CoChat

Electrochemical Activation of C−C Bonds through Mediated Hydrogen Atom Transfer Reactions

Open access

Published version of a preprint

The DOI matches its Crossref record; 65 of the 66 references it cites were found in a registry or an index.

Abstract

Activating inert sp 3 –sp 3 carbon‐carbon (C−C) bonds remains a major bottleneck in the chemical upcycling of recalcitrant polyolefin waste. In this study, redox mediators are used to activate the inert C−C bonds. Specifically, N ‐hydroxyphthalimide (NHPI) is used as the redox mediator, which is oxidized to phthalimide‐ N ‐oxyl (PINO) radical to initiate hydrogen atom transfer (HAT) reactions with benzylic C−H bonds. The resulting carbon radical is readily captured by molecular oxygen to form a peroxide that decomposes into oxygenated C−C bond‐scission fragments. This indirect approach reduces the oxidation potential by >1.2 V compared to the direct oxidation of the substrate. Studies with model compounds reveal that the selectivity of C−C bond cleavage increases with decreasing C−C bond dissociation energy. With NHPI‐mediated oxidation, oligomeric styrene (OS 510 ; M n =510 Da) and polystyrene (PS; M n ≈10 000 Da) are converted into oxygenated monomers, dimers, and oligomers.

Verification finished with gaps

Some checks didn’t finish. The results below cover the steps that did.

  1. Registry recordVerified
  2. Full textRead the full text
  3. Reference list65 references found
  4. Reference check65 of 65 references checked
  5. StatisticsRecomputed
  6. ClaimsDidn’t finish — the rest of the report still applies.
  7. Cited sourcesDidn’t finish — the rest of the report still applies.
  8. Self-checkChecked
  9. VerificationFindings verified

Overview

CoChat Summary

TL;DR

This paper demonstrates an electrochemical, mediator-based route to activate inert C–C bonds via N-hydroxyphthalimide (NHPI)/phthalimide-N-oxyl (PINO)-mediated hydrogen atom transfer (HAT) from benzylic C–H bonds, followed by O₂ capture and peroxide decomposition. The approach lowers oxidation potentials by >1.2 V versus direct substrate oxidation and converts oligomeric styrene and polystyrene into oxygenated monomers, dimers, and oligomers.

Key findings

  • NHPI/PINO mediates benzylic C–H HAT; for bibenzyl, the NHPI-mediated oxidation onset potential was 0.80 V vs Ag/AgCl, 1.26 V less positive than direct bibenzyl oxidation at 2.06 V.
  • Bulk electrolysis of bibenzyl gave a bifurcated pathway: C–C bond cleavage products (benzaldehyde, benzoic acid) and C–H oxygenation products (1,2-diphenylethanone, benzil), with each NHPI carrying out 7.5 turnovers before decomposition on average.
  • Optimal conditions were 20 mol% NHPI, 0.1 M pyridine, 0.1 M HOAc, 0.1 M LiBF₄/acetonitrile, 1 atm O₂, room temperature, and 2 mA; under these conditions bibenzyl conversion was 61.0% with 45.2% Faradaic efficiency.
  • For oligomeric styrene (Mn = 510 Da), Ph0–1 product yields increased from 3.1% at q = 0.57 to 13.6% at q = 2.28; for polystyrene (~10,000 Da), all starting PS was converted to smaller molecules when unit charge exceeded 1.29 F mol⁻¹, and monomer/dimer yields reached 7.49% and 4.75% at q = 4.29, respectively, with the conclusion reporting a combined monomer and dimer yield of 12%.

Methods

  • Cyclic voltammetry was recorded at 10 mV s⁻¹ in 0.1 M LiBF₄/acetonitrile with 10 mM NHPI, with and without substrate, to compare mediated versus direct oxidation potentials.
  • Bulk electrolysis used an H-shaped glass cell with working and counter chambers separated by a Nafion membrane, typically at constant current (2 mA, or 1 mA for oligomeric/polymeric styrene) up to 1.5 V vs Ag/AgCl.
  • Products were analyzed by GC-MS, GC-FID, HPLC, and GPC; model substrates included bibenzyl, 1,3-diphenylpropane, 1,4-diphenylbutane, and substituted derivatives, plus oligomeric styrene (Mn = 510 Da) and polystyrene (~10,000 Da).

Limitations

  • Stated: NHPI/PINO undergoes irreversible decomposition, limiting turnover (7.5 turnovers per NHPI) and lowering Faradaic efficiency; side reactions include pyridine oxidation and solvent HAT.
  • Stated: for polystyrene, slow diffusion and high solution viscosity limit HAT rate; downstream separation is needed for the heterogeneous oxygenate products; PS additives could affect reactivity; oligomer products (300–5,000 Da) are challenging to analyze by GC-FID, GC-MS, NMR, or LC-MS.
  • Evident from the text: the work is a proof-of-concept using model compounds and analytical polystyrene rather than real plastic waste, and monomer/dimer yields remain low (12% combined in the conclusion), with future work needed on mediator stability, immobilization, and scale-up.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.1002/cssc.202102317

Cites

65 of 65 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Image 1
CC-BY-NC-ND · From the PDF
Image 2
CC-BY-NC-ND · From the PDF
Figure 2 Cyclic voltammetry (CV) plots of 10 mM NHPI/PINO redox couple in the absence (black) and presence of 50 mM bibenzyl (red). The grey trace denotes bibenzyl direct oxidation in the absence of the NHPI mediator. At 1 mA, the NHPI-mediated bibenzyl oxidation requires a potential of 1.26 V less positive than that of direct bibenzyl oxidation. All CVs were recorded at 10 mV s -1 in 0.1 M LiBF4/acetonitrile electrolyte consisting of 0.1 M pyridine + HOAc.
Figure 2 Cyclic voltammetry (CV) plots of 10 mM NHPI/PINO redox couple in the absence (black) and presence of 50 mM bibenzyl (red). The grey trace denotes bibenzyl direct oxidation in the absence of the NHPI mediator. At 1 mA, the NHPI-mediated bibenzyl oxidation requires a potential of 1.26 V less positive than that of direct bibenzyl oxidation. All CVs were recorded at 10 mV s -1 in 0.1 M LiBF4/acetonitrile electrolyte consisting of 0.1 M pyridine + HOAc.CC-BY-NC-ND · From the PDF
Figure 3 Concentration profiles of bibenzyl, C-C bond cleavage products (benzaldehyde and benzoic acid), and C-H oxygenation products (1,2diphenylethanone and benzil) during NHPI-mediated bibenzyl oxidation.
Figure 3 Concentration profiles of bibenzyl, C-C bond cleavage products (benzaldehyde and benzoic acid), and C-H oxygenation products (1,2diphenylethanone and benzil) during NHPI-mediated bibenzyl oxidation.CC-BY-NC-ND · From the PDF
Scheme 1 . A bifurcated pathway of C-C bond cleavage and C-H oxygenation follows PINO induced HAT and O2 adduction.
Scheme 1 . A bifurcated pathway of C-C bond cleavage and C-H oxygenation follows PINO induced HAT and O2 adduction.CC-BY-NC-ND · From the PDF
Figure 4 Products distribution of NHPI-mediated oxidation.
Figure 4 Products distribution of NHPI-mediated oxidation.CC-BY-NC-ND · From the PDF
Figure 5 For the mediated oxidation of OS510, (a) the mass yields and (b) the distribution of products consisting of zero to five phenyl rings (Ph0-5) depend on the charge passed to each styrene unit in average (unit charge q ). Products were quantified by GC-FID. The product distribution was based on the results at q = 2.28.
Figure 5 For the mediated oxidation of OS510, (a) the mass yields and (b) the distribution of products consisting of zero to five phenyl rings (Ph0-5) depend on the charge passed to each styrene unit in average (unit charge q ). Products were quantified by GC-FID. The product distribution was based on the results at q = 2.28.CC-BY-NC-ND · From the PDF
Figure 6 (a) GPC results of NHPI-mediated PS oxidation with increasing unit charge. (b) Monomeric and dimeric products distribution after the bulk electrolysis of PS.
Figure 6 (a) GPC results of NHPI-mediated PS oxidation with increasing unit charge. (b) Monomeric and dimeric products distribution after the bulk electrolysis of PS.CC-BY-NC-ND · From the PDF
Image 9
CC-BY-NC-ND · From the PDF

Verification

Claims the paper makes

This check didn’t finish.

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

2 of 2

Citations

Cites

Show all 65 references

Research works printed but not linked: 1

  1. 10.1016/j.elecom.2004.04.014 · doi:10.1016/j.elecom.2004.04.014

Cited by

See all 73

Metadata

Authors
Yan, B., Shi, C., Beckham, G. T., Chen, E. Y. ‐., & Román‐Leshkov, Y.
Affiliations
  • Massachusetts Institute of Technology (US)
  • Colorado State University (US)
  • National Laboratory of the Rockies (US)
Corresponding author
Román‐Leshkov, Yuriy
Venue
ChemSusChem
Publisher
Wiley
Published
2022-02-23
Volume
15
Issue
6
Pages
e202102317-e202102317
ISSN
  • 1864-5631 (ISSN-L)
  • 1864-564X
OpenAlex
W4200243676
Cited by
73
References
66
Citations by year
2026: 18 · 2025: 13 · 2024: 23 · 2023: 14 · 2022: 3
FWCI
3.55
Type
journal article
Language
en
Open access
Locations
  • ChemSusChem (publishedVersion)
  • ChemRxiv (submittedVersion, cc-by-nc-nd)
  • PubMed (publishedVersion)
  • OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information) (submittedVersion)
  • Royal College of Surgeons in Ireland (submittedVersion, cc-by-nc-nd)
Funders
U.S. Department of Energy (DE-AC36-08GO28308)
Topics
  • Physical Sciences › Chemistry › Organic Chemistry › Radical Photochemical Reactions
  • Physical Sciences › Chemistry › Organic Chemistry › Oxidative Organic Chemistry Reactions
  • Physical Sciences › Environmental Science › Water Science and Technology › Advanced oxidation water treatment
Keywords
C–C bond cleavage, hydrogen atom transfer, redox mediators, N-hydroxyphthalimide, phthalimide-N-oxyl radical, polyolefin waste, chemical upcycling, polystyrene, benzylic C–H oxidation, bond dissociation energy
MeSH terms
Carbon, Hydrogen, Oxidation-Reduction, Oxygen

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.