Physicochemical and Engineering Aspects · doi:10.1016/j.colsurfa.2014.01.013 · Cited by 61
Rugayah, A. F., Aziz, A. A., & Ngadi, N. (2014) · Journal of Oil Palm Research · Cited by 42
Yu, Q., Li, M., Ning, P., Yi, H., & Tang, X. (2014) · Separation Science and Technology · doi:10.1080/01496395.2014.917326 · Cited by 34
Wu, C., Song, M., Jin, B., Wu, Y.-M., & Huang, Y. (2013) · Journal of Environmental Sciences · doi:10.1016/s1001-0742(12)60028-x · Cited by 33
Taha, M. F., Kiat, C. F., Shaharun, M. S., & Ramli, A. (2011) · Zenodo (CERN European Organization for Nuclear Research) · doi:10.5281/zenodo.1072111 · Cited by 17
Olajire, A. A., & Azeez, L. A. (2012) · Advances in environmental research · doi:10.12989/aer.2012.1.2.109 · Cited by 15
Joseph, C. G., Zain, H. F. M., & Dek, S. F. (2006) · UMS Institutional Repository (Universiti Malaysia Sabah) · Cited by 13
Cited by
Methods for preparation and activation of activated carbon: a review
Heidarinejad, Z., Dehghani, M. H., Heidari, M., Javedan, G., Ali, I., & Sillanpää, M. (2020) · Environmental Chemistry Letters · doi:10.1007/s10311-019-00955-0 · Cited by 1,475
Production and utilization of biochar: A review
Cha, J. S., Park, S. H., Jung, S.-C., Ryu, C., Jeon, J.-K., Shin, M.-C., & Park, Y.-K. (2016) · Journal of Industrial and Engineering Chemistry · doi:10.1016/j.jiec.2016.06.002 · Cited by 1,293
Recent advances in activated carbon modification techniques for enhanced heavy metal adsorption
Mariana, M., H.P.S., A. K., Mistar, E. M., Yahya, E. B., Alfatah, T., Danish, M., & Amayreh, M. (2021) · Journal of Water Process Engineering · doi:10.1016/j.jwpe.2021.102221 · Cited by 410
KOH-activated high surface area Douglas Fir biochar for adsorbing aqueous Cr(VI), Pb(II) and Cd(II)
Herath, A., Layne, C. A., Perez, F., Hassan, E. B., Pittman, C. U., & Mlsna, T. E. (2021) · Chemosphere · doi:10.1016/j.chemosphere.2020.128409 · Cited by 308
Lobato-Peralta, D. R., Okoye, P. U., & Alegre, C. (2024) · Journal of Power Sources · doi:10.1016/j.jpowsour.2024.235140 · Cited by 266
Metadata
- Authors
- Hui, T. S., & Zaini, M. A. A.
- Venue
- Carbon letters
- Publisher
- Korean Carbon Society
- Published
- 2015-10-31
- Volume
- 16
- Issue
- 4
- Pages
- 275-280
- ISSN
- 1976-4251 (ISSN-L)
- OpenAlex
- W2341750026
- Cited by
- 291
- References
- 28
- FWCI
- 7.44
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.