The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Submillimeter-Scale Topography of the Lunar Regolith
Open accessAbstract
We have applied computer stereophotogrammetry to Apollo Lunar Surface Closeup Camera (ALSCC) pictures of the lunar surface to construct the first-ever digital topographic relief maps of undisturbed lunar soil over spatial scales from 85 μm to 8.5 cm. Using elevation histograms, fractal analysis, and Hapke's photometric roughness model we show that Apollo 14 (Fra Mauro) Imbrium ejecta is rougher than average Apollo 11 (Mare Tranquilitatis) and Apollo 12 (Oceanus Procellarum) mare surfaces at submillimeter to decimeter size-scales. We confirm the early result of K. Lumme et al. (1985, Earth Moon Planets33, 19–29) that the cumulative distribution of elevations for lunar soil is typically well described by Gaussian statistics. However, cumulative distributions are insensitive to asymmetries in the shapes of elevation histograms: Of 11 discrete elevation histograms we measured, about half exhibit significant deviations from Gaussian behavior. We also confirm Lumme et al.'s finding that the roughnesses of all lunar surfaces increase with decreasing size-scale. We further show that the scale dependence of roughness is well represented by fractal statistics. The rates of change of roughness with size scale, represented by fractal dimension D, are remarkably similar among terrians. After correcting for the contribution of large-scale roughness, our average value of D=2.31±0.06 falls within the range 2.0≤D≤2.4 reported from lunar radar studies. The amplitude of roughness, which we characterize with the rms slope angle at 1-mm scale, varies significantly among terrains. For lunar mare, the average rms slope angle is 16°±4°3 and that for Fra Mauro regolith is 25°±1°. By comparison to radar data, we suggest that the roughness of Fra Mauro (Imbrium ejecta) regolith is similar to that of lunar highland terrains. We find that the Gaussian slope distribution assumed in B. W. Hapke's model (1984, Icarus59, 41–59) adequately describes typical lunar regolith surfaces. A revised form of Hapke's equation that models realistic particle phase functions and the coherent backscatter opposition effect was fitted to disk-resolved lunar photometric observations and yields estimates of θ=27±1° for highland and θ=24±1° for mare regolith. These values of θ as well as the implied relative highland:mare photometric roughness ratio are best matched in our elevation data by the cummulative contributions of surface topography covering all scales greater than 0.1 mm. Less than 5% of the photometrically detected roughness of lunar regolith is contributed by surface relief at scales larger than 8 cm. This conclusion implies that values of θ derived from whole-disk and disk-resolved photometry, respectively, may be taken to represent the same physical quantity. In addition, particulate samples used in goniophotometric measurements should not be assumed to be photometrically smooth (i.e., θ=0°), as is often done in laboratory applications of Hapke's photometric model. The predicted photometric roughness at size scales of 0.1 mm and less significantly exceed photometric estimates and suggests that there exists a measurable size scale below which topographic relief either is not photometrically detectable or is not represented in the Hapke model as macroscopic roughness.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Statistics of atomic frequency standards
Allan, D. W. (1966) · Proceedings of the IEEE · doi:10.1109/proc.1966.4634 · Cited by 2,692
Cited by
Theory of Reflectance and Emittance Spectroscopy
Hapke, B. (1993) · Cambridge University Press eBooks · doi:10.1017/cbo9780511524998 · Cited by 1,849
Theory of Reflectance and Emittance Spectroscopy
Hapke, B. (2012) · Cambridge University Press eBooks · doi:10.1017/cbo9781139025683 · Cited by 752
The roughness of natural terrain: A planetary and remote sensing perspective
Shepard, M. K., Campbell, B. A., Bulmer, M. H., Farr, T. G., Gaddis, L. R., & Plaut, J. J. (2001) · Journal of Geophysical Research: Planets · doi:10.1029/2000je001429 · Cited by 409
Self-citationEdwards, C. S., Nowicki, K. J., Christensen, P. R., Hill, J., Gorelick, N., & Murray, K. (2011) · Journal of Geophysical Research · doi:10.1029/2010je003755 · Cited by 302
Resolved Hapke parameter maps of the Moon
Sato, H., Robinson, M. S., Hapke, B., Denevi, B. W., & Boyd, A. K. (2014) · Journal of Geophysical Research: Planets · doi:10.1002/2013je004580 · Cited by 165
Metadata
- Authors
- Helfenstein, P., & Shepard, M. K.
- Venue
- Icarus
- Publisher
- Elsevier BV
- Published
- 1999-09
- Volume
- 141
- Issue
- 1
- Pages
- 107-131
- ISSN
- 0019-1035 (ISSN-L)
- OpenAlex
- W2034388547
- Cited by
- 161
- References
- 1
- FWCI
- 2.48
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Submillimeter-Scale Topography of the Lunar Regolith. https://app.cochat.ai/papers/10.1006/icar.1999.6160
- The paper
- Helfenstein, P., & Shepard, M. K. (1999). Submillimeter-Scale Topography of the Lunar Regolith. Icarus. https://doi.org/10.1006/icar.1999.6160
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.