Determining crustal structure beneath seismic stations overlying a low‐velocity sedimentary layer using receiver functions
The DOI matches its Crossref record; 13 of the 13 references it cites were found in a registry or an index.
Abstract
The receiver function (RF) technique has been widely applied to investigate crustal and mantle layered structures using P‐to‐S converted (Ps) phases from velocity discontinuities. However, the presence of low‐velocity (relative to that of the bedrock) sediments can give rise to strong reverberations in the resulting RFs, frequently masking the Ps phases from crustal and mantle boundaries. Such reverberations are caused by P‐to‐S conversions and their multiples associated with the strong impedance contrast across the bottom of the low‐velocity sedimentary layer. Here we propose and test an approach to effectively remove the near‐surface reverberations and decipher the Ps phases associated with the Moho discontinuity. Autocorrelation is first applied on the observed RFs to determine the strength and two‐way traveltime of the reverberations, which are then used to construct a resonance removal filter in the frequency domain to remove or significantly reduce the reverberations. The filtered RFs are time corrected to eliminate the delay effects of the sedimentary layer and applied to estimate the subsediment crustal thickness and VP/VSusing a H‐k stacking procedure. The resulting subsediment crustal parameters (thickness and VP/VS) are subsequently used to determine the thickness and VP/VS of the sedimentary layer, using a revised version of the H‐k stacking procedure. Testing using both synthetic and real data suggests that this computationally inexpensive technique is efficient in resolving subsediment crustal properties beneath stations sitting on a low‐velocity sedimentary layer and can also satisfactorily determine the thickness and VP/VS of the sedimentary layer.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Efron, B., & Tibshirani, R. (1986) · Statistical Science · doi:10.1214/ss/1177013815 · Cited by 6,033 · cited 1×
“Ten bootstrap iterations are used to evaluate the standard deviations of the observed sedimentary and subsediment crustal parameters [Efron and Tibshirani, 1986; Press et al., 1992; Liu and Gao, 2010].”
MethodSeismic Data Analysis: Processing, Inversion, and Interpretation of Seismic Data
Yilmaz, Ö. (2001) · Society of Exploration Geophysicists eBooks · doi:10.1190/1.9781560801580 · Cited by 2,245 · cited 12×
“The direct P phase, which arrives at t = 0, is weaker than PbS and can barely be observed directly unless the frequency of the wavelet is unrealistically high.”
BackgroundMethodInfluentialStructure under Mount Rainier, Washington, inferred from teleseismic body waves
Langston, C. A. (1979) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb084ib09p04749 · Cited by 1,632 · cited 4×
“The conversion from compressional to shear waves occurs when P waves encounter an acoustic impedance YU ET AL.”
BackgroundMethodInfluentialMoho depth variation in southern California from teleseismic receiver functions
Zhu, L., & Kanamori, H. (2000) · Journal of Geophysical Research: Solid Earth · doi:10.1029/1999jb900322 · Cited by 1,489
Owens, T. J., Zandt, G., & Taylor, S. R. (1984) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb089ib09p07783 · Cited by 530 · cited 1×
“…phases) related to the Moho including PmS, PPmS, and PSmS (Figure 1) have been widely employed to image crustal thickness and VP∕VS beneath a recording site using the receiver function (RF) technique [Langston, 1979; Owens et al., 1984; Ammon, 1991; Zandt and Ammon, 1995; Zhu and Kanamori, 2000].”
MethodThe Poisson ratio of the Australian crust: geological and geophysical implications
Chevrot, S., & van der Hilst, R. D. (2000) · Earth and Planetary Science Letters · doi:10.1016/s0012-821x(00)00264-8 · Cited by 202
Southern African crustal evolution and composition: Constraints from receiver function studies
Nair, S. K., Gao, S. S., Liu, K. H., & Silver, P. G. (2006) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2005jb003802 · Cited by 177
Self-citationCrustal thickness variations across the Colorado Rocky Mountains from teleseismic receiver functions
Sheehan, A. F., Abers, G. A., Jones, C. H., & Lerner‐Lam, A. L. (1995) · Journal of Geophysical Research Atmospheres · doi:10.1029/95jb01966 · Cited by 176 · cited 1×
“Forward modeling was conducted to obtain sedimentary and crustal S wave velocity models by iteratively fitting the synthetics to the observed RFs [Sheehan et al., 1995; Zelt and Ellis, 1999; Clitheroe et al., 2000; Anandakrishnan and Winberry, 2004; Mandal, 2006; He et al., 2012], but the strong…”
MethodMantle transition zone discontinuities beneath the contiguous United States
Gao, S. S., & Liu, K. H. (2014) · Journal of Geophysical Research Solid Earth · doi:10.1002/2014jb011253 · Cited by 123
Self-citationThe application of homomorphic deconvolution to shallow-water marine seismology; Part I, Models
Stoffa, P. L., Buhl, P., & Bryan, G. M. (1974) · Geophysics · doi:10.1190/1.1440438 · Cited by 111 · cited 3×
“Similar to multiples created in a water layer [e.g., Stoffa et al., 1974, equation (18)], for a model with a low-velocity sedimentary layer (Figure 1), the primary and multiples of the converted shear waves can be expressed as H(t) = ∞∑ n=0 (−r0)n × F(t − n × Δt), (2) where n is the index of the…”
BackgroundMethodCrustal and uppermost mantle structure along the Deep Probe seismic profile
Snelson, C. M., Henstock, T., Keller, G. R., Miller, K. C., & Levander, A. (1998) · Rocky Mountain geology · doi:10.2113/33.2.181 · Cited by 86 · cited 2×
“The sedimentary VP was taken from well logs [Moore, 1985], and the subsediment crustal VP was obtained from nearby active source seismic studies [Snelson et al., 1998].”
MethodResultReed, C. A., Almadani, S. A., Gao, S. S., Elsheikh, A. A., Cherie, S. G., Abdelsalam, M. G., Thurmond, A. K., & Liu, K. H. (2014) · Journal of Geophysical Research Solid Earth · doi:10.1002/2013jb010719 · Cited by 62 · cited 1×
“…some recent studies attempted to reduce the influence of the sedimentary layer by applying band-pass or band-rejection filters [Leahy et al., 2012; Reed et al., 2014], but it is sometimes subjective to decide the optimal frequency bands, and the removal of the sedimentary effects is frequently…”
BackgroundSelf-citationBashir, L., Gao, S. S., Liu, K. H., & Mickus, K. (2011) · Geochemistry Geophysics Geosystems · doi:10.1029/2011gc003563 · Cited by 39 · cited 2×
“A popularly used procedure for crustal studies using RFs is H-k stacking, in which the radial RFs are moveout corrected and stacked along the traveltime curves of the Moho Ps phases at each candidate pair of H (thickness) and k (VP∕VS) in a grid search procedure [Chevrot and Van der Hilst, 2000;…”
MethodSelf-citation
Metadata
- Authors
- Yu, Y., Song, J., Liu, K. H., & Gao, S. S.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 2015-05
- Volume
- 120
- Issue
- 5
- Pages
- 3208-3218
- ISSN
- 2169-9313 (ISSN-L)
- 2169-9356
- OpenAlex
- W1540163445
- Cited by
- 165
- References
- 13
- FWCI
- 4.19
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.