The DOI matches its Crossref record; 28 of the 28 references it cites were found in a registry or an index.
From Surface ZrO2 Coating to Bulk Zr Doping by High Temperature Annealing of Nickel‐Rich Lithiated Oxides and Their Enhanced Electrochemical Performance in Lithium Ion Batteries
Abstract
One of the major hurdles of Ni‐rich cathode materials Li 1+x(NixCozMnz)wO 2, y > 0.5 for lithium‐ion batteries is their low cycling stability especially for compositions with Ni ≥ 60%, which suffer from severe capacity fading and impedance increase during cycling at elevated temperatures (e.g., 45 °C). Two promising surface and structural modifications of these materials to alleviate the above drawback are (1) coatings by electrochemically inert inorganic compounds (e.g., ZrO 2) or (2) lattice doping by cations like Zr 4+, Al 3+, Mg 2+, etc. This paper demonstrates the enhanced electrochemical behavior of Ni‐rich material LiNi 0.8 Co 0.1 Mn 0.1 O 2 (NCM811) coated with a thin ZrO 2 layer. The coating is produced by an easy and scalable wet chemical approach followed by annealing the material at ≥700 °C under oxygen that results in Zr doping. It is established that some ZrO 2 remains even after annealing at ≥800 °C as a surface layer on NCM811. The main finding of this work is the enhanced cycling stability and lower impedance of the coated/doped NCM811 that can be attributed to a synergetic effect of the ZrO 2 coating in combination with a zirconium doping.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Generalized Gradient Approximation Made Simple
Perdew, J. P., Burke, K., & Ernzerhof, M. (1996) · Physical Review Letters · doi:10.1103/physrevlett.77.3865 · Cited by 215,824
Efficient iterative schemes for ab initio total-energy calculations using a plane-wave basis set
Kresse, G., & Furthmüller, J. (1996) · Physical Review B · doi:10.1103/physrevb.54.11169 · Cited by 123,652
Projector augmented-wave method
Blöchl, P. E. (1994) · Physical Review B · doi:10.1103/physrevb.50.17953 · Cited by 92,732
Kresse, G., & Furthmüller, J. (1996) · Computational Materials Science · doi:10.1016/0927-0256(96)00008-0 · Cited by 75,638
Ab initio molecular dynamics for liquid metals
Kresse, G., & Hafner, J. (1993) · Physical Review B · doi:10.1103/physrevb.47.558 · Cited by 45,727
Kresse, G., & Hafner, J. (1994) · Physical Review B · doi:10.1103/physrevb.49.14251 · Cited by 23,019
Noh, H.-J., Youn, S., Yoon, C. S., & Sun, Y.-K. (2013) · Journal of Power Sources · doi:10.1016/j.jpowsour.2013.01.063 · Cited by 2,302
Layered Lithium Insertion Material of LiCo1/3Ni1/3Mn1/3O2 for Lithium-Ion Batteries
Ohzuku, T., & Makimura, Y. (2001) · Chemistry Letters · doi:10.1246/cl.2001.642 · Cited by 1,388
Jung, S., Gwon, H., Hong, J., Park, K., Seo, D., Kim, H., Hyun, J., Yang, W., & Kang, K. (2014) · Advanced Energy Materials · doi:10.1002/aenm.201300787 · Cited by 1,124
Novel lithium insertion material of LiCo1/3Ni1/3Mn1/3O2 for advanced lithium-ion batteries
Yabuuchi, N., & Ohzuku, T. (2003) · Journal of Power Sources · doi:10.1016/s0378-7753(03)00173-3 · Cited by 870
Schipper, F., Erickson, E. M., Erk, C., Shin, J.-Y., Chesneau, F. F., & Aurbach, D. (2017) · Journal of The Electrochemical Society · doi:10.1149/2.0351701jes · Cited by 762
Self-citationIn situ x-ray diffraction and electrochemical studies of Li1−xNiO2
LI, W., Reimers, J. N., & Dahn, J. R. (1993) · Solid State Ionics · doi:10.1016/0167-2738(93)90317-v · Cited by 745
Aurbach, D., Levi, M. D., Levi, E., Teller, H., Markovsky, B., Salitra, G., Heider, U., & Heider, L. (1998) · Journal of The Electrochemical Society · doi:10.1149/1.1838758 · Cited by 654
Self-citationCathode materials modified by surface coating for lithium ion batteries
Li, C., Zhang, H. P., Fu, L. J., Liu, H., Wu, Y. P., Rahm, E., Holze, R., & Wu, H. Q. (2006) · Electrochimica Acta · doi:10.1016/j.electacta.2005.11.015 · Cited by 624
Study of the Failure Mechanisms of LiNi0.8Mn0.1Co0.1O2Cathode Material for Lithium Ion Batteries
Li, J., Downie, L. E., Ma, L., Qiu, W., & Dahn, J. R. (2015) · Journal of The Electrochemical Society · doi:10.1149/2.1011507jes · Cited by 516
Minimization of the cation mixing in Li1+x(NMC)1−xO2 as cathode material
Zhang, X., Jiang, W. J., Mauger, A., Qilu, Gendron, F., & Julien, C. M. (2010) · Journal of Power Sources · doi:10.1016/j.jpowsour.2009.09.029 · Cited by 409
Yabuuchi, N., Makimura, Y., & Ohzuku, T. (2007) · Journal of The Electrochemical Society · doi:10.1149/1.2455585 · Cited by 387
Crystal and electronic structures of superstructural Li1−x[Co1/3Ni1/3Mn1/3]O2 (0≤x≤1)
Koyama, Y., Tanaka, I., Adachi, H., Makimura, Y., & Ohzuku, T. (2003) · Journal of Power Sources · doi:10.1016/s0378-7753(03)00194-0 · Cited by 350
Significant improvement of high voltage cycling behavior AlF3-coated LiCoO2 cathode
SUN, Y., HAN, J., MYUNG, S., LEE, S., & AMINE, K. (2006) · Electrochemistry Communications · doi:10.1016/j.elecom.2006.03.040 · Cited by 273
A brief review: Past, present and future of lithium ion batteries
Schipper, F., & Aurbach, D. (2016) · Russian Journal of Electrochemistry · doi:10.1134/s1023193516120120 · Cited by 210
Self-citationYabuuchi, N., Koyama, Y., Nakayama, N., & Ohzuku, T. (2005) · Journal of The Electrochemical Society · doi:10.1149/1.1924227 · Cited by 198
Ghanty, C., Markovsky, B., Erickson, E. M., Talianker, M., Haik, O., Tal‐Yossef, Y., Mor, A., Aurbach, D., Lampert, J., Volkov, A., et al. (2015) · ChemElectroChem · doi:10.1002/celc.201500160 · Cited by 163
Self-citationDixit, M., Markovsky, B., Aurbach, D., & Major, D. T. (2017) · Journal of The Electrochemical Society · doi:10.1149/2.0561701jes · Cited by 162
Self-citationAurbach, D., Srur-Lavi, O., Ghanty, C., Dixit, M., Haik, O., Talianker, M., Grinblat, Y., Leifer, N., Lavi, R., Major, D. T., et al. (2015) · Journal of The Electrochemical Society · doi:10.1149/2.0681506jes · Cited by 143
Self-citationStudy of the surface modification of LiNi1/3Co1/3Mn1/3O2 cathode material for lithium ion battery
Hashem, A. M., Abdel-Ghany, A. E., Eid, A. E., Trottier, J., Zaghib, K., Mauger, A., & Julien, C. M. (2011) · Journal of Power Sources · doi:10.1016/j.jpowsour.2011.06.039 · Cited by 131
Myung, S., Komaba, S., Kurihara, K., Hosoya, K., Kumagai, N., Sun, Y., Nakai, I., Yonemura, M., & Kamiyama, T. (2006) · Chemistry of Materials · doi:10.1021/cm052704j · Cited by 88
Huang, Y., Chen, J., Cheng, F., Wan, W., Liu, W., Zhou, H., & Zhang, X. (2010) · Journal of Power Sources · doi:10.1016/j.jpowsour.2010.07.021 · Cited by 83
Li, J., Wang, L., Zhang, Q., et al. (2008) · Journal of Power Sources · doi:10.1016/j.jpowsour.2008.08.011 · Cited by 71
Cited by
Guidelines and trends for next-generation rechargeable lithium and lithium-ion batteries
Wu, F., Maier, J., & Yu, Y. (2020) · Chemical Society Reviews · doi:10.1039/c7cs00863e · Cited by 2,229
Problems and their origins of Ni-rich layered oxide cathode materials
Zhang, S. S. (2020) · Energy Storage Materials · doi:10.1016/j.ensm.2019.08.013 · Cited by 746
Yang, H., Wu, H., Ge, M., Li, L., Yuan, Y., Yao, Q., Chen, J., Xia, L., Zheng, J., Chen, Z., et al. (2019) · Advanced Functional Materials · doi:10.1002/adfm.201808825 · Cited by 630
Kim, U.-H., Park, G.-T., Son, B.-K., Nam, G. W., Liu, J., Kuo, L.-Y., Kaghazchi, P., Yoon, C. S., & Sun, Y.-K. (2020) · Nature Energy · doi:10.1038/s41560-020-00693-6 · Cited by 540
Reactive boride infusion stabilizes Ni-rich cathodes for lithium-ion batteries
Yoon, M., Dong, Y., Hwang, J., Sung, J., Cha, H., Ahn, K., Huang, Y., Kang, S. J., Li, J., & Cho, J. (2021) · Nature Energy · doi:10.1038/s41560-021-00782-0 · Cited by 539
Metadata
- Authors
- Schipper, F., Bouzaglo, H., Dixit, M., Erickson, E. M., Weigel, T., Talianker, M., Grinblat, J., Burstein, L., Schmidt, M., Lampert, J., Erk, C., Markovsky, B., Major, D. T., & Aurbach, D.
- Venue
- Advanced Energy Materials
- Publisher
- Wiley
- Published
- 2017-09-22
- Volume
- 8
- Issue
- 4
- ISSN
- 1614-6832 (ISSN-L)
- 1614-6840
- OpenAlex
- W2760707428
- Cited by
- 565
- References
- 28
- FWCI
- 20.92
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.